Proposal to align the 03 series of amendments to UN R53 (as adopted during GRE-81: GRE/2018/50, as amended by GRE/2019/12) with the latest proposals for amendments to the 01 and 02 series (as adopted by GRE but not yet in force at the time of the present proposal:

1. Add references to UN R148, R149, and R150 (WP.29/2018/104/Rev.1 as amended by WP.29-177-07, and WP.29/2018/105), implementing the change index and amending the definitions (taking into consideration informal document GRE-80-05),
2. Align UN R53 with UN R148 regarding the inward geometric visibility requirements for rear position lamps (GRE/2018/28),
3. Clarify the use of direction indicators to show the status of the device for protection of a vehicle against unauthorised use and allow exterior courtesy lamps to be fitted on motorcycles (WP.29/2019/17 as amended by para. 107 of the session report and WP.29/2019/18 as amended by para. 108),
4. Align UN R53 with UN R48 and correct a mistake in a previous amendment process (WP.29/2018/86/Rev.1 andWP.29/2018/87/Rev.1),
5. Allow the use of different stop lamp activation methods, aligning the definition of “stop lamp” with UN R48 (GRE/2018/29), and
6. Introduce requirements for light emitting diode (LED) substitute light sources (GRE/2018/41).

Proposal to

• align UN R50 and UN R53 regarding the inward geometric visibility requirements for rear position lamps;
• to allow the use of different stop lamp activation methods for powered two-wheelers as currently applicable for four-wheelers; e.g. by the application of a retarder or a similar device.
• restore the definition of “device” (because the definition under UN R53 differs from that under UN R48)
• delete the definitions of “bend lighting”, “H plane”, “sequential activation” and “emergency stop signal” (because they are identical to the definitions in UN R48), and
• introduce requirements for light emitting diode (LED) substitute light sources.

Proposal to align UN R50 and UN R53 regarding the inward geometric visibility requirements for rear position lamps, to allow the use of different stop lamp activation methods for powered two-wheelers as currently applicable for four-wheelers; e.g. by the application of a retarder or a similar device, and to make editorial corrections.