Proposal to clarify the requirements concerning the height of steps in vehicles which comply with Annex 8.

Proposal to redefine the measurement criteria for determining appropriate seat spacing in order to address observed cases where adequate spacing is not achieved even though the current criteria are fulfilled. The type approval authorities of the member states of the European Union (TAAM) discussed the proper interpretation of the text of the Regulation in the case of seats with a central recess (sunken area) and decided that the text of the Regulation needed to be modified in order to provide an adequate method to measure the H dimension.

Proposal to clarify the specification of the abrasion test machine.

Proposal to clarify that fully integrated surveillance mirrors may be mounted below 2 metres in cases where they are integrated in a housing including one or more Class II or III mirrors.

Proposal to add a telltale and symbols for “Accident Emergency Call System (AECS)”.

Proposal to correct an oversight by aligning the “alternative procedures” provisions of the regulation with the previously adopted amendment of the regulation that raised the rear-impact speed to between 48 and 52 km/h (03 series of amendments).

Proposal to align the draft 03 series (document WP.29/2014/65) with other UN Regulations and Indian standards by limiting the upper weight threshold of the total permissible mass of M1 and N1 vehicles to 2.5 tonnes (rather than the current 2.8 tonnes).

Proposal to remove the provisions for welded constructions of compressed natural gas (CNG) cylinders or metal liners, including high-strength steel CNG cylinders.

Proposal to clarify the scope and the application of the regulation. The proposal clarifies that the regulation applies to “the burning behaviour of electric cables and cable sleeves or cable conduits used in the vehicle” and it updates the reference to paragraph 5.22. of ISO 6722-1:2011. Specifically, the proposal would apply testing to electric cables, cable sleeves, and cable conduits that exceed a length of 100 mm.

Proposal to clarify the scope and the application of the regulation. The proposal clarifies that the provisions concern any cable used in the entire vehicle, not only to those in the interior compartment, engine compartment and separate heater compartment. The proposal also clarifies that the regulation applies not only to electric cables, but also to cable sleeves or cable conduits and it updates the reference to paragraph 5.22. of ISO 6722-1:2011. Specifically, the proposal would apply testing to electric cables, cable sleeves, and cable conduits that exceed a length of 100 mm.

Proposal to introduce a definition for “twinned wheels”.

The aim of this corrigendum is to correct the text of the Regulation and to restrict the mandatory application of the requirements on dedicated areas for prams and pushchairs to Class I vehicles.

Proposal to mandate fire suppression systems on vehicles of Classes I and II as a new 07 series of amendments to UN R107. It is mainly based on ECE/TRANS/WP.29/GRSG/2014/6/Rev.1, amended as reproduced in GRSG-108-51, submitted to WP.29 and AC.1 for consideration at their November 2015 sessions, as draft Supplement 4 to the 06 series of amendments to Regulation No. 107 (ECE/TRANS/WP.29/2015/88).

Pursuant to the proposal to enable the use of autonomous compressed natural gas (CNG) heaters for the purpose of heating the engine coolant under UN R110, this proposal would require that the alarm system and fire suppression system (required through paragraph 7.5.1.5. as amended by Supplement 4 to 06 series of amendments) be activated as soon as the heater is in function and even if the engine is not operational.

Incident reports confirm that occupants of exposed seats have been thrown forward during heavy braking or vehicle impact conditions, often sustaining head injuries from contact with the vehicle floor or other hard structure. Seats particularly affected are those located immediately to the rear of an open wheelchair or buggy space. This proposal aims to reduce this risk by extending existing requirements for exposed seats adjacent to step wells to apply to other exposed seats where there is a risk of the occupant being thrown forward.

Proposal to amend UN R67 to allow for limited flows of petrol into the LPG tank of dual fuel vehicles.

Proposal to enable the use of autonomous CNG heaters for the heating of engines before the vehicle is in service.

Editorial corrections to document WP.29/2015/88 proposing to introduce fire suppression systems for buses and coaches upon detection of fire in the engine and/or heater compartment.

Editorial corrections to the proposal to clarify the scope and the application of the regulation with regard to cable provisions.

Discussion of the state of accident statistics and other data to support the development of coach and bus safety requirements.

FIA responses to question raised by OICA’s critique of the proposed odometer requirements and the ensuring discussion during the May 2015 GRSG session.

Proposal to correct that apparent omission of paragraph 7.5.1.5 in Annex 3 in the formal proposal to introduce mandatory fire suppression systems in certain buses and coaches (document GRSG/2015/32).