Changes to the proposal to update and clarify Annex 6 on requirements for documentation, fault strategy and verification of the safety of electronic systems and complex electronic vehicle control systems related to vehicle steering.

Proposal to allow the use of a haptic signal as an alternative to the current requirement for an acoustic signal for the corrective steering function, provided the vehicle is equipped with a lane-departure warning system approved under UN R130. The proposal also introduces a requirement that the haptic warning must extend beyond the steering wheel (e.g., the signal would also include the driver’s seat) in order to address misuse (i.e., hands off the steering wheel use).

Safety of the Intended Functionality standard. Password protected for use within WP.29. Please contact the GRVA secretariat for access.

Presentation in support of the proposals for the 01 series of amendments and for Supplement 1 to UN R152 (respectively, documents GRVA/2019/16 and GRVA/2019/17.

The False Reaction scenarios in Annex 3-Appendix 2 were based on UN R131 (on-highway heavy vehicles) without verification of their applicability to urban light vehicles. Japan has begun research and anticipates proposing changes to the UN R152 scenarios in the near future. This proposal identifies scenarios under study and recommends tolerances for the vehicle and pedestrian dummy placements. Japan also raises concerns over the provision “the AEBS shall not provide a collision warning” in cases where there is no imminent collision risk.

Proposal to modify lateral acceleration values for Automatically Commanded Steering Functions (ACSF) of Category B1 (e.g., SAE L2 lane-keeping) and to allow the vehicle under test to change speeds in order to meet maximum lateral acceleration values when navigating curves.

Proposal to allow for higher lateral acceleration limits for Automatically Commanded Steering Functions (ACSF) in executing lane changes. The proposal modifies acceleration limits in the original proposal (GRVA/2019/27) and focuses on the timing for lane changes (e.g., 15-second total duration).

Proposal to introduce provisions for a “two-step Human Machine Interface” in the requirements for Automatically Commanded Steering Functions (ACSF) of Category C lane-change functions.

Text approved by GRVA consolidating input from stakeholders and agreed changes to the original proposal (GRVA/2019/19) for submission to WP.29 at its March 2020 session. The proposal amends the draft text (GRVA/2019/9) submitted to resolve measurement concerns in the test requirements for ACSF of Category B1 and C by introducing provisions for tolerances, including:

• inclusion of the position at which the lateral acceleration was measured and the position of the centre of gravity of the vehicle for better traceablility,
• sampling rate of at least 100 Hz for dynamic testing,
• specification of filters and cut-off frequency for determination of lateral acceleration,
• option to measure “overriding force” torque via an internal sensor or an external device (e.g., steering robot).

Proposal to add transitional provisions to document GRVA/2019/18.

Presentation on Tesla experience with hands-on lane-keeping and automated lane-change systems, especially with regard to lateral acceleration and distance limits under UN R79.

Proposal to correct editorial errors in the consolidated document WP29/2016/58 relating to GRRF-80-37, GRRF/2015/22 and GRRF-81-04-Rev.1 and to insert the word “tolerance” in para. 2.3.3.4.1.

Protected with a password for use by GRVA stakeholders: contact the secretariat for access.

AEBS informal group proposal to introduce new and enhanced requirements for the car-to-pedestrian test scenario.

Proposal from the AEBS informal group to improve and clarify the text of the Regulation.

Proposal the clarify the test method for the evaluation of performance of energy sources and energy storage devices under Annex 7. In particular, the proposal clarifies that the measurement is made on the ninth brake application.

Proposal to amend the draft text (GRVA/2019/9) submitted to resolve measurement concerns in the test requirements for ACSF of Category B1 and C by introducing provisions for tolerances, including:

1. inclusion of the position at which the lateral acceleration was measured and the position of the centre of gravity of the vehicle for better traceablility,
2. sampling rate of at least 100 Hz for dynamic testing,
3. specification of filters and cut-off frequency for determination of lateral acceleration,
4. option to measure “overriding force” torque via an internal sensor or an external device (e.g., steering robot).

Proposal to update and clarify Annex 6 on requirements for documentation, fault strategy and verification of the safety of electronic systems and complex electronic vehicle control systems related to vehicle steering. The assessment particularly addresses driver assistance and automated steering.

Proposal to introduce provisions for the approval of Remote Control Manoeuvring (RCM) systems.

Proposal to allow for the use of the maximum operable steering wheel angle of a steering system’s design in cases where the normalized angle as calculated under the regulation cannot meet the fixed values of the regulation (i.e., between 270 and 300 degrees). The intention is to enable approval of eventual systems (e.g., steer-by-wire) that may use low steering gear ratios.

Proposal to align GTR No. 3 with technical progress, addressing among others: electromagnetic compatibility/immunity of ABS-systems, ABS performance requirements for category 3-5 vehicles (three-wheelers), uniform requirements for equipment such Emergency Stop Signal and the means to disable the ABS, if equipped. This amendment aims to harmonize GTR with recent amendments made to UN Regulation No. 78 while addressing its use under self-certification compliance systems.

Proposal to introduce provisions for a “two-step Human Machine Interface” in the requirements for Automatically Commanded Steering Functions (ACSF) of Category C lane-change functions.

Proposal to align approval numbers and markings under UN R90 with Schedule 4 of Revision 3 to the 1958 Agreement.

Discussion of lateral acceleration values for Automatically Commanded Steering Functions (ACSF) of Category B1 (e.g., SAE L2 lane-keeping) and proposal to allow the vehicle under test to change speeds in order to meet maximum lateral acceleration values when navigating curves.

Proposal to allow for higher lateral acceleration limits for Automatically Commanded Steering Functions (ACSF) in executing lane changes.

Proposal to supplement paragraph 5.6.4.6.7. with additional requirements regarding lane-change driver actions that should allow for a more intuitive user experience while limiting a significant risk of mode confusion.