Input from Germany in response to the European Commission request (document GRSG-106-38) for input on the possible type approval of new systems that enable unlocking cars via smart phones and that send silent alarms to security services via the Internet.

Pursuant to research conducted in Japan, this document recommends amending UN R110 with regard to:

1. Welded metal cylinders
2. Steel cylinders (CNG-1 cylinder) and Steel liner cylinders (CNG-2 cylinder)
3. Accessories fitted to the cylinder, and
4. Indication of cylinder and accessories fitted to the cylinder.

The document also raises the possibility of further considerations concerning LNG cylinders.

Proposal to exclude M1 vehicles from the close-proximity field of vision requirements pursuant to the establishment of the international whole vehicle type approval system.

Explanations and arguments in support of the amendments to UN R43 proposed by the Informal Group on Plastic Glazing (IGPG) in document GRSG/2014/23.

Proposal by Germany to amend the Swedish proposal (document GRSG/2014/6) to introduce approval provisions for automatic fire suppression systems activated upon the detection of fire in the engine and/or heater compartment of buses and coaches. This proposal would limit mandatory installation to Class III vehicles.

OICA comments on the proposal to introduce fire suppression systems for buses and coaches upon detection of fire in the engine and/or heater compartment (document GRSG/2014/6).

UN R116 specifies operating voltages and voltage limits. Current technology and intelligent battery management systems allow for precise control and definition of these parameters. This includes “intelligent” operating ranges in order to optimize energy management (CO2 emission reduction). Fixed operating voltage ranges are therefore unnecessary or even may hinder efforts for CO2 emission reduction in the future. OICA proposes language to modify the design-restrictive language.

Paragraph 5.3.1. refers to Appendix 8 of Annex 1. OICA believes that the reference should be to Appendix 10 of Annex 1 and so proposes this correction.

The draft 03 series of amendments follows current UN guidelines for regulatory texts (document WP29/1044/Rev.1); however, a new version of the guidelines which uses a different phrasing for transitional provisions will soon be adopted. Therefore, OICA proposes using the new wording in the draft 03 series.

More detailed explanation of the proposal (document GRSG/2014/24) to update the reference to ISO 6722 in the cable test (i.e. replace the reference to “IS0 6722 paragraph 12” with a reference to “ISO 6722-1:2011 paragraph 5.22”).

Proposal to correct the calculation of total mass under the draft 05 and 06 series amendments intended to align Annex 11 of UN R107 with Regulation (EU) 1230/2012 (i.e., the amendments proposed in document GRSG/2014/22).

Proposal to modify the draft amendment to UN R39 that would introduce odometer requirements (document GRSG/2014/32). OICA proposes to change the definition of “odometer” to refer to the distance recorded rather than traveled and to delete the definition of “technical constant of the odometer”.

This proposal aims to enable the use of thick glass panes for multiple glazed units which, in turn, requires omitting the head-form test in case of these units.

OICA and CLEPA comments on the Korean proposal to amend GTR No. 6 and UN Regulation No. 43 in response to issues identified in its defect investigation concerning panoramic sunroofs.

Correction to clarify that the scope of the GTR covers windscreens and panes for cars and trucks and to harmonize the text with ISO 3537/ UN R43. The present text could be read to limit the scope of windscreens and double window panes.

Proposal for an amendment to UN Regulation No. 43 to define a “reduced vision zone I” for vehicles of categories M and N other than M1. The goal is to extend the concept that already exists for M1 vehicles in order to enable the installation of sensors and cameras that improve driving safety.

Proposal to introduce fire suppression systems for buses and coaches upon detection of fire in the engine and/or heater compartment, superseding document GRSG/2014/6.

Proposal to delete provisions regarding the optical display of the status of the vehicle alarm system outside the passenger compartment in order to avoid driver distraction by and/or confusion of such exterior lighting with primary lighting and signaling equipment required under UN R48.

Proposal to delete provisions regarding the optical display of the status of the vehicle alarm system outside the passenger compartment in order to avoid driver distraction by and/or confusion of such exterior lighting with primary lighting and signaling equipment required under UN R48.

This file is password-protected. ISO provided these standards "for the sole purpose of review during UNECE GRSG regulations development for GRSG participants, and not for public posting or reproduction without ISO’s permission.” Parties involved with this work may contact the GRSG secretariat to obtain the password.

ISO Standard 11439 concerns “High pressure cylinders for the on-board storage of natural gas as a fuel for automotive vehicles”. ISO 6722 concerns ’60 V and 600 V single-core cables — Part 1: Dimensions, test methods and requirements for copper conductor cables".

Amended proposal to include odometers within the scope of UN R39, deleting the reference to the “technical constant” and a provision for the installation of a replacement odometer.

Proposal to amend the draft 03 series of amendments to UN R58 (document GRSG/2014/18).

Comments in support of the proposal to introduce provisions for fire-suppression systems under UN R107.

Proposal to revise the text of document GRSG-107-25 on fire suppression systems to ensure that the provisions can be applied fully to natural gas and/or hydrogen-powered vehicles.

Progress report from the group of experts working on provisions to enable the type approval of video systems in place of conventional rear-view mirrors.

Request to postpone consideration of the Dutch proposal concerning the discharge of natural gases from a pressure relief device (PRD) in anticipation of conclusions and best practices on the location and venting of PRD from a research program underway in the US.

Corrections to the proposal to clarify the provisions of Chapter 18 following the introduction of automatic valves (see report GRSG/84, para. 38).

Proposal to add a definition for “CNG Accumulator” and to revise a related decision tree flow chart.

Revised proposal to introduce more stringent requirements for rear underrun protection devices, amending and superseding document GRSG/2014/18.

Proposal to clarify that “low-floor vehicles” concern only those vehicles that provide a single step from the ground into the low floor area and that any equipment that would counteract the intention of such single-step low-floor vehicles to facilitate access by passengers with reduced mobility is prohibited.

Proposal to introduce the automatic activation of the hazard warning lights upon detection of excess temperatures in the engine and/or heater compartment.

Proposal to clarify the text of the amendments updating provisions for service doors, windows and emergency exits. The main purpose of the proposal is to delete the prohibition on the use of laminated glass or plastic material in window panes and to delete the provision that emergency windows shall be capable of being operated from outside.

Text proposing to clarify the current transitional provisions of UN Regulation No. 107. The proposal aims to ensure the validity of the preceding series of amendments to UN R107 for vehicles not impacted by the 05 series (mandating temperature alarm systems in certain bus compartments not directly visible to bus occupants).

Proposal to introduce fire suppression systems for buses and coaches upon detection of fire in the engine and/or heater compartment.

Updated proposal to insert provisions in Annex 3 to facilitate access to a roof escape hatch in the event that the vehicle is lying on its side, superseding document GRSG-105-05 which superseded the original proposal in document GRSG/2013/17.

Text prepared to introduce provision to address difficulties encountered by technical services located at high altitudes in fulfilling the barometric pressure conditions required for the impact test. This document supersedes informal document GRSG-105-24.

Proposal to clarify the testing method for resistance to high temperature in order to address issues raised with testing at high altitudes. CLEPA proposes to amend the wording of paragraph 5.1. to clarify how to proceed with a test in boiling water, which is permitted for safety glazing with both external surfaces of inorganic material. The tolerance of +0 °C / -2 °C is taken from ISO 3917, high temperature test. The temperature of boiling water can be determined with the required accuracy easily.

Proposal to introduce, for special cases, adjustments to the coordinates of the ocular points used to check compliance with the required field of vision provided by the rear-view mirrors.. The proposal would align the definition of the “driver’s ocular points” with that of Regulation No. 125 (forward vision) as also used in EC Directive 2003/97/EC as amended by Directive 2005/27/EC. This document is based on informal document GRSG-105-19.

Alternative from OICA to the proposal offered by Germany (document GRSG/2013/27 which is expected to be updated and presented as GRSG/2014/18) to introduce more stringent requirements for rear underrun protection devices.

Proposal to adapt the provisions for multi-function displays to technological progress. In principle, current displays can convey more information to the driver, including levels of severity or importance, while the current text was written when technologies were less flexible. As a result, the current provisions risk impeding the use of beneficial multi-function tell-tales. This text is based on informal document GRSG-105-21.

Proposal to extend the scope of UN Regulation No. 118 to vehicles powered by compressed natural gas (CNG).

Proposal to avoid imposing administrative burdens on small glazing that is not required for the driver’s forward or rearward field of vision.

Text prepared by the Informal Group on the Introduction of Plastic Glazing for windscreens and laminated plastic panes other than windscreens into UN Regulation No. 43 (IGPG) in order to clarify the requirements of Annex 21 (provisions on the installation of safety glazing on vehicles).

Proposal to amend the requirements for fire prevention under certain conditions in the event of a rear collision. This document supersedes the earlier proposal contained in document GRSG/2013/4.

Proposal to require automatic mirrors to unfold automatically when the vehicle reaches a speed higher than 10 km/h. The concern is to address certain mirrors designed not to unfold at speeds up to 45 km/h.