Proposal to amend para. 2.9. to define “ISOFIX position” as one that satisfies requirements of this Regulation to allow installation of ISOFIX child restraint systems as defined in UN R44 and UN R129, amend para. 2.24. to define “i-Size seating position” as one that satisfies requirements of this Regulation to allow installation of i-Size child restraint systems as defined in UN Regulation No. 129, amend para. 5.2.2.7. to exclude low ISOFIX anchorages installed in vehicles of category M₂ or M₃ from certain requirements, amend para. 5.2.4.1. to exclude vehicles of category M₂ and M₃ from marking requirements, and amend para. 6.2.5.1. to establish differentiated seat inertia forces for vehicles of categories M₂, N₂, M₃, and N₃. The justification clarifies that the definitions are based on tests fulfilled in this Regulation regarding strength rather than CRS category, addresses that the prior ISOFIX position definition incorrectly allowed i-Size CRS installation in non-i-Size positions, and harmonizes inertia loads for M₂ and M₃ vehicles with UN R14.

The agenda includes installation of belted child restraint systems, including seat belt minimum length feedback and definition of minimum effective belt length, installation of ISOFIX child restraint systems, amendments to UN R107, ISO pictogram wording revision and dimensions, clarification of the table for M₁ vehicles, introduction of seat belt length requirements for belted child restraint systems on M₂ and M₃ vehicles, amendments to UN R145, ISOFIX force reduction, and proposals to improve ISOFIX definitions across UN Regulations.

ISOFIX position means a position satisfying regulation requirements to allow installation of ISOFIX child restraint systems as defined in UN R44 and UN R129. i-Size seating position means a seating position satisfying regulation requirements to allow installation of i-Size child restraint systems as defined in UN R129.

Proposal to modify definitions 2.9 “ISOFIX position” and 2.24 “i-Size seating position”. The revised definition of ISOFIX position specifies which types of ISOFIX child restraint systems as defined in UN R44 and UN R129 may be installed. The definition of i-Size seating position clarifies that such positions are designed to accommodate i-Size child restraint systems as defined in UN R129. The modification bases these definitions on strength test requirements rather than child restraint system category.

UN R145 and UN R173 establish optional ISOFIX installation for vehicles of category M₂ and M₃. ISOFIX seating positions require compatibility with specific Child Restraint Fixture volumes and lower isofix forward strength of 8kN. I-Size seating positions require minimum 440mm distance between adjacent positions, compatibility with ISO/F2X and ISO/R2, and additional support leg strength testing. The document proposes allowing labels on bus windows and removing marking requirements for M₂ and M₃ from UN R145.

Proposal to enable application to vehicles of category X (vehicles of category Y are excluded from the scope). For vehicles of category X, the R point of the most forward passenger seat shall be taken instead of the R-point of the driver’s seat. The proposal amends the provision on “anti-rotation device” to read, “An anti-rotation device for an ISOFIX semi-universal child restraint system consists of either a top tether, the vehicle dashboard, a support leg or any other means intended to limit the rotation of the restraint during a frontal impact”.