Submission of the International Motorcycle Manufacturers Association (IMMA) in order to change the inward visibility angle of front position lamp in Regulation No. 53.

Proposal to add “less than 5 degrees” as a test condition in order to prohibit the unintended use of bend lighting in the proposal for collective amendments to Regulations Nos. 53 and 113 on bend lighting for motorcycles.

Document WP.29/2012/76 is a proposal for Supplement 14 to the 01 series of amendments to UN R53 to introduce bend lighting for motorcycles. IMMA proposes to keep the bank angle threshold for activation at five degrees rather than the proposed three degrees.

Text prepared by the expert from the International Motorcycle Manufacturers Association (IMMA) to introduce the possibility of installing interdependent lamps for L3 category vehicles. Also, the amendment reflects the recent amendments to Regulation No. 48, Supplement 2 to its 06 series of amendments and further includes some editorial corrections of current Regulation No. 53 texts. The concern is that the rear trunk lid commonly used for four-wheeled vehicles may be adapted for future scooter type motorcycles to secure the storage space for helmet, etc. Current lamp requirements impose design constraints that may hamper the proper development of such storage features.

Text submitted by the International Motorcycle Manufacturers Association (IMMA) to allow for the use of different brake lamp activation methods for Powered Two Wheelers (PTWs). This amendment also introduces the concept of a high-mounted stop lamp to PTWs to improve the conspicuity of the vehicles during stopping.

Revised proposal (superseding document GRE/2014/8) to allow for the installation of interdependent lamps for L3 category vehicles. The amendment also reflects recent amendments to Regulation No. 48, Supplement 2 to its 06 series of amendments and further includes some editorial corrections of current Regulation No. 53 texts. The concern is that the rear trunk lid commonly used for four-wheeled vehicles may be adapted for future scooter type motorcycles to secure the storage space for helmet, etc. Current lamp requirements impose design constraints that may hamper the proper development of such storage features.

IMMA proposal to provide transitional provisions to the German proposal to delete R113 Class B headlamps from R53 (document GRE/2014/32).

Proposal to enable the approval of emergency stop signal on motorcycles to increase safety.

Proposal to allow the use of different brake lamp activation methods and to align the brake lamp provision with those applicable for four-wheelers.

Proposal to allow for the installation on motorcycles of light-signalling devices with light sources that can be sequentially activated.

Proposal to delete references to UN R113 Class B headlamps from the regulation.

Revised proposal to delete in Regulation No. 53 the references to headlamps of Class B of Regulation No. 113.

Proposal to explicitly allow direction indicators to be activated when the motorcycle engine is stopped in order to signal the vehicle status. Some motorcycles currently offer this feature; however, it is not clear whether the scope of Regulation No. 53 covers and allows this function.

Proposal to remove the prohibition against lamps “reciprocally incorporated” with any other lamp. This proposal would align UN R53 with UN R48 and correct an oversight from a previous amendment process.

Proposal to update the definition of “stop lamp” (in line with similar definitions in UN R7 and UN R48) so that it would allow the use of different stop lamp activation methods for powered two-wheelers (e.g. by the application of a retarder or a similar device). A corresponding proposal for amendments to Regulation No. 78 (GRRF/2017/14) has been submitted to the September 2017 session of the Working Party on Braking and Running Gear.

Proposal to align the draft Supplement 20 to the 01 series of amendments and draft Supplement 2 to the 02 series of amendments to UN R53 more closely with UN R48. These supplements concern the use of different stop lamp activation methods (in alignment with similar provisions for four-wheeled vehicles).

Proposal to clarify the text with regard to the activation of the direction indicators when the motorcycle engine in order to signal the vehicle status. The proposal would specify the purposes for which indicators may be activated:

1. To show the vehicle status (e.g. locking system) when the vehicle is parked;
2. To allow the driver to recognize the presence of his/her own vehicle from a certain distance by remote control;
3. In case of keyless entry system and of the driver having lost the key fob while riding – to inform the driver that he/she no longer has the key fob and that the vehicle will soon become unable to restart.

Proposal to allow installation of exterior courtesy lamps on motorcycles by aligning the text with provisions on courtesy lamps in UN R48.

Proposal to align UN R50 and UN R53 regarding the inward geometric visibility requirements for rear position lamps.

Proposal to update the definition of “stop lamp” in order to allow the use of different stop lamp activation methods for powered two-wheelers as currently applicable for four-wheelers; e.g. by the application of a retarder or a similar device.

IMMA proposal to delete definitions in UN R53.02 that are already in UN R48. Under the Simplification of Lighting Regulations (SLR) program, certain common lighting device definitions would be consolidated under UN R48 (lighting installation).

Proposal to clarify conditions under which direction indicator lamps may be switched ON to indicate the status of the device to prevent unauthorized use.

Proposal to include provisions for exterior courtesy lamps on motorcycles under UN R53 (as is already the case for motor vehicles under UN R48).

Proposal to restore the original automatic headlamp ON (AHO) requirement for vehicles not equipped with daytime running lamps (DRL). The 03 series of amendments (focusing on DRL) as approved by GRE during its October 2018 session (document GRE/2018/50) changes provisions for automatic headlamps as adopted for motorcycles in 2004 (see document GRE/2003/12/Rev.1). While appropriate for vehicles equipped with DRL, the changes would reduce safety for vehicles not equipped with DRL.

Proposal to restore the requirements for installing driving beams for motorcycles having a cylinder capacity > 125 cm³.

Proposal to restore the requirements for installing driving beams for motorcycles having a cylinder capacity > 125 cm³.

Proposal to align the 03 series of amendments to UN R53 (as adopted during GRE-81: GRE/2018/50, as amended by GRE/2019/12) with the latest proposals for amendments to the 01 and 02 series (as adopted by GRE but not yet in force at the time of the present proposal:

1. Add references to UN R148, R149, and R150 (WP.29/2018/104/Rev.1 as amended by WP.29-177-07, and WP.29/2018/105), implementing the change index and amending the definitions (taking into consideration informal document GRE-80-05),
2. Align UN R53 with UN R148 regarding the inward geometric visibility requirements for rear position lamps (GRE/2018/28),
3. Clarify the use of direction indicators to show the status of the device for protection of a vehicle against unauthorised use and allow exterior courtesy lamps to be fitted on motorcycles (WP.29/2019/17 as amended by para. 107 of the session report and WP.29/2019/18 as amended by para. 108),
4. Align UN R53 with UN R48 and correct a mistake in a previous amendment process (WP.29/2018/86/Rev.1 andWP.29/2018/87/Rev.1),
5. Allow the use of different stop lamp activation methods, aligning the definition of “stop lamp” with UN R48 (GRE/2018/29), and
6. Introduce requirements for light emitting diode (LED) substitute light sources (GRE/2018/41).

Proposal to enable the approval of Category L₃ equipped with adaptive driving beam (ADB) headlamps under UN R53 and R149.

Proposal to clarify the content of GRE/2019/23, aimed at ensuring that the new 03 series of amendments to UN Regulation No. 53 contains the latest proposals adopted by GRE regarding preceding series.

Comparison of adaptive driving beam provisions between the current UN Regulation No. 48 and the proposal for amendments to UN Regulation No. 53 (GRE-82-13).

Comments particularly with regard to the transitional provisions for the 03 series of amendments.

In the leaning condition, the operation of the ADB lamp and its effect do not change from the non-leaning condition which turns off the segment where a camera has detected preceding and/or oncoming vehicle(s).Therefore, there is no additional requirement for the leaning condition.

Proposal aim to allow the installation of Adaptive Driving Beams (ADB) on vehicles of category L₃.

Proposes to clarify the electrical connection requirements for a white front position lamp reciprocally incorporated with the front direction indicator.

Proposal aims to enhance the conspicuity of motorcycles equipped with a front position lamp reciprocally incorporated with a direction indicator, by clarifying the electrical connection requirements

Proposal to enable the use of Rear-End Collision Alert Signal (RECAS) on vehicles of category L₃.

Proposal including transitional provisions and justifications.

Draft amendments to UN R53 (based on SLR-71-07, SLR-71-7, SLR-66-01, SLR-73-07, SLR-75-05, and WP.29/2024/30) updates the baseline document for the 05 series of amendments. Key changes include: simplification of definitions and general specifications; consolidation of individual specifications; addition of EV inclusion and failure provisions; editorial harmonization with UN R48 baseline regarding hyphenation, terminology, and formatting; replacement of “visual failure tell-tale” with “tell-tale indicating failure” and “rear-end collision alert signal” with RECAS; standardization of vehicle category references; adoption of scientific notation with lumens; simplification of paragraphs 6.4 and 6; and revision of the transitional provisions.

Based on SLR-76-03-Rev1 for R48 and tentatively applying WP.29/2024/76, IMMA presents transitional provisions for UN R53. The document outlines provisions applicable to all amendment series, including that Contracting Parties may grant type-approvals according to any preceding series and shall continue granting extensions of existing approvals. For the 05 series of amendments, specific dates establish when Contracting Parties shall accept or refuse type-approvals, with exceptions for equipment, parts, and unaffected vehicle systems.

Proposal to amend multiple paragraphs in UN R53. Changes include: paragraph 5.3. to add tolerance specifications and manufacturer fitting requirements; paragraphs 5.6.2.1., 5.6.2.2., and 5.6.2.3. to reference UN Regulation No. 48; paragraph 5.8.1. to clarify direction indicator lamp photometric characteristics; paragraph 5.19.2. regarding dual lamp assemblies marked “D”; paragraph 6.1.7.2. for HIAS failure tell-tale specifications; paragraphs 6.2.4., 6.3.3.1., 6.10.4., and 6.11.4. to define geometric visibility angles; paragraph 6.9.3. for circuit-closed tell-tale requirements; Annex 1 paragraphs 9 to 10

Proposal to correct mistakes found in the current 04 series of amendments and align with UN R48, with appropriate adaptation of L category vehicles.

The document considers options for the Communication form of UN R53 regarding whether to include the UN R48 series number. Option 1 retains the current form without the series number. Option 2 adopts the current Baseline document style. Option 3 adds an area in the comment section. Option 4 invites other ideas. Feedback is requested on which option should be adopted.

This document proposes draft provisions for a 05 series, updating the previous baseline (SLR-71-07). Key changes include simplification of definitions by referencing UN R48 where applicable; consolidation of geometric visibility requirements with uniform formatting; incorporation of electric vehicle (EV) provisions; inclusion of rear-end collision alert signal (RECAS); replacement of legacy terminology with hyphenated forms (e.g., “direction-indicator lamp,” “type-approved”); use of scientific notation for luminous intensity values; and reduction of transitional provisions to retain only the 05 series requirements. Annex 3 has been reserved and deleted. The regulation applies to the installation of lighting and light-signalling devices on motorcycles and prescribes mandatory and optional devices with specifications for position, geometric visibility, orientation, electrical connections, and tell-tales. Transitional provision dates remain undecided.