Proposal to address non-negligible differences in sound performance in cases where COP tests are carried out under conditions that differ from those used for the granting of the type approval. The proposal introduces conditions, procedures, and corrections to be applied to L_urban to account for the difference in test conditions.

Proposal to introduce a definition for “Electronic” to mean a principle of operation by electric or electro-magnetic force with amplifier and speaker or resonator in order to address new technologies enabling a driver-actuated audible signal of the presence of a vehicle in a dangerous traffic situation.

Proposal to delete the reference to abrasion requirements in Annex 3, paragraph 6.4.1.3. since abrasion resistance is not relevant in the assessment of resistance to weathering.

Proposal to introduce a generic drawing to improve interpretation of the regulation, especially with regard to contactable parts (sphere protocol).

Proposal to improve the communication document. The current wording of item 2 in Annex 1 is redundant with item 3 and not aligned with similar texts (UN R58 or R73). The key point of item 2 is to identify the type of device or component approved.

Editorial amendments to proposed transitional provisions

Proposal to clarify the requirements of paragraph 5.26. for the variable luminous intensity of four different light signaling functions: rear direction indicator lamps of category 2b, rear position lamps of category R2, stop lamps of category S2,and rear fog lamps of category F2. The intent is to ensure that all the lamps maintain their proportionate relationships throughout the transitions in luminosity.

vary all together proportionally.

Proposal to allow under specified conditions the use of logos inside the illuminating surface of a signalling lamp.

Proposal to introduce objective criteria for evaluating whether a door remains latched following the pole impact test. Under UN R135, rear doors on the impacted side of the vehicle not directly struck by the pole may nonetheless be subjected to heavy loads and therefore need to be assessed. This proposal corresponds to a similar clarification already introduced into UN R95 on side impacts.

This document proposes a draft text for a resolution on “activities other than those related to driving” that the driver of a vehicle equipped with an automated driving system could undertake when the automated driving system is engaged.

Proposal to introduce electromagnetic specifications for the approval of an electronic device, such as a transponder — even without the traditional functionality of a mechanical key — under UN R62 via reference to UN R10 on electromagnetic compatibility (as is the case under UN R116). This proposal relates to document GRSG/2018/15 adopted during the previous GRSG session and subsequently adopted by WP.29 during its March 2019 session (document WP.29/2019/8)..

Status report of the BMFE informal working group.

Proposal to clarify rounded-edge requirements for roof-opening roof devices.

Proposal to introduce objective criteria for evaluating whether a door remains latched following the pole impact test. Under UN R135, rear doors on the impacted side of the vehicle not directly struck by the pole may nonetheless be subjected to heavy loads and therefore need to be assessed. This proposal corresponds to a similar clarification already introduced into UN R95 on side impacts.

Proposal to amend the draft text (GRVA/2019/9) submitted to resolve measurement concerns in the test requirements for ACSF of Category B1 and C by introducing provisions for tolerances, including:

1. inclusion of the position at which the lateral acceleration was measured and the position of the centre of gravity of the vehicle for better traceablility,
2. sampling rate of at least 100 Hz for dynamic testing,
3. specification of filters and cut-off frequency for determination of lateral acceleration,
4. option to measure “overriding force” torque via an internal sensor or an external device (e.g., steering robot).

Proposal to define “electronic” as a “principle of operation by electric or electro-magnetic force with amplifier and speaker or resonator”.

Proposal to introduce electromagnetic specifications for the approval of an electronic device, such as a transponder — even without the traditional functionality of a mechanical key — under UN R62 via reference to UN R10 on electromagnetic compatibility (as is the case under UN R116).

Proposal to introduce a generic drawing to improve interpretation of the regulation, especially with regard to contactable parts (sphere protocol). The proposal aims to clarify how to deal with potentially “exempted” parts and which requirements apply to which part of the windscreen wiper. Given the implications for approvals, the proposal is presented as a new series of amendments with transitional provisions starting 24 months after entry into force.

Proposal to allow the use of logos inside the illuminating surface of a signalling lamp under certain conditions.

Presentation on new national legislation that defines a new vehicle category, “urban shuttle”. The legislation skirts the current M category definitions by defining an urban shuttle as having a total capacity to carry between nine and 16 passengers plus a driver with seating for 4-5 passengers. As such, France intends to propose national type approvals for such vehicles with a view to address driverless versions in future legislation.

Presentation on the status of the informal working group on bus management of fire events (BMFE).

“Arrêté du 6 mai 2019 définissant les conditions d’homologation, d’exploitation et de circulation des navettes urbaines”