Proposal to specify a target-oriented quasi-static certification of the upper legform impactor for the upper legform to bumper test, as described in Chapter 7 of the GTR.

Proposal ro clarify that the removal of an insert may also trigger additional tests with alternative dummy statures.

Proposal to improve the shoulder height requirements to properly take the dimensions of premature newborns into account

Presentation on creation of ISOFIX. There is interest from several specialists on Child Restraint Safety, CRS manufacturers and Consumer Organisations to add a 3rd fixed point.

Question remains, what if the ECRS is permanently or temporarily connected, on what basis can compliance with (the technical provisions of) UN R10 be required ?

Proposal applies to Supplements 3 to the 04 series of amendments. Proposal to clarify the scope of data from tests to the windscreen that must be provided for the purpose of type approval.

This proposal is to correct the clerical error found during transposing amendment 1 to GTR 13, Phase 2 (GTR13-PH2) into the Regulation

Proposal to correct inconsistencies following the amendment for vehicles of category O

Proposal to correct inconsistencies following the amendment for vehicles of category O

Proposal also for a corrigendum 1 to the 04 series of amendments and a
corrigendum 1 to the 5 series of amendments

Procedural request for authorisation to introduce provisions for supply lines between compressed hydrogen storage systems (CHSS) and their thermally activated pressure relief devices (TPRD) based on the outcomes from the transposition of GTR-Phase 2 (Amendment 1) transposition into UN R134.

Proposal to amend UN R134 regarding hydrogen and fuel cell vehicles. The amendment clarifies requirements for supply lines serving additional thermally activated pressure relief devices (TPRDs) on compressed hydrogen storage systems. It specifies that supply lines must be constructed from metallic materials, demonstrate mechanical integrity through qualification tests excluding drop tests, and establishes handling procedures to prevent damage. The proposal also defines container attachments and refines test procedures for burst pressure, drop impact, permeation, and localized leak testing.

How could greater diversity in terms of representation of crashes and occupants be implemented in concerned crash safety regulations?

Presentation on the REGAM project
objectives :
• Determine the most injured body segments (frequency and severity) and identify representative accident scenarios associated with these injuries.
• Design robust (repeatable) virtual and physical tools, capable of assessing the level of protection provided by airbags

Proposal concerning the description and performance of test tools and devices necessary for the assessment of compliance of wheeled vehicles, equipment and parts according to the technical prescriptions

Proposed modifications to ECE/TRANS/WP.29/GRSP/2025/7