Pursuant to the concern raised by Spain to avoid a misinterpretation that shoulder strap positioners must be designed to be released before the harness buckle, This proposal clarifies that a shoulder strap positioner may be released before, after, or simultaneously with the harness buckle. The proposal also improves the text with regard to the release of modules from a base.

During its 61st session, GRSP approved Supplement 3 to the 01 series of amendments and Supplement 2 to the 02 series of amendments. This proposal reinserts text inadvertently omitted during the reproduction of the text as approved during the session.

The video used during the presentation can be downloaded separately.

Proposal to amend document GRSP/2017/40 in order to clarify the performance requirements for impacted doors (i.e., determination of whether a door remained closed during the test) and to reduce the proposed force level from 500 N to 400 N for the test to open the door.

Proposal to remove references to age limits in preference for limits based on stature in the definition of “infant carrier”, to update the transitional provisions in line with the new guidelines on regulatory procedures (ECE/TRANS/WP.29/1044/Rev.2), especially concerning extensions of approvals, and to replace a reference in para. 16.11 to “vehicle approval” with “Enhanced Child Restraint Systems”.

Proposal to update the Communication Form since from the 07 series of amendments rear safety belt reminders have been added.

Proposal to prohibit the granting of new approvals under UN R44 from [1 September 2020] and to amend the transitional provisions accordingly.

Latest developments from the GTR 7 informal group to implement the Phase 2 development of the GTR. Phase 2 addresses a new measurement procedure for the effective height of the head restraint and introduction of the Biofidelic Rear Impact Device (BioRID).

Proposal to introduce new and modified labeling and to clarify packaging information to distinguish between forward-facing-only, rear-facing-only, and convertible CRS in order to reduce the risk of users misusing these enhanced CRS.

Proposal to introduce provisions for the approval of the booster cushion category of Enhanced Child Restraint Systems.

Proposal to clarify provisions for booster seats under the 02 series of amendments to avoid possible confusion with the provisions for booster cushions in the proposal for the 04 series of amendments (see document GRSP/2018/29). The proposal also adds a missing reference to Appendix 5 of UN R16 that defines envelopes for non-integral Enhanced Child Restraint Systems.

The 01 series of amendments to UN R129 amended the door panel geometry to create a small opening close to the seat bight. This change protected the panel from interaction with the anchorage of the adult seat belt on the test bench (added subsequently in the 02 series). Although Integral ISOFIX Enhanced Child Restraint Systems (ECRS) do not use the belt, these CRS were also required to use this new door panel geometry. This proposal amends the 02 series of amendments to require Integral ISOFIX ECRS to use the original door panel geometry with no opening (except during extensions of approvals in which the new panel geometry was used). The proposal ensures that ISOFIX ECRS designs cannot use the opening to mitigate loads to the ECRS and dummy.

Proposal to clarify provisions for booster seats under the 02 series of amendments to avoid possible confusion with the provisions for booster cushions in the proposal for the 04 series of amendments (see document GRSP/2018/29). The proposal also adds a missing reference to Appendix 5 of UN R16 that defines envelopes for non-integral Enhanced Child Restraint Systems.

Proposal to introduce a definition for “insert” and provisions for their use.

Proposal transposing the provisions of the draft GTR 7-Amendment 1 (aka Phase 2) into UN R17. Phase 2 addresses a new measurement procedure for the effective height of the head restraint and introduction of the Biofidelic Rear Impact Device (BioRID).

English wording “Upper neck tension force” corresponds to the following Russian wording “Сжимающая сила верхней части шеи”. English wording “Upper neck flexion moment” corresponds to the following Russian wording “Изгибающий момент верхней части шеи”.

Explanatory notes related to formal documents GRSP/2018/ 19 through 22 (superseded by informal documents GRSP-64-02 to GRSP-64-05) submitted by Spain for the 63rd GRSP session.

Proposal to modify the approval markings:

• specify the dimensions of the approval number
• update i-Size universal ISOFIX, Specific Vehicle ISOFIX, i-Size Booster seat and Specific Vehicle Booster seat numbering (omitted in WP29-2018-045)
• rearrange the dimensions mark for arrangements of the approval mark where used in combination with the module mark
• change the 145 cm stature of the Specific Vehicle Booster seat to 150 cm stature as this is the correct upper limit.

Proposal to modify the approval markings for consistency between technical services and approval authorities and between the labels of products approved under the 02 and 03 series. Combinations of approval marks can be made as long as the categories are able to be combined (category-wise as given in paragraph 3.2.2 and as long as it is one approval number). By combining approval marks, space on the Enhanced Child Restraint can be saved and more space is available for clear installation and use instructions.

Explanation of informal documents GRSP-64-07 to -09 regarding the rearrangement of approval markings.

Proposal to align the French version with the adopted English version of the text (reference document WP.29/2018/45).