Addendum 1 to the Report of the GRRF on its 86th session

Proposal as approved by the GRRF to introduce formulae for tyre sizes in Annex 5, Table B, add sizes in Annex 5, Part II, Tables C and E for old sizes that do not follow the guidelines/formulae applicable for high flotation tyres, amends footnotes in Annex 5, Part II, Table B in order to clarify categories of use, clarify tyre width tolerances, correct paragraph numbering and references, align the text editorially with UN R30 and to make other editorial improvements,

Proposal as approved by GRRF to add tyre sizes and tyre classification codes common in the United States and standardised by the Tire and Rim Association, but needed under UN Regulation No. 106 in order to permit their type approval in conformity with Regulation EU 167/2013 for imported tyres. The proposal adds kPa marking specifications for use in measurements and tyre testing. The proposal further includes changes to the text and addition of tyre size designations to Annex 5 and Annex 7:

1. Paragraph 2.33.2 deleted since new tables for IF and VF were added to Annex 7
2. Paras 3.2., 3.2.2. and 5.4. modified because “tyres submitted for approval” cannot bear an approval mark until approved and the “only” as it is written can be misunderstood. Para. 3.2.2. was aligned to the wording in other UN Regulations. Reference to para. 3.3 in paragraph 5.4. is deleted because paragraph 3.3 does not refer to specific markings
3. Para 6.1.2. amended to align the wording to the headers in Annex 5 and to correct the reference to the footnote
4. Para 6.2.1. amended to restore the proper references after renumbering resulting from the latest Supplements
5. The amendment of Annex 5, Table 5 adds the value for the overall diameter (D) in column (*) that applies to tyres marked with classification code “I-3”
6. Annex 5, Table 6, Note 1 amended because most of the tyre sizes listed in the table, especially those identified by the “classification code I‐3” (i.e. Traction tread), are currently available in both versions: ‘implement’ to be used on agricultural machinery and ‘IND’ to be used on construction vehicles. The two types of tyres have the same type of size designation and the same dimensions. Therefore some manufacturers identify those tyres with the suffix ‘IND’ rather than with the suffix ‘IMP’ thus applying the variation of load capacity with speed as published in Annex 7 Part E. The reason for this proposal is to avoid a duplication of tables with a new table only replacing the suffix IMP with the suffix IND.
7. The addition of the footnote to Annex 5, Table 7 answers the request by GRRF to introduce appropriate formulae in the Regulation instead of continuously updating Annex 5.
8. References in Annex 7 corrected pursuant to the renumbering following the introduction of three new paragraphs in Supplement 15 approved during the 172nd session of WP.29.
9. Annex 7, Part A amended to conform with Tire and Rim Association specifications for code designated diagonal tyres with speed symbol A8.

Proposal to add replacement brake components for L₆ and L₇ (quadricycles) to the regulation, to correct references, and to clarify the text. This proposal aligns UN R90 with UN R78 (motorcycle braking).

Proposal of requirements for L category vehicles. The original proposal addressed a broader range of issues and could not be finalized during the GRRF session. This document allows items where consensus was reached to move forward for WP.29 consideration.

Changes and notes made to the ACSF informal group status report as part of the GRRF discussion on how to deliver approval requirements for ACSF B2 (lane-keeping at Level 3 automation) within the prescribed mandate of the group. The ACSF group is expect to deliver a draft text within the next nine months.

CLEPA presentation on the type approval process for replacement brake pads, linings, and drums and the impact of the new approval numbering system adopted under Revision 3 to the 1958 Agreement on approvals and markings of these products.

Proposal to resolve inconsistencies present from Supplement 2 to the 02 series of amendments resulting from the approval of proposals in documents GRRF/2014/23/Rev.2, GRRF/2015/22 and GRRF/2016/22. The proposal also introduces provisions for L category (motorcycle and related) vehicles.

Updated version of document GRRF/2017/14 to amend UN R78 with regard to stop lamp activation. IMMA has proposed (document GRE/2015/42) to allow stop lamp activation under UN R53 through means other than application of the brakes (e.g., by electric vehicle regenerative braking). This proposal accordingly amends UN R78 regarding generation of the brake signal.

Annex 1 of UN R55 concerns the type approval communication form. Item 9.3. requires information “For Class A mechanical coupling devices or components, including towing brackets”. Poland proposes to add “if fitted” to the description in order to avoid interpretations that brackets must be part of the approval (i.e., the approval may concern the coupling ball without additional attachments).

Revised proposal concerning remote-controlled parking (RCP). The new series 02 of Regulation 79 introduced requirements for RCP systems. An RCP system requires the engagement of an EPB (electronic parking brake) once the manoeuvre has finished and the ignition is switched off. This proposal would allow the release or disconnection of the EPB by a remote control system (approved to R79) so the RCP can subsequently drive the vehicle out of a parking spot. The second proposal in the original document concerning regenerative braking and stop lamp activation will be discussed again as a revised formal document at the September 2018 GRRF session.

Revision 7 of Regulation No. 13 includes a former version of Figure 1B which was changed with Amend 4 to Revision 6 of UN Regulation No. 13. This correction is also needed for Revision 8, which contains the same error.

Germany proposed, in document GRRF/2017/24, to require automatic reactivation of a manually deactivated automatic braking system. One concern with the proposal invoked the need for prolonged deactivation under certain circumstances, such as when a vehicle is fitted temporarily with a snow plow. This proposal would explicitly require AEBS to be capable of detecting a blocked sensor (already implicit in the regulation) such that AEBS would not reactivate in such cases.

Proposal to add a paragraph to define the purpose of the “SS” marking introduce by the amendments to UN R106 on agricultural and related off-road tyres.

Norwegian request for GRRF comments on protection of steering gear and attachment to heavy vehicle frames. In a collision in Norway, the steering gear detached from the vehicle frame following a frontal collision such that the driver could no longer control the vehicle. Norway seeks input on strengthening the protection of steering gear in order to avoid such a situation.

Marked up text of the tyre GTR Amendment 1 with improvements to the text (Phase 2A in the development of the regulation).

TyreGTR informal group presentation of Amendment 2 to the GTR on tires.

Proposal to amend footnotes in Annex 5, Part II, Table B in order to clarify categories of use.

Session agenda updated pursuant to the latest informal document submissions.

Proposal to correct a mistake in Supplement 17 to UN R75 (adopted document WP.29/2017/8). Annex 7, Paragraph 1.2., Footnote 1 should refer to UN R54, not UN R106.

Pursuant to Supplement 21 to UN R54 replacing PSI with kPa to indicate tyre inflation pressures, UN R109 requires updating. This proposal would allow both markings under UN R109 because the life cycle of the carcasses spans several years.

Correction of a cross-reference error in the original documents GRRF/2018/5 and GRRF/2018/11.

The European Agreement Concerning the International Carriage of Dangerous Goods by Road (ADR) requires vehicles to be equipped with a speed limitation device compliant with UN R89. UN R89 refers to speed limitation devices (SLD) and speed limitation functions (SLR) (i.e., aims to be technologically neutral). Russia requests GRRF confirmation that compliance with UN R89 can be achieved through either an SLD or SLF.

OICA counter-proposal to address the German concern over manual deactivations of AEB systems. The original document (GRRF/2017/24) proposed automatic reactivation of the AEBS when the vehicle speed exceeds 30 km/h. OICA proposes reactivation after 15 minutes of continuous operation at a speed above 70 km/h.

Possible scenarios for developing regulatory provisions for snow tyres under UN tyre regulations.

Proposal of amendments to the proposal to introduce provisions for the approval of Remote Control Manoeuvring (RCM) systems, defined as driver-actuated systems on off-road vehicles used for navigating exceptionally difficult terrain. OICA seeks to cover remote control applications for low speed manoeuvring not addressed in the original UK proposal.

Proposal from Germany and the Republic of Korea to resolve measurement concerns in the test requirements for ACSF of Category B1 and C. The proposal addresses issues identified in Annex 8, improves reproducibility and robustness of the procedures, fills in gaps in the test cases, and provides additional details on measuring equipment and test execution.

Revised proposal from OICA pursuant to comments received during the previous GRRF session to

1. exempt cases where the driver has temporarily deactivated the speed limiter from the warning requirement for excess speed in in order to reduce driver distraction
2. introduce throttle control via adjustment of the accelerator pedal position
3. to correct an editorial error in paras. 5.2.5.4.2. and 21.2.5.4.2.

This document presents two proposals. (1)The new series 02 of Regulation 79 introduced requirements for RCP (remote controlled parking) systems. An RCP system requires the engagement of an EPB (electronic parking brake) once the manoeuvre has finished and the ignition is switched off. This proposal would allow the release or disconnection of the EPB by a remote control system (approved to R79) so the RCP can subsequently drive the vehicle out of a parking spot. (2) Proposal to permit illumination of the stop lamp for electric regenerative braking under 0.7m/s² deceleration in order to allow for “one-pedal driving” of electric vehicles.

A field study on tyre inflation pressures and TPMS fitment on passenger cars carried out in Sweden, Germany and Spain between November 2016 and August 2017. The study is the first of its kind worldwide covering all types of TPMS and taking into account the specific tyre inflation pressure recommendations for cold tyres as well as the actual tyre temperatures at the time of measurement.

Report on the development of AEBS requirements for light vehicles, including a note on the intention to seek GRRF approval for a new regulation on M₁/N₁ vehicle AEBS separate from the current UN R131 on heavy-duty vehicle AEBS.

Revised technical report to accompany the proposal for amendment 3 (concerning mainly ABS issues) to GTR 3.

Revised proposal to align GTR No. 3 with technical progress, addressing among others: electromagnetic compatibility/immunity of ABS-systems, ABS performance requirements for category 3-5 vehicles (three-wheelers), uniform requirements for equipment such Emergency Stop Signal and the means to disable the ABS, if equipped. This amendment aims to harmonize GTR with recent amendments made to UN Regulation No. 78 while addressing its use under self-certification compliance systems.

Report of the expert group on agricultural coupling devices and components on the development of a new UN Regulation.

Introductory statement to document GRRF-86-04 proposing amendments in order to provide a legal approval framework for extended mobility tyres under UN R30 and their recognition as “emergency mobility equipment” under UN R64.

Discussion of run-flat tyres and extended mobility tyres (EMT) in support of a general proposal to establish approval procedures for EMT under UN R30 and include EMT as “emergency mobility equipment” under UN R64. The proposal makes reference to recent activity on ISO 16992 regarding EMT test protocols.

Proposal to correct Revision 2 of UN R55 to align with the text of Supplement 04 to 01 series of amendments. This proposal removes a subparagraph under paragraph 13.1 that should not have been included in the Revision.