Corrections proposed to document GRSP/2014/26 which introduced amendments to the draft regulation as presented in document GRSG/2014/11.

Update on the work concerning head restraint height measurement, dynamic test for rear impacts, BioRID II dummy certification and R&R, GTR “whiplash” injury criteria, and introduction of the BioRID test tool into the Mutual Resolution 1 compendium.

Text prepared by the UN R44 Technical Services Group to clarify the regulation, including test failure parameters, CRS displacement or locking systems, seat installation color coding systems, and use of load limiting devices. The test procedure would be modified, including an increase in the applied load to exceed the maximum allowed resistance to permit sliding of the strap through the quick adjuster and through rigid parts, increased tolerances related thereto, deletion of the option for shorter shift (deemed unnecessary since it is a test on the strap, not on the complete component), and modification of drawings to improve consistency with the text.

Proposal to expand the application area of the energy absorption criteria for seating in order to facilitate the optimization of seat-belt load limiters by allowing limited occupant contact with these seat areas.

Revised amendment to introduce all the modifications needed in UN Regulation No. 129 (Enhanced Child Restraint System (ECRS)) that were suggested by the experts of the informal working group on Child Restraint Systems (IWG CRS) to extend the scope of this Regulation to Non-Integral child restraint systems (“Universal Booster” or “Specific to vehicle Booster”) (Phase 2 of the UN Regulation).

Revised amendment, including track changes, to introduce all the modifications needed in UN Regulation No. 129 (Enhanced Child Restraint System (ECRS)) that were suggested by the experts of the informal working group on Child Restraint Systems (IWG CRS) to extend the scope of this Regulation to Non-Integral child restraint systems (“Universal Booster” or “Specific to vehicle Booster”) (Phase 2 of the UN Regulation).

Revised CLEPA proposal to clarify dynamic testing, rear seat system, advanced restraint system approval, and transitional provisions. This proposal supersedes document GRSP/2014/27.

In June 2014, WP.29 returned a proposal (document WP.29/2014/34) to introduce provisions for ISOFIX positions in convertibles and vehicles with one seating position per row due to concerns over clarity. Given the complexity of this topic, OICA has decided to address specific elements separately. This proposal addresses the use of top tethers in child restraint systems and proposes to retain the “i-size” term and definition endorsed by GRSP.

The scope of the new Global Technical Regulation on Pole Side Impact includes vehicles of category N1 (limited to GVM < 3.5 t) and vehicles of category M1 (without mass limit). However, the vehicle fleet includes a small number of M1 vehicles with a GVW > 3.5t which are based on vehicles of category N2, N3, M2 or M3. Therefore, OICA proposes to limit the scope of the GTR to both M1 and N1 vehicles under 3.5 t maximum vehicle mass in order to alleviate burdens on manufacturers producing M1 variants based on N2, N3, M2, or M3 vehicles.

Further refinements to the proposed new regulation on frontal impact protection in relation to occupant restraint systems (document GRSP/2014/10 amended by doument GRSP/2014/23) prepared by the Informal Group on Frontal Impact. These amendments concern provisions on the position of the front passenger.

Proposal to introduce provisions concerning universal child booster seating positions.

Further refinements to UN R94 frontal impact regulation in light of the new regulation on frontal impacts and occupant restraint systems currently pending approval.

Proposal to introduce provisions concerning universal child booster seating positions with the amendments shown within the text of the regulation, incorporating the amendments proposed in document GRSP/2014/14.

Editorial improvements to the text and introduction of provisions allowing for the separation of connectors (including the vehicle inlet) without the use of tools under prescribed conditions.

Editorial improvements to the text and introduction of provisions allowing for the separation of connectors (including the vehicle inlet) without the use of tools under prescribed conditions.

Proposal to clarify the text related to the recently expanded height requirements for the effective upper belt anchorage (Supplement 4 to the 07 series of amendments to Regulation No. 14).

Request for clarifications on the application of relaxation areas under UN Regulation No. 127.

Request for clarification of test procedures for active pedestrian protection devices (such as active hood, pedestrian airbag).

Japan is developing national legislation to prescribe requirements for the body, hydrogen storage containers and their specific components, batteries etc. of hydrogen fuel-cell powered motorcycles.

Proposal from Japan to outline a 01 series of amendments to the draft new UN Regulation with regard to the Full Width Rigid Barrier test. This proposal would enable Contracting Parties to apply this Regulation with a Thorax Compression Criterion (ThCC) of 34 mm for the Hybrid III 5th female dummy on the passenger seat in the event that both the 00 series draft new regulation and the 01 series amendments are adopted concurrently.

Fact sheet on UN R129 including comparison with UN R44.

Proposal to include “MFP” in the labeling requirement for hydrogen containers. MFP refers to the maximum allowable container pressure under normal use.

Proposal to amend the toxicity and flammability declarations via references to EN71 (European safety standards).

Question and answer brochure on the i-size child restraint systems regulation.

Report on the phase 2 development (regarding universal booster seats and cushions) of UN Regulation No. 129.

Presentation on occupant protection tests of selected L7 category vehicles (e.g., very light, limited maximum speed road vehicles that do not require a driver’s license to operate).

Proposal to prohibit the use of Y-shaped belt on forward-facing child restraint system. This proposal aligns UN R129 with provisions already in UN R44.

Proposal to exclude “bucket seats” from the ISOFIX requirements as well as vehicles with only one seating position (by applying the regulation only to vehicles with more than one seating position). The proposal also exempts certain vehicle/seating configurations from ISOFIX requirements, addressing cases where the vehicle design and purpose mitigate against the use of such child restraints and ISOFIX systems.

The scope of the new Global Technical Regulation on Pole Side Impact includes vehicles of category N1 (limited to GVM < 3.5 t) and vehicles of category M1 (without mass limit). However, the vehicle fleet includes a small number of M1 vehicles with a GVW > 3.5t which are based on vehicles of category N2, N3, M2 or M3. Based on the OICA proposal (document GRSP-56-12) and ensuing discussions, Australia proposes to limit the scope of the GTR to both M1 vehicles under 3.5 t maximum vehicle mass and to certain N1 vehicles based on geometric measurements.

Thorax compression criterion (ThCC) under the draft new regulation on frontal impact protection and occupant restraint systems.

Proposal from the Bumper Test Area Task Force to revise the procedure for determining the bumper test area under the pedestrian safety regulation. This proposal corrects shortcomings in the current definitions which could lead to a narrower test area than intended (leading to less effective pedestrian protection). This proposal does not take into account potentially harmful hard structures such as bumper beams that may lie behind the outer contour or front fascia extending beyond the defined bumper corners as consensus within the task force could not be reached.

Proposal from the Bumper Test Area Task Force, submitted as an alternative to the proposal in document GRSP/2014/17 as amended by document GRSP-56-38, to revise the procedure for determining the bumper test area under the pedestrian safety regulation. This proposal corrects shortcomings in the current definitions which could lead to a narrower test area than intended (leading to less effective pedestrian protection). This proposal includes a “bumper beam” determination method.

Proposal from the Bumper Test Area Task Force, pursuant to discussions within GRSP, to revise the procedure for determining the bumper test area under the pedestrian safety regulation. This proposal corrects shortcomings in the current definitions which could lead to a narrower test area than intended (leading to less effective pedestrian protection). This proposal does not take into account potentially harmful hard structures such as bumper beams that may lie behind the outer contour or front fascia extending beyond the defined bumper corners as consensus within the task force could not be reached. Presented as a Supplement, the proposal includes a September 2017 transition date in case GRSP determines that the changes should be put into a new series of amendments rather than as a supplement.

Proposal from the Bumper Test Area Task Force, pursuant to discussions within GRSP, submitted as an alternative to the proposal in document GRSP/2014/31 as amended by document GRSP-56-40, to revise the procedure for determining the bumper test area under the pedestrian safety regulation. This proposal corrects shortcomings in the current definitions which could lead to a narrower test area than intended (leading to less effective pedestrian protection). This proposal includes a “bumper beam” determination method. The proposal also includes a September 2017 transition date in the event that the GRSP determines that the proposal should be treated as a new series of amendments rather than as a Supplement.

Argument in favor of extending provisions for seat-belt reminders to the rear seating positions, particularly to respond to low seat-belt use by rear occupants and the associated higher rates of death and injury in accidents.

Addition of new document references to the agenda.

Draft of the amendment to introduce the Flex PLI lower legform impactor and related test procedures into the GTR on pedestrian safety protection, including the new bumper test area specifications.

Proposal from the Bumper Test Area Task Force to revise the procedure for determining the bumper test area under the pedestrian safety regulation. This proposal corrects shortcomings in the current definitions which could lead to a narrower test area than intended (leading to less effective pedestrian protection). This proposal does not take into account potentially harmful hard structures such as bumper beams that may lie behind the outer contour or front fascia extending beyond the defined bumper corners as consensus within the task force could not be reached.

Germany submitted a proposal that would require at least one set of ISOFIX anchorages in single-row vehicles (which are currently exempted under UN R14). This proposal (superseding GRSP-55-31) would set a minimum R-point criteria for requiring the ISOFIX anchorages and thus exempt vehicles with R-points below this minimum height. The purpose is to exempt sport vehicles not intended to carry small children requiring child seats from the ISOFIX requirement.

Proposal to define the moment of intertia in the luggage-impact test as “0.3 ± 0.05 kgm2 (around all 3 principal axis of inertia of the luggage blocks)”. UN R17 presently lacks such a definition, resulting in variations in trajectory and behavior of the luggage cubes before and after impact.

Proposal to extend the prohibition against the installation of side-facing seats to all categories of commercial vehicles (N).