Proposal to increase the potential speed reduction during the collision warning phase and clarify the interpretation of “engine start/run cycle” pursuant to GRVA discussions during the 14th session.
Proposal to update the text with the American Society for Testing and Materials (ASTM) F2493-20 standard reference test tyre.
Proposal from the GRVA secretariat to update informal group deliverables for 2023-2024 under the Framework Document on Automated Vehicles.
Proposal to introduce new text concerning activation: “Notwithstanding the activation criteria above and following the activation request at any type of road by a deliberate action with the same means as for ACSF of Category B1, the ACSF of Category C may turn automatically to standby mode when entering a type of road as described above.”
Guidance from GRVA regarding the review of WP.29 regulations for applicability to vehicles equipped with driving automation systems.
Proposal to amend the extended mobility tyre (EMT) symbol following the detection of dimensional inconsistencies within the International Organization for Standardization Working Group (ISO) TC31/SC3/WG19, where the dimension “0,33h” was judged wrong and constituting an unnecessary over constraint and to amend the inflation value to be used for the tyre conditioning when assessing the “flat tyre running mode” of “run flat tyres” and of “extended mobility tyres”.
Proposal to clarify the scope and application of the regulation.
Proposal to improve the Appendix 2 Annex 3 for assessing robustness against false reaction, to introduce new provisions for automatic deactivation of AEBS, and to improve the text in other instances.
Proposal to introduce provisions under a car-to-bicycle test scenario.
Proposal to add a reference to the installation parameters (illumination levels, maximum gradient value, angles of visibility and light incidence angle) of the licence plate illumination lamps determined during their type approval process, to clarify the height requirements for the installation of the dipped-beam headlamp, reversing lamp and rear fog lamp for vehicles of category G (designed for off-road use), to clarify use of the term "electronic light source control gear”, to correct paragraph numbering, and to re-introduce provisions that were omitted by mistake in previous amendments.
Proposal for amendments that allows for tyre marking methods other than moulding.
Proposal to create a new UN Regulation on uniform provisions concerning the approval of a vehicle alarm system and approval of a vehicle with regard to its vehicle alarm system, pursuant to splitting the UN R116 into three separate regulations.
The deadline for the submission of official working documents is 2 November 2018