Revision 3 of the 1958 Agreement allows for a Unique Identifier (UI) under the DETA system as an alternative to the current approval mark. In the case of child restraint systems, the approval mark contains important information for users. Therefore, this proposal would prohibit replacement of the approval mark by the UI.

Proposal to enable approval testing under UN R137 as an alternative to UN R12 in order to avoid redundant testing requirements. The proposal adds references to the steering gear provisions of UN R137 (full width frontal impact) as a compliance alternative in parallel to the current references similarly allowing compliance via provisions in UN R94 (offset deformable barrier frontal impact). Please note that this proposal is based upon document GRSP-60-06/Rev.1. The reference to GRSP-60-07 is incorrect.

Proposal to transfer all ISOFIX requirements from UN R14 into a new UN Regulation. Within the context of the international whole vehicle type approval program, the removal of these CRS anchorage provisions would align UN R14 with its Australian Design Rule counterpart and enable Australia to apply the revised UN R14 narrowed down to adult seat-belt anchorages only.

For the International Whole Vehicle Type Approval, a UN Regulation is split in two regulations, UN Regulation No. 14-08 series of amendments including only adult safety belt anchorages and a new regulation UN Regulation No. [XX] will include all requirements for child restraint anchorages. Accordingly, this proposal would update the references to UN Regulation No. 14 in UN Regulation No. 16 in order to recognize child restraint system anchorages installed on the vehicle and approved under the new regulation.

Proposal to clarify the requirements for CRS utilizing the seat belt lap strap in order to ensure correct installation and testing and to avoid possibly dangerous misinterpretation to the test configuration.

Proposal to modify document GRSP/2014/15 presenting Amendment 2 to GTR No. 9. Amendment 2 would introduce the flexible pedestrian legform impactor (FlexPLI) as a single harmonized test tool. The National Highway Traffic Safety Administration (NHTSA) has expressed concern whether the injury assessment reference values (IARV) proposed in Amendment 2 will be able to meet the needs for injury mitigation in the United States of America. In order to allow the amendment to move forward, the United States proposes to accept the IARV while noting in the statement of technical rationale and justification its continuing research into the IARVs and the possibility of a future proposal to amend the values should this prove warranted.

Proposal to

1. align the regulation with legislation of the European Union, United States of America, and Japan,
2. clarify the test procedure, including ambient temperature provisions,
3. reduce unnecessary time and cost demands of the COP test procedures,
4. apply the minimum burst pressure BP_min as the pressure limit in the hydrostatic pressure rupture test for COP batch testing, and
5. delete the phrase “and in no case less than the value necessary to meet the stress ratio requirements” erroneously introduced into paragraph 9.3.2.1.

Proposal to amend UN R44 in line with the proposal to amend UN R14 in order to separate child restraint provisions (including ISOFIX anchorage provisions) into a new UN Regulation. The ISOFIX amendment to UN R14 has been introduced to facilitate the establishment of the International Whole Vehicle Type Approval (IWVTA) regulation by limiting the scope of UN R14 to adult safety belts.

Proposal to amend UN R129 in line with the proposal to amend UN R14 (document GRSP/2017/8) in order to separate child restraint provisions (including ISOFIX anchorage provisions) into a new UN Regulation. The ISOFIX amendment to UN R14 has been introduced to facilitate the establishment of the International Whole Vehicle Type Approval (IWVTA) regulation by limiting the scope of UN R14 to adult safety belts.

Proposal to clarify the testing of seats with and without head restraints. This proposal would allow alternatives at the request of the manufacturer by clarifying that under testing of a bench seat with three seating positions and two head restraints, a moment of 3 × 373Nm shall be applied to the back of seats and of 2 × 373Nm to the head restraints:
(a) If the manufacturer wants to comply with the test requirements of paragraph 6.2. (strength of the seat-back), by the test of head restraint performance of paragraph 6.4., they choose to apply 53 daNm to each seat back without head restraint and 89 daN to each head restraint. In this case only one test shall be performed.
(b) If the manufacturer chooses not to apply 53 daNm, during the test of paragraph 6.4., the seat back strength test of paragraph 6.2. has to be performed in addition to the test of paragraph 6.4.

Proposal to add the Q0 infant test dummy to the UN R44 procedures in response to problems encountered in acquiring the currently specified P0 dummy.

Proposal to consolidate provisions concerning ISOFIX anchorages systems, ISOFIX top tether anchorages and i-Size seating positions removed from Regulation No. 14 in a new regulation. This change removes obstacles to the inclusion of UN R14 into Annex 4 of the future UN Regulation No. 0 of the International Whole Vehicle Type Approval (IWVTA).

Proposal of amendments developed by the CRS informal working group to enable the type approval of integral and non-integral Enhanced Child Restraint Systems equipped with an impact shield.

Proposal of amendments developed by the CRS informal group to enable the type approval of integral and non-integral Enhanced Child Restraint Systems equipped with an impact shield.

1. The proposed amendment includes Enhanced Child Restraint Systems from the universal belted or specific to vehicle belted categories into the scope of UN Regulation No. 129. This represents Phase 3 of the UN Regulation.
2. The text includes all modifications proposed by GRSP up to and including its sixtieth session (13-16 December 2016) as well as those of the Informal Working Group on Child Restraint Systems up to and including its sixty-third session (Brussels, 25th January 2017).
3. This proposal refers to the original text of Regulation No. 129, including the following amendments:
   • Corrigendum 1,
   • Supplement 1,
   • Supplement 2,
   • Supplement 3,
   • Supplement 4,
   • the 01 series of amendments,
   • Supplement 1 to the 01 series of amendments,
   • the 02 series of amendments,
   • Supplement 1 to the 02 series of amendments (GRSP/2016/19 and 23 amended by GRSP-60-08-Rev.1),
   • Supplement 2 to the 01 series of amendments (GRSP/2016/22 amended by GRSP-60-09-Rev.2).

Proposal to clarify that only a three-point safety belt is permitted in the driver position.

Proposal to clarify that only three-point safety belts are permitted in the driver position.