The Working Party on Noise and Tyres held its eighty-fourth session from 2-4 September 2026 in Geneva. GRBP adopted a draft new Supplement to the 02 series and a draft new Supplement to the 04 series of amendments to UN R117, and agreed to submit these to WP.29 and AC.1 for consideration and vote at their March 2027 sessions. GRBP adopted the content of a proposal for a new supplement to UN R64 and agreed to postpone submission to WP.29 until further notice. GRBP adopted revised Terms of Reference for the IWG on Real Driving-Additional Sound Emission Provisions with extended mandate until February 2028.

Proposal to clarify that an extended mobility tyre shall not be retreaded without being marked with the EMT symbol to avoid the mix up on the same axle with a tyre of radial structure not featuring extended mobility capabilities

Session report of WP.29 (World Forum for Harmonization of Vehicle Regulations), its Administrative Committee of the 1958 Agreement (AC.1), Executive Committee of the 1998 Agreement (AC.3), and Administrative Committee of the 1997 Agreement (AC.4) held 23-26 June 2026 in Geneva. AC.1 voted on 92 amendments to existing UN Regulations, one corrigendum to UN Regulation No. 79, and three new UN Regulations (Nos. 184-186) on liquid hydrogen vehicle safety, automated driving systems, and tyre abrasion performance. AC.3 established UN GTR on automated driving systems and adopted corrigendum to UN GTR No. 9 and Amendment 2 to UN GTR No. 13. WP.29 extended mandates of several informal working groups and noted accession of Mongolia and Armenia to the 1958 and 1997 Agreements respectively.

Proposal to revise the definition of principal grooves in paragraph 2.14.1.; delete paragraph 2.48. and renumber subsequent paragraphs; amend paragraph 2.51. regarding material supplier definition; revise paragraph 3.2.6. on M+S inscription requirements; modify paragraph 4.1.5.3.2. to include a table of tyres classified for severe snow conditions; delete paragraphs 4.1.5.3.2.1., 4.1.5.3.2.2., and 4.1.5.3.2.3.; revise paragraphs 6.5.3., 6.5.8., 6.6., 6.7.4., and 7.1.5. regarding material supplier requirements and diameter calculations.