Proposal to establish an informal working group to consolidate existing amendments to UN Regulation No. 110 in light of technical progress of other gaseous fuel regulations and standards and, where necessary, amend the Regulation to promote improved clarity and harmonization.

ISO standards provided for the sole use of participants in the Working Party on General Safety. This file is password protected. Please contract the GRSG secretariat (Mr. Romain Hubert, telephone: +41 (0) 22 917 2402 or by e-mail) for further information.

Proposal from the WP.29 secretariat to further consider the use of acronyms and symbols across UN Regulations. Listings of acronyms are available at www.unece.org/trans/main/wp29/wp29wgs/wp29gen/acronyms_definitions.html

Proposal to add a telltale and symbols for “Accident Emergency Call System (AECS)”.

Proposal by the International Road Transport Union (IRU) to amend the proposal by Germany that increases the stringency of the UN R58 rear underrun performance requirements. This proposal would delete the labeling provision (para. 16.7) in the German proposal (document GRSG/2015/17).

Proposal to require an exterior protection on cylindrical gas tanks. Under the current regulation, such exterior protection may be fitted at the discretion of the manufacturer. The intention is to increase protection against corrosion of cylinders in response to a corroded cylinder explosion in Germany.

Proposal to clarify the scope and the application of the regulation. The proposal clarifies that the regulations applies to “the burning behaviour of electric cables and cable sleeves or cable conduits used in the vehicle” and it updates the reference to paragraph 5.22. of ISO 6722-1:2011.

Proposal for improvements to marking provisions and changes to high-strength steel specifications pursuant to the deliberations of the Japanese ’Study Group for CNG Cylinders/LNG Tanks’, a stakeholder expert group.

Proposal to correct an oversight by aligning the “alternative procedures” provisions of the regulation with the previously adopted amendment of the regulation that raised the rear-impact speed to between 48 and 52 km/h (03 series of amendments).

Proposal to clarify and refine the draft amendments proposed in document GRSG/2015/17 “Proposal for the 03 series of amendments to UN Regulation No. 58”.

Proposal to introduce a definition for “twinned wheels”.

Proposal to exclude M and N1 vehicles from the close-proximity field of vision requirements pursuant to the establishment of the international whole vehicle type approval system.

Proposal to clarify the specification of the abrasion test machine.

Proposal to clarify the requirements concerning the height of steps in vehicles which comply with Annex 8.

Password-protected copy of ISO standard 16505: Road Vehicles — Ergonomic and performance aspects of Camera Monitor Systems — Requirements and test procedures. Participants in GRSG work may contact the GRSG secretariat for access.

Amendments from the CMS II informal group to the draft provisions that would allow the optional replacement of mirrors of Classes I to IV by camera-monitor systems.

Proposal to add information reporting requirements for type approval of camera-monitor systems of classes I to IV to the proposal for a Supplement to the 04 series of amendments to UN R46 (document GRSG/2015/2).

This proposal aims to clarify that surveillance mirrors can be mounted below 2 meters from the ground when integrated in a housing including one or several mirrors of classes II or III.

Proposal to redefine the measurement criteria for determining appropriate seat spacing in order to address observed cases where adequate spacing is not achieved even though the current criteria are fulfilled. The type approval authorities of the member states of the European Union (TAAM) discussed the proper interpretation of the text of the Regulation in the case of seats with a central recess (sunken area) and decided that the text of the Regulation needed to be modified in order to provide an adequate method to measure the H dimension.

Incident reports confirm that occupants of exposed seats have been thrown forward during heavy braking or vehicle impact conditions, often sustaining head injuries from contact with the vehicle floor or other hard structure. Seats particularly affected are those located immediately to the rear of an open wheelchair or buggy space. This proposal aims to reduce this risk by extending existing requirements for exposed seats adjacent to step wells to apply to other exposed seats where there is a risk of the occupant being thrown forward.

Proposal to amend document GRSG/2015/17 which would introduce higher stringency levels for rear underrun protection devices.

Proposal to correct certain omissions in the text and to simplify the transitional provisions proposed in document GRSG/2015/17 which would increase the stringency of the rear underrun protection device requirements.

Proposal from the GRSG secretariat to correct the definition of “Odometer” in documents GRSG/2015/15 and GRSG/2015/16.

Document GRSG/2015/9 would amend the provisions of UN R10 on electromagnetic compatibility to include camera-monitor devices newly defined under UN R46. This proposal aims to clarify that the amendment applies only to regulated devices for indirect vision (UN R46) so as not to be confused with other devices for indirect vision already included within the scope of UN R10.

UN Regulations Nos. 58 and 73 contain exemptions which can be applied by an approval authority and we are concerned that a vehicle which is correctly approved using such an exemption cannot then be required to have an RUPD or sideguards. The UK seeks the views of GRSG on how the wording of the exemptions may be improved to ensure that as many vehicles as possible are fitted with RUPD and sideguards.

Proposal to enable the use of autonomous CNG heaters for the heating of engines before the vehicle is in service.

Document GRSG/2015/8 proposes to amend the provisions on forward field of vision of drivers in UN R125 to promote and to support the installation of camera-monitor devices on vehicles of category M1. This proposal would clarify that the amendment only applies to regulated devices for indirect vision.

An accident occurred where an N1 security vehicle fatally injured a child who was crossing the entrance to a supermarket car park. The vehicle had been modified from the original specification of the manufacturer by the removal of the side windows and the fitting of plastic glazing on both sides of the driver’s cab area, and a frame of strengthening material fitted to the replacement glazing. This reduced the side vision for the driver of the vehicle. Since UN R125 applies to M1 vehicles, the UK seeks guidance from GRSG on the application of UN R125 provisions to N1 vehicles.

OICA comments expressing opposition to the proposed measures to combat odometer fraud in the used vehicle market.

India comments raising concerns over the feasibility of the proposal to combat odometer fraud in used car sales.

Proposal for corrections to the text.

Proposal to align the draft 03 series (document WP.29/2014/65) with other UN Regulations and Indian standards by specifying the upper weight threshold of the total permissible mass of M1 and N1 vehicles of 2.5 tonnes (rather than the current 2.8 tonnes).

Proposal to update requirements for numeric/digital displays.

Notice from the European Commission of Directive (EU) 2015/719 concerning permissible vehicle masses and dimensions that will result in mandatory revisions to the EU type approval legislation during 2016.

Notice on the publication of an EC-sponsored study on the benefits and feasibility of a range of new technologies and unregulated measures in the field of motor vehicles and on future plans of the Commission in this regard.

OICA concerns regarding the proposal to introduce fire suppression systems for buses and coaches upon detection of fire in the engine and/or heater compartment (document GRSG/2014/6/Rev.1).

Consolidated revised version of UN R46 introducing provisions prepared by the Informal Group on Camera-Monitor Systems (IGCMS-II) to introduce the optional replacement of mirrors of Classes I to IV by camera-monitor systems.

Text of the proposal for fire suppression systems prepared by the Secretariat and incorporating documents GRSG/2015/6/Rev.1 and GRSG-108-45 as agreed by the GRSG during its 108th session.

Revised proposals approved by the GRSG to delete provisions regarding the optical display of the status of the vehicle alarm system outside the passenger compartment in order to avoid driver distraction by and/or confusion of such exterior lighting with primary lighting and signaling equipment required under UN R48. These proposals supersede documents WP.29/2015/36 and WP.29/2015/37 that were submitted for the March 2015 WP.29 session but deferred to the June session.

Proposal developed by the IWVTA informal group to highlight concerns over the ambiguity of Regulation No. 116, especially with regard to whether the installation of vehicle immobilizer systems is mandatory. IWVTA is requesting WP.29 for clarification and resolution of the ambiguous provisions and interpretations.

Proposal to allow for small variations in the presentation of motorcycle telltales and control symbols that do not deviate to such an extent as to cause confusion.

Revised proposal to introduce more stringent requirements for rear underrun protection devices, taking into account the comments received during the 108th GRSG session.

Revised proposal to introduce more stringent requirements for rear underrun protection devices, taking into account the comments received during the 108th GRSG session.

Consolidated revised version of UN R46 as approved by the GRSG during its 108th session to introduce the optional replacement of mirrors of Classes I to IV by camera-monitor systems.

Proposal as approved by the GRSG during its 108th session to introduce more stringent requirements for rear underrun protection devices..