Proposal for new safety provisions with regard to LPG systems having hydraulic interconnections with the petrol or diesel fueling system through which inter-flows of fuels may occur.

Proposal to allow for the use of natural gas refrigeration systems to vehicles propelled by natural gas (CNG or LNG). This proposal addresses a new, environmentally friendly natural gas fuelled refrigeration system for trucks with refrigerated loads that already are propelled by natural gas. Currently paragraph 18.1.7.1 allows heating systems to be fitted on vehicles to heat the passenger compartment and/or the load area of a vehicle, however, the same provision omits cooling systems that are used on trucks for the carriage of loads requiring refrigeration.

Proposal to add a telltale and symbols for “Accident Emergency Call System (AECS)”.

Proposal to expand the scope of the regulation by deleting paragraph 1.2.2. which allows for the exclusion of “vehicles designed and constructed for special purposes where it is not possible, for practical reasons, to fit lateral protection devices” from the text. The proposal allows Type Approval Authorities to nonetheless exempt “vehicles where any LPD (e.g. fixed, removable, foldable, adjustable, etc.) is incompatible with their on-road use” through the addition of new paragraphs.

Proposal from the AECS informal group for a regulation to enable the approval of Accident Emergency Call Devices (AECD) intended for M1 and N1 vehicles, the approval of M1 and N1 vehicles with regard to the installation of an AECD, and/or the approval of M1and N1 vehicles with regard to their Accident Emergency Call System (AECS) or with regard to the installation of an AECD which has not been separately approved under the regulation.

Proposal to augment the provisions to address the needs of persons with reduced mobility by improving accommodations for wheelchair users and for persons who are visually and/or hearing impaired.

Corrections to the proposal to augment the provisions to address the needs of persons with reduced mobility by improving accommodations for wheelchair users and for persons who are visually and/or hearing impaired. The corrections include an additional paragraph with requirements for loudspeaker systems.

Proposal to align the requirements for plastic panes other than windscreens with the requirements of plastic pane windscreens. This includes amendments concerning rigid plastic panes, flexible plastic panes and rigid plastic multiple-glazed units. The proposed modifications to this type of glazing are in line with the requirements of Supplement 4 to the 01 series of amendment of UN Regulation No. 43.

Proposal to harmonize UN R110 with standard ISO 11439:2013 on high pressure cylinders for the on-board storage of natural gas as a fuel for automotive vehicles.

Proposal to reduce the administrative burden in obtaining approvals for electrical cables according to UN Regulation No. 118. The experts from Finland, France and Germany agreed that the change from ISO 6722:2006 to ISO 6722-2011 does not impact the degree of safety and, therefore, the test reports or approvals established under the older version of the ISO standard shall remain valid.

Proposal to improve and clarify provisions concerning the approval of interior materials, cables and insulation materials. The proposaladds new requirements for cable sleeves and conduits, modifies vertical testing requirements under Annex 8 to allow testing of small test samples and to clarify their fixation to the specimen holder., and adds a new Annex 10 on provisions for testing of electrical cables.

Proposal to allow for the approval of speedometers and odometers that enable drivers to display figures either in km/h or mph (but not both simultaneously). The proposal also clarifies the application of the provisions across the category L vehicle subcategories.

At its fifty-ninth session, GRSP approved a proposal for the 07 series of amendments to UN R16 to mandate safety belt reminders for all vehicle seats. This proposal aligns provisions in UN R121 with the changes to UN R16:
a) the term “seat belt” is replaced by “safety belt”,
b) the symbol for safety belt, defined in item 21 of Table 1 in the Regulation, may be displayed in different colours to convey different meanings. Therefore, the existing footnote ¹⁸ has been added to item 21, and
c) this symbol may be replaced by different symbols for seats other than those of the front row. Therefore, a new footnote ²² is added to item 21. This proposal does not change any of the technical requirements of UN R121.

Detailed review of the proposed changes to UN R110.

Proposal to

1. Update the standards to note that all references to standards are always to the latest version unless stated otherwise.
2. Update Annex II with: Series of PRD/TPRD’s are not allowed
3. Update A.24 with the pressure relief device shall comply with the requirements given in annex 4A for the specific type
4. Update Annex 4A para 4 and para 7 with reference to ISO15500-13.

Copies of the ISO standards. Extraction from zip file requires password. GRSG delegations may obtain the password from the secretariat.

Proposal concerning document GRSG/2015/22 to clarify the specification of the abrasion test machine.

Explanatory information from the AECS informal group regarding the provisions in document GRSG/2016/19.

Proposed amendments from the AECS informal group to document GRSG/2016/19.

Proposal to correct a cross-referencing error introduced in paragraph 7.7.9.1. of Annex 3 to Regulation 107 concerning textual markings (safety signs).

Proposal to delete the inclusion of the 75kg mass of a crew member from the definition of the mass of buses and coaches equipped with a crew member seat in order to align UN R107 with the definitions used in European Commission Regulation (EU) No. 1230/2012.

The 01 series of amendments inserted a new paragraph 5.1 and renumbered the subsequent paragraphs. This proposal corrects an oversight by updating a reference to paragraph 5.3 to 5.4 in the footnote under paragraph 2.5.

The text of the German proposal (document GRSG/2016/21) in the tables in annexes 14 and 16 only refers to small windows as “windows into which a circle of diameter D < 150 mm is capable of being scribed”. OICA proposes to add the criterion of a maximum area limited to 200 cm² in order to align with the definition in paragraph 2.39 (“pane having an area of less than 200 cm² and within which it is not possible to inscribe a circle having a diameter of 150 mm”).

Proposal to replace the current Figure 2a with a more accurate drawing reflecting the meaning of paragraph 2.4.2.2 of the regulation. The new drawing addresses the lateral limits of any opaque obscuration of the window area.

Under its technical regulation CU TR 018/2011 concerning the safety of wheeled vehicles, the Eurasian Customs Union will require AECS to automatically transmit accident data in the event of a vehicle rollover from 1 January 2017. The proposed UN Regulation on AECS ( document GRSG/2016/19) does not address rollover accidents. Therefore, Russia proposes an amendment to allow for such rollover requirements at the national level.

Proposal to align UN R121 with ISO 2575 per ISO Resolution 664 allowing for use of the diesel engine glow plug symbol with non-diesel technologies that (also) assist engine starting at low temperatures. he current text of the Regulation focuses on diesel engine glow plugs that assist in starting the engine at low temperatures.

Proposal to introduce requirements for Automatic Emergency Call Component (AECC) approvals that can be integrated into Automatic Emergency Call Device (AECS) approvals and/or Automatic Emergency Call Device installation approvals (Installation of AECD) under the new AECS Regulation.

IRU believes that the revised proposal by Germany (ECE/TRANS/WP.29/GRSG/2016/20 and its Corr.1) to insert new amendments might create an additional burden on road transport operators without increasing road safety. IRU cannot support the German proposal and thinks that it would be more appropriate to address the issue with a cost benefit analysis, where the safety benefit can be justified.

Proposal to clarify the definitions of LPG container accessories to facilitate coordination between the separate, independent approvals required for the LPG container and for its accessories. The proposal does not introduce any changes in technical requirements or changes in the test methodology. The proposed changes are intended to prevent the possibility of improper selection of accessories for the tank, which could arise due to lack of clear provisions of type-approval certificates issued for accessories fitted to the container.

Proposal to add a new condition to paragraph 18.1.7.2. such that the number of filling cycles will be verified at the time of type approval in order to prevent exceeding the maximum number of filling cycles.

Proposal to amend the provisions of UN R67 (R67) in order to enable the approval of non-seamless double and single wall gas tubes provided they can withstand the applicable tests according to Annex 15.

Proposal, as modified pursuant to discussions during the October 2016 GRSG session, to amend the provisions of UN R67 (R67) in order to enable the approval of non-seamless double and single wall gas tubes provided they can withstand the applicable tests according to Annex 15.

Proposal to correct the definition of “manual valve”, including deletion of the phrase “rigidly fixed to the cylinder or tank”.

The proposal by Belgium GRSG/2016/05 aimed at removing the amended additional safety prescriptions for trolleybuses from annex 12 of UN Regulation No. 107 for the Construction of M2 and M3 vehicles (R107), and inserting them into UN Regulation No. 100 on Electric Powertrain Vehicles (R100), see proposal GRSP/2016/07. This document explains how the scope and technical provisions for trolleybuses of R100 and R107 are complementary, but not yet fully compatible.

Proposal to introduce requirements for “obstacle detection systems to support fields of vision” (e.g., wide-view mirrors, sensors, camera systems). The aim is to decrease backover fatalities and injuries due to driver failure to adequately scan for obstacles when driving in reverse gear.

Presentation on the German effort to develop blind-spot detection performance assessment procedures pursuant to interest in making such systems mandatory on long vehicles.

Research in support of the AECS sled test pulse corridor as presented in GRSG/2016/19 (draft AECS regulation). The research demonstrates that the proposed peak G crash pulse specification is a reasonable representation of real-world crash dynamics.

Proposal to replace the term “minimum average magnification factor” with “magnification factors” in paragraph 16.1.3.1. There is no “minimum average magnification factor” in this regulation, just a “minimum magnification factor” and an “average magnification factor” and this already mentioned in the text following the revised sentence.

Presentation on Japanese legislation concerning the “Facilitation of Mobility of the Elderly, Disabled, and Other Vulnerable People through Public Transit System”.

Proposal for an informal group to develop a draft regulatory proposal for a new UN Regulation on close proximity vision and obstacle detection systems in order to establish uniform technical requirements for such close proximity vision and obstacle detection systems to prevent accidents by enabling the driver to notice any pedestrians around or behind the vehicle.

Proposal prepared by the GRSG Secretariat pursuant to discussions of document GRSG/2016/24. The proposal aims to improve and clarify provisions concerning the approval of interior materials, cables and insulation materials. The proposal adds new requirements for cable sleeves and conduits, modifies vertical testing requirements under Annex 8 to allow testing of small test samples and to clarify their fixation to the specimen holder., and adds a new Annex 10 on provisions for testing of electrical cables.

Presentation on CTIF cooperation with Euro NCAP, ISO, and others to encourage consideration of fire and rescue worker needs in responding to accidents (e.g., clear marking of vehicle propulsion system, post-crash occupant accessibility and extraction, protection against hazards).

Proposal to extend the duration of the PSG informal group until June 2018 to allow for the completion of its work.

PSG informal group proposal to correct the scope of the GTR in accordance with Part A of the GTR, its UN R43 counterpart, and corresponding regional/national interpretations and to align the impact test procedure description with that of UN R43 and ISO 3537.

Proposal to augment the provisions to address the needs of persons with reduced mobility by improving accommodations for wheelchair users and for persons who are visually and/or hearing impaired, superseding documents GRSG/2016/20 and its Corrigendum 1.

At its fifty-ninth session, GRSP approved a proposal for the 07 series of amendments to UN R16 ( (GRSP/2016/2 and GRSP/59, page 24) to mandate safety belt reminders for all vehicle seats. This proposal aligns provisions in UN R121 with the changes to UN R16:
a) the term “seat belt” is replaced by “safety belt”,
b) the symbol for safety belt, defined in item 21 of Table 1 in the Regulation, may be displayed in different colours to convey different meanings. Therefore, the existing footnote ¹⁸ has been added to item 21, and
c) this symbol may be replaced by different symbols for seats other than those of the front row. Therefore, a new footnote ²² is added to item 21.

Paragraph 5.1.5. is modified and paragraph 5.1.7. introduced to take into consideration the strict content of GRSP/59, page 24, paragraphs 8.4.3.2.1. and 8.4.4. on safety-belt reminder for occupants of rear seat row(s). This proposal does not change any of the technical requirements of UN R121.

Proposal prepared by the Chair of the Informal Working Group (IWG) on Accident Emergency Call Systems (AECS) for a draft UN Regulation on new provisions for AECS. It is mainly based GRSG/2016/19, distributed during the 111th session of the Working Party on General Safety Provisions (GRSG) and includes the modifications proposed by the IWG on AECS in informal document GRSG-111-07, as agreed by GRSG at its 111th session.

Overview of AECS, the draft regulation, and possible next steps.