Proposal to clarify the test procedures and the different ECRS to be tested for the assessment of the system.

Internal annotations to the agenda

Proposes to transfer the provisions on minimum number of anchorage points and location of lower anchorages from Consolidated Resolution on the Construction of Vehicles (R.E.3)

Proposal that for the unfastened belts indicator to only detect unfastened belt in the rear without actually identifying the exact location of the seat and the addition of a new paragraph to clarify that an exemption in the transition provisions remains applicable and acceptable,.

IWG presentation promoting DETA and the use of it

Proposal to discuss Supplement 18 to 04 series of amendments to UN R44 in lieu of a specific child restraint system that would fall outside the scope of the regulation

Proposal for an approach to address the need for crash safety of car-like passenger quadricycles (L7) through UN Regulation No. 137. The proposal is to first to separate the passenger and goods L7 quadricycles and then harmonising the definition in Consolidated Resolution RE3.

IWG 22 Proposal to introduce some corrigendum to the approved document ECE/TRANS/WP.29/2019/25

IWG 22 report and background on the proposal for amendments in ECE/TRANS/WP.29/GRSP/2019/11

Status report of the IWG DPPS

Proposal for editorial corrections to ECE/TRANS/WP.29/GRSP/2019/27

The proposal from the drafting group, based on GRSP-65-13, is to align UN Regulations to the provisions of the revised General Safety Regulation of the European Union to modify the scope of the UN Regulation, to provide appropriate transitional provisions and to make minor adaptations and clarifications to the existing requirements.

Proposal to to delete paragraph 13.3.4. of ECE/TRANS/WP.29/GRSP/2019/27 as difficulty may arise to judge whether an approval according to the preceding series of amendments is still valid.

The proposal is to amend the ECE/TRANS/WP.29/GRSP/2019/27 and updates ECE/TRANS/WP.29/GRSP/2019/9.

Proposal based on document GRSP/2019/19 to define the introduction of limit values for chest vertical acceleration of Q-dummies during dynamic testing of Enhanced Child Restraint Systems (ECRS).

Japan’s position on the alignment of UN R137 with GTR 20 on electric vehicle safety.

Proposal to amend the requirements concerning post-crash electrical safety in the event of frontal collision. The proposal aligns post-crash electrical safety requirements with GTR 20 and aligns administrative provisions with Revision 3 of the 1958 Agreement. The amendments would not affect approvals for vehicles without high-voltage electric power trains.

Proposal to amend the requirements concerning post-crash electrical safety in the event of lateral collision. The proposal aligns post-crash electrical safety requirements with GTR 20 and aligns administrative provisions with Revision 3 of the 1958 Agreement. The amendments would not affect approvals for vehicles without high-voltage electric power trains.

Proposal to transpose the electrical safety requirements of GTR 20 into UN R100 and align administrative provisions with Revision 3 of the 1958 Agreement. The proposal provides for a 2-3 year transitional period. The proposal also integrates the amendments to UN R100 provided in document GRSP/2019/17.

Consolidated revision of UN R100 incorporating the proposal to transpose the electrical safety requirements of GTR 20 into UN R100 and align administrative provisions with Revision 3 of the 1958 Agreement. The proposal provides for a 2-3 year transitional period. The proposal also integrates the amendments to UN R100 provided in document GRSP/2019/17.

Proposal to amend the requirements concerning post-crash electrical safety in the event of frontal collision. The proposal aligns post-crash electrical safety requirements with GTR 20 and aligns administrative provisions with Revision 3 of the 1958 Agreement. The amendments would not affect approvals for vehicles without high-voltage electric power trains.

Proposal to cease new approvals of booster-cushion CRS under UN R44 from 1 September 2021 and to amend the transitional provisions accordingly.

Proposal to align UN R134 with UN R67 and UN R110 with regard to labelling requirements and to assist emergency services in determining appropriate responses in case of fire.

Proposal to introduce a tolerance for the position of the loading device during the test. The loading device is required to be parallel to the x-y plane of the chassis. This proposal would add a z dimension to the x-y plane and set a tolerance such that the loading device may not deviate by more than 5° along the z-axis.

Proposal to explicitly state that functional safety requirements apply to categories of vehicles beyond M₁ through the addition of the following text marked in bold:

When leaving the vehicle, the driver shall be informed by a signal (e.g. optical or audible signal) if the vehicleis still in the active driving possible mode. Moreover, in case of vehicles of category M₂ and M₃, such signal shall already be given when leaving the driver seat.

Proposal to add the specifications of flexible Pedestrian Legform Impactor (FlexPLI) to the Resolution on test devices.

Proposal to specify a head restraint height between 720 mm and 830 mm including a new method for measuring the effective height of head restraints, use of the Biofidelic Rear Impact Device (BioRID II) test dummy, and to improve the overall text. This proposal also eliminates the backset measurement test procedure using the HRMD method.

Proposal to clarify that modifications need only be notified to the Type Approval Authority when they have an influence on the performance (compliance with technical requirements of UN R16) and/or the documentation required by the UN Regulation.

Proposal to amend the dynamic option of the draft 10 series of amendments (document GRSP/2018/34). CLEPA proposes that injury risk limits should be based not only on the injury risk curves, but also on technical feasibility given the repeatability and reproducibility limits of the BioRID II test tool. This proposal also corrects the definition of T(end) which is different from T-HRC.

Proposal to amend the dynamic option of the proposal of amendment 1 of UN Global Technical Regulation No. 7 submitted by the Informal Working Group on the Phase 2 of UN GTR No. 7 (document GRSP/2018/27).

Proposal to clarify the application of GTR 7 Phase 2 static alternative provisions and to modify the allowed range of tolerances under the backset retention and energy dissipations test. The proposal would re-introduce certain paragraphs in the 09 series of amendments removed by the draft 10 series (GRSP/2018/34). In addition, the proposals adds the area where the gap measurement procedure by the sphere is appropriate per the Federal Motor Vehicle Safety Standard 202a (i.e. only gaps in the area over 540 mm).

Proposal to amend the static options of the proposal of amendment 1 of UN Global Technical Regulation No. 7 submitted by the Informal Working Group on the Phase 2 of UN GTR No. 7 (document GRSP/2018/27).

Proposal developed by the informal working group on protective helmets to introduce new categories of helmets and update provisions, including for sun visors. The new series would tentatively be phased in during 2022-2024.

Proposal to include booster cushion categories within the scope of the 03 series of amendments to UN R129.

Proposal to introduce objective criteria for evaluating whether a door remains latched following the pole impact test. Under UN R135, rear doors on the impacted side of the vehicle not directly struck by the pole may nonetheless be subjected to heavy loads and therefore need to be assessed. This proposal corresponds to a similar clarification already introduced into UN R95 on side impacts.

Proposal to introduce an optional (on the choice of the manufacturer) test procedure for frontal airbags in combination with rearward facing child restraint systems in the rear seat to demonstrate that no deactivation of the airbag is needed.

Proposal to amend the definition of integrated, detachable and separate head restraint.

Proposal to clarify that the warning signal to alert a driver of an M₂ or M₃ vehicle with more than 22 seating positions if the vehicle is in active-driving-possible mode when the driver leaves the seat shall be activated upon leaving the seat, not the vehicle.

Proposal to ensure pedestrian protection across the vehicle height variations that may be produced by an active suspension system.

Proposal to introduce limit values for the chest vertical acceleration (Az) of Q dummies during dynamic testing of Enhanced Child Restraint Systems (ECRS) until such time as upper neck tension Force (Fz) and upper neck flexion moment (My) criteria can be established.