With each development phase (series of amendments), UN R129 has expanded its scope in terms of child restraint applications (e.g., i-Size, specific vehicle ISOFIX, i-Size booster seat, specific vehicle booster seat, etc.). Paragraph 3.2.2. requires the applicant for type approval to declare the intended application or combination of applications. CLEPA proposes new language to specify the various possible combinations and related requirements in order to maintain consistency between phases 1 and 2 and phase 3.

Presentation to initiate discussions on the impact of storage compartments, such as in vehicle floors, on the safe installation and use of i-Size CRS.

Revision of Table 1 of the new draft regulation on child restraint systems to replace the bench foam of UN R44 with the foam of the New Programme for the Assessment of Child restraint Systems (NPACS) used during the regulation’s evaluation phase and adopted by the informal group.

Review of open issues concerning ISOFIX child restraint systems.

Proposal to align UN R44 with UN R129 with respect to the references to European standard EN 71:2009 (which specifies safety requirements for toys, especially with regard to chemical composition, flammability, and other mechanical and physical properties).

Presentation on the main principles behind the new enhanced child restraint systems provisions:

1. Modern dummy and criteria
2. Classification based upon child size
3. Integral universal ISOFIX
4. Side-impact protection
5. Mandatory rear-facing up to 15 months
6. improved compatibility

Fact sheet on UN R129 including comparison with UN R44.

Proposal to add missing Integral fixtures for Regulation No. 129. Fuller explanation can be found in document GRSP-57-09.

Completion of missing Integral fixtures for Regulation 129. The Universal Fixture was compatible with 39 of 40 vehicle types (97.5%) tested, but a lateral fixture (lie flat, carry cot) is needed for certain special cases.

Presentation in support of the proposal (document GRSP-58-16) to amend the toxicity and flammability declarations via references to EN71.

Proposal to amend the toxicity and flammability declarations via references to EN71 (European safety standards).

Proposal to amend the toxicity and flammability provisions. This proposal runs in parallel with the proposal to amend the 00 series of amendments (document GRSP-58-32).

Amendment to the proposals (GRSP/2016/3, GRSP/2016/5, and GRSP/2016/6) to amend the toxicity and flammability declarations via references to EN 71 (European safety standards), taking into account procedures of FMVSS 302. The amendments propose the burning rate values of FMVSS 302 (302.4 inches/102 mm per minute), to harmonize the three proposals with regard to EN standards references, and to incorporate the amendment 1 to EN 71-3 (A1:2014).

CLEPA response to the presentation on the phase 1, 2, and 3 amendments to UN R126 (document GRSP-61-28) regarding the proposals for amendments to the 01 and 02 series of amendments and for the 03 series of amendments. CLEPA expresses concern that certain restrictions and requirements have been proposed without adequate research and discussion, often related to concerns raised under UN R44, that would imposed unwarranted burdens on manufacturers.

Proposal to correct the omission of the exemption of non-integral ECRS with a stature range starting at 100 cm or above from the testing of toxicity in Supplement 1 to R129 (document WP.29/2016/106, paragraph 6.3.1.1.). This correction should also be applied to the later documents:

• GRSP /2017/44 Proposal for Supplement 7 to R129,
• GRSP /2017/43 Proposal for Supplement 4 to 01 series of amendments to R129,
• GRSP /2017/42 Proposal for Supplement 3 to 02 series of amendments to R129, and
• GRSP /2017/41 Proposal for 03 series of amendments to R129.

Proposal to align end-user information provisions with those adopted for UN R44.

Certain enhanced child restraint systems are designed for forward-facing and rearward-facing depending upon the age of the occupant. This proposal would clarify the labeling and packing information to avoid confusion between the requirements for these “dual” systems and exclusively forward-facing CRS.

During its 61st session, GRSP approved Supplement 3 to the 01 series of amendments and Supplement 2 to the 02 series of amendments. This proposal reinserts text inadvertently omitted during the reproduction of the text as approved during the session.

Pursuant to the concern raised by Spain to avoid a misinterpretation that shoulder strap positioners must be designed to be released before the harness buckle, This proposal clarifies that a shoulder strap positioner may be released before, after, or simultaneously with the harness buckle. The proposal also improves the text with regard to the release of modules from a base.

Proposal to remove the age and stature characteristics from the definition of an “Infant carrier” to avoid misinterpretations. These seats may be used by children above the age specification provided they fall within the stature limits.

Proposal to explicitly allow the granting extensions for type approvals under the 02 series of amendments and for any approval not affected by 03 series of amendments pursuant to the new guidelines on UN Regulations.

Proposal of corrections to document GRSP/2018/29 (previously submitted by CLEPA) regarding the introduction of booster-cushion provisions into UN R129.

Proposal to clarify the use of the i-Size logo on i-Size boosters.

Labels under UN R129, paragraph 4.5. highlight that the ECRS should not be used by children under 15 months old. This proposal presents the same layout for rearward/forward-facing and for forward-only CRS.

Proposal to clarify that Conformity of Production assessments shall be conducted under the same requirements as those of the original approval or, if applicable, the extension of the approval. This proposal supersedes the proposal to require testing of Integral ISOFIX ECRS to use the door panel geometry of the 00 series of UN R129 (document GRSP/2018/31).

Proposal to introduce provisions for the booster cushion category of child restraint systems under UN R129.

Final refinements developed during the May 2019 GRSP session to the proposal to include booster cushion categories within the scope of the 03 series of amendments to UN R129 (Supplement 3 to the 03 series).

Proposal to provide information on the essential measurement information that needs to be recorded in the Type Approval test report

Proposal to improve the repeatability and reproducibility of the assessment of the external dimensions of the ECRS. It does not change any current dimensional requirements relating to the sizes of the body of the ECRS, the support leg or the support leg foot.

Proposals for “tasks and deliverables” with regard to enhanced child restraint systems and alternative seating configurations enabled by automated driving.

Proposal to clarify aspects of document GRSP/2020/03, which is based on documents GRSP-66-11 (Digital User Guide) and GRSP-66-12 (Test Report Template) introduced during the 66th GRSP session. The proposed amendments are based on feedback received from stakeholders.

Proposal for amendments to the injury assessment criteria for frontal and rear impact to specify limit values for tension force and flexion moment measured in the upper neck of the Q0, Q1 and Q1.5 dummies.

Consolidated proposal based on document GRSP/2020/3 to clarify aspects the current procedure, formalize the assessment practice and improve the transparency and consistency of Type Approval testing results. The document incorporates proposals for Digital User Guide and Test Report Template pursuant to discussions on document GRSP-67-16.