Proposal to:

1. Clarify that only one braking control (e.g., service braking control, parking brake control) shall be used for each test condition of the secondary braking effectiveness and permit the selection of the braking control based on the vehicle load condition, and
2. Establish definitions for “e-axle”, “e-axle trailer” and “dynamo function” and provisions for the approval of e-axle trailers with regard to their “dynamo function”.

Proposal to:

1. Clarify that only one braking control (e.g., service braking control, parking brake control) shall be used for each test condition of the secondary braking effectiveness and permit the selection of the braking control based on the vehicle load condition, and
2. Establish definitions for “e-axle”, “e-axle trailer” and “dynamo function” and provisions for the approval of e-axle trailers with regard to their “dynamo function”.

Proposal to:

1. Enable real-time reading of electrical transmission brake demand values via an OBD connector and scan tool during periodical technical inspections,
2. Clarify that only one braking control (e.g., service braking control, parking brake control) shall be used for each test condition of the secondary braking effectiveness and to permit the selection of the braking control based on the vehicle load condition,
3. Establish definitions for “e-axle”, “e-axle trailer” and “dynamo function” and to establish provisions for the approval of e-axle trailers with regard to their “dynamo function”.

Proposal to enable the application of UN R13 to automated vehicles, including those without manual controls.

Proposal to

1. Enable real-time reading of electrical transmission brake demand values via an OBD connector and scan tool during periodical technical inspections,
2. Clarify that only one braking control (e.g., service braking control, parking brake control) shall be used for each test condition of the secondary braking effectiveness and to permit the selection of the braking control based on the vehicle load condition, and
3. Establish definitions for “e-axle”, “e-axle trailer” and “dynamo function” and to establish provisions for the approval of e-axle trailers with regard to their “dynamo function”.

Proposal from OICA, CLEPA, and CITA to amend CITA’s proposal to enable real-time reading of electrical transmission brake demand values via an electronic vehicle interface and an off-board electronic device during periodical technical inspections, including a 24-month transitional period.

Proposal to establish definitions for “e-axle”, “e-axle trailer” and “dynamo function” and to establish provisions for the approval of e-axle trailers with regard to their “dynamo function”.

This document proposes amendments to UN Regulation 13 for trailers with dynamo function, superseding GRVA-22-26, GRVA-2025-15, and GRVA-21-12. The dynamo function converts vehicle kinetic energy into electrical energy without affecting braking system forces and is limited to trailers of category O₂, O₃, and O₄ pending further development. Maximum retardation power limits are 22 kW for O₃/O₄ trailers and 2 kW for O₂ trailers, measured using specified methods. Requirements include wheel locking prevention with braking rate not exceeding 0.04 per wheel, functional safety assessment per Annex 18, and demonstration that anti-lock and stability control systems comply when dynamo function is enabled. The dynamo function shall not be used during brake application testing. Administrative amendments update Annexes 2, 4, 5, 10, 19, 20, and 21 to reference e-axles and dynamo functions.

Proposal from the FADS informal group to amend its proposal to enable the application of UN R13 to automated vehicles, including those without manual controls.

Proposal to enable real-time reading of electrical transmission brake demand values via an OBD connector and scan tool during periodical technical inspections.

Proposal from the FADS informal group to introduce amendments to enable the application of UN R13 to automated vehicles, including those without manual controls.

The Task Force on regulatory Fitness for Automated Driving Systems reports proposed amendments to UN R13, R13-H, and R79. Amendments to R13 and R13-H, submitted as GRVA/2025/24 and GRVA/2025/25, include general clarifications, relaxed manual control requirements for vehicles of categories X and Y, clarification of braking system warning transmission to the ADS, and ESC compatibility provisions. R79 amendments, submitted as GRVA/2025/23, establish baseline manual control requirements for X and Y vehicles, remote control capabilities, ADS steering equipment requirements, and remove ALKS exemptions. Transitional provisions apply. The task force coordinates with other expert groups on horizontal topics and continues amending additional UN Regulations.

Proposal to add definitions for “e-axle”, “e-axle trailer”, and “dynamo function” for trailers of category O₃ and O₄, amend paragraph 2.2.2.4. to reference electric regenerative braking systems and electric propulsion systems, insert new paragraphs 5.2.2.26.1. through 5.2.2.26.5. establishing special requirements for dynamo function including maximum retardation power of 20kW, wheel locking prevention at speeds above 15 km/h, and assessment according to Annex 18, insert requirements in Annex 4 to switch off electric regenerative braking systems and dynamo function during brake applications and tests, and amend Annex 19 Appendices 5 and 7 to include e-Axles in schematic diagram considerations. This document is based on GRVA/2025/15 and GRVA-21-12.

Proposal to clarify that the use of any braking system control for testing the effectiveness of the secondary braking system in failure conditions is allowed.

Proposal to enable the type-approval of ADS vehicles, including those without manual controls.

Proposal to mitigate risks of decreasing trailer brake performance caused by brake pads and linings “falling asleep”.

Proposal for amendments) Proposal to mitigate the risks of decreasing trailer brake performance caused by brake pads and linings “falling asleep”.

Proposal for amendments) Proposal to mitigate the risk of decreasing trailer brake performance caused by brake pads and linings “falling asleep”.

Proposal to mitigate the risks of decreasing trailer brake performance caused by brake pads and linings “falling asleep”.

In-session mark-up from the 22nd FADS task force meeting.

Proposal to resolve the problem of decreasing trailer brake performance caused by brake pads and linings “falling asleep”.

Proposal from the FADS task force to update the text for application to certain ADS vehicles.

Draft proposal for amendments and clarifications, especially to address the applicability of the regulation to ADS vehicles, submitted by the FADS task force for information pending finalisation.

Proposal to amend provisions in documents GRVA/2025/13 and GRVA/2025/14 concerning the type approval of a park lock device as an alternative to or in combination with the friction parking braking.

Proposal to amend para. 2.2.2.4. to include electric regenerative braking system and electric propulsion system, amend para. 2.21. to define Electric Regenerative Braking (ERB), add para. 2.56. to define e-trailer, amend para. 5.2.2.7. regarding braking surface connection and electrical regenerative braking system disconnection, insert para. 5.2.2.26. establishing special requirements for e-trailers and trailers equipped with ERB of Category O₃ or O₄, insert Annex 4 paras. 1.7.1.3., 3.1.2.6., and 3.1.3.5. requiring ERB system deactivation during brake applications and tests, insert Annex 13 para. 4.7. requiring anti-lock braking system for vehicles with ERB, and amend Annex 16 tables to include trailer regenerative system parameters, based on GRVA/2025/15.