Proposal for a new UN Regulation on tire installation for use within the International Whole Vehicle Type Approval system.

Proposal to align the requirements of UN R113 with those adopted in Regulations Nos. 98, 112 and 123 relating to movement of the cut-off line after heat test and to correct an error in the provisions on the use of LED modules.

Presentation of a proposal for type approval authority “attestations” to address cases where a UN Regulation contains provisions not required in all markets. For example, UN R48 contains provisions for daytime running lamps presently required in the EU but not in Japan. An attestation would declare a vehicle compliant with all aspects of UN R48 except that the vehicle is not fitted with DRL.

Version of the document following the GRE-75 discussions on 8 April 2016.

Proposal to enable the use of alternate colors (per footnote 18 of Table 1 and in line with ISO Standard 2575) for certain lighting tell-tales in order to indicate light source failures in response to the proposals for light failure indicators under UN Regulations Nos. 7, 48 and 87 (GRE/2016/7, GRE/2016/12 and GRE/2016/17) as adopted by GRE. This proposal anticipates use of the same approach in response to plans for additional failure indication requirements for other lighting regulations.

Proposal from the informal working group on the International Whole Vehicle Type Approval to restructure UN R116 into two separate regulations. The regulation addresses anti-theft, alarm, and immobilizer aspects of theft prevention. Since these aspects may be mandatory or optional depending upon the country or market, the application of UN R116 to whole vehicle type approval becomes problematic. This proposal would extract the immobilizer provisions into a separate new regulation.

Presentation of issues raised during discussions of the GRE Task Force on EMC requirements with regard to the application of several UN Regulations to trolley buses depending upon their configuration (e.g., dual-mode operation either connected to overhead cables or in standard bus mode).

Illustration of the UN Regulation approvals information sheet as proposed in the related document SGR0-19-13, superseding the previous attachment SGR0-19-13/att.1.

Updated report from Japan’s MLIT consideration of the IWVTA procedures, identifying concern over the definition and verification of information contained in type approvals. Attachment 1 to this report lists the various items from type-approval certificates that MLIT found difficult to verify independently.

Proposal to clarify that the component approvals underpinning a vehicle type approval do not have to have been issued to the same manufacturer, but that the responsibilities of the manufacturer applying for vehicle type approval to the type approval authority nonetheless remain intact.

Updated MLIT report raising concerns over the way approval numbers reflect the supplements covered. The draft Revision 3 of the 1958 Agreement requires that each approval number include the applicable supplement number; however, the application for a change of the supplement number does not constitute application for an extension of the approval. As a result, the approval number will not be changed even if a different supplement comes into force, resulting in a product having a supplement number that is different from the actual number of the supplement in force.

Report highlights that regulations under IWVTA may not apply equally to two vehicles of the same type; for example, application of high voltage protection provisions only to electrified vehicles, but not their ICE homologue.