Proposal to cease new approvals of non-integral group 2 and group 2/3 child restraint systems under UN Regulation No. 44 as of [1 September 2018].

Proposal to correct Table 1 by deleting “F1” (this fixture is part of a corresponding ISO Standard but not in UN R16) and to replace “universal” by “i-Size” in the title of Appendix 5, as UN R129 booster seats can be only i-Size or specific.

Proposal to correct paragraph 1.2. by deleting “and Appendix 5” in order to align with the text of Supplement 9 to the 06 series of amendments to UN R16, to correct Table 1 by deleting “F1” (this fixture is part of a corresponding ISO standard not found in UN R16), and to correct Appendix 5 by replacing “universal” with “i-Size” (UN R129 booster seats can be only i-Size or specific).

Proposal to clarify the text of UN R14. The current text has produced differing interpretations among Technical Services with regard to which requirements apply to central seating positions in rear rows of category M₁ and N₁ vehicles and the minimum distance between two effective lower belt anchorages (L1 and L2). The proposed amendments clarify that a reduced minimum distance of 240 mm is only allowed in the case where there is only one central seating position (i.e. in a row of 3 seating positions). Rear seat rows with an even number of seats always shall have a distance of at least 350 mm. Given that it entails new requirements, the proposal is presented as a new series of amendments with transitional provisions (proposed through 2025).

Proposal to clarify that the second level warning requirement in the 02 series of amendments to the UN R16 is dependent upon the needs of each seating position. A strict reading of paragraph 2.45. would require a second-level warning in the event of any unfastened seat-belt in a front or rear position. This proposal would clarify that the second-level warning is required depending on the individual position requirement (e.g., based on detection that a position is occupied).

Proposal to clarify that seat belt components such as retractors shall not sustain damage during testing according to Annex 9 of UN R17. Such components have occasionally been damaged during testing such that their functionality has been impaired. In order to ensure adequate occupant safety, this proposal would require all safety-belt components to be included in the test installation and require post-test inspection to confirm the absence of damage.

Proposal to introduce installation specifications for securing a cab mounted on a vehicle to the test rig for tests B and C, as is currently provided for test A, under UN R29. This proposal aims to improve repeatability and reproducibility while allowing more flexibility in permitting the use of rigid composite blocks and/or (adjustable) metal brackets in securing the vehicle in the place of the wooden block presently prescribed in Figure 1.

Proposal to harmonize airbag warning labels regarding the correct use of a child restraint system in a seating position equipped with an activated frontal airbag in order to prohibit the display of additional information unrelated to child safety.

Proposal to delete a reference to the “Y” symbol denoting a crotch strap. The Y symbol is no longer used in UN R129 and the presence of this reference has caused problems in interpretation of requirements.

Proposal to specify the proper use and behavior of an adult safety-belt used to install a non-integral Enhanced CRS during dynamic tests. These instructions are present in UN R44, but not in UN R129. Therefore, this proposal would align the two regulations.

Proposal to allow for the use of electronic means (QR code, smartphone software application, etc.) in furnishing the consumer with the list of vehicle applications of a CRS.

Proposal to allow for the use of electronic means (QR code, smartphone software application, etc.) in furnishing the consumer with the list of vehicle applications of a CRS.

Proposal to allow for the use of electronic means (QR code, smartphone software application, etc.) in furnishing the consumer with the list of vehicle applications of a CRS.

Proposal to allow for the use of electronic means (QR code, smartphone software application, etc.) in furnishing the consumer with the list of vehicle applications of a CRS.

Proposal on behalf of the Technical Services Group (TSG) on UN Regulation No. 129 to delete the requirement for chest deflection and abdominal pressure data under the dynamic tests. These criteria were not required in this (original or 00 series) version of UN R129.

Proposal on behalf of the Technical Services Group (TSG) on UN Regulation No. 129 to clarify that the opening force applied to the ISOFIX attachments of a complete seat or of a seat component under the test protocol is 50 ± 1 N.

Proposal on behalf of the Technical Services Group (TSG) on UN Regulation No. 129 to clarify that the opening force applied to the ISOFIX attachments of a complete seat or of a seat component under the test protocol is 50 ± 1 N.

Proposal on behalf of the Technical Services Group (TSG) on UN Regulation No. 129 to clarify that the opening force applied to the ISOFIX attachments of a complete seat or of a seat component under the test protocol is 50 ± 1 N.

Pursuant to the approval of GRSP/2017/13 as amended in document GRSP-61-14-Rev.1 at the 61st GRSP session, this proposal clarifies the test protocol for positioning and securing the child restraint system on the vehicle.

In line with amendments presented in document GRSP/2017/13 and adopted by GRSP to clarify the seat belt installation procedure for testing integral child restraint systems (in order to ensure proper evaluation of potential injury risks), this proposal recommends corresponding amendments to address non-integral child restraint systems (e.g., booster seats).

Proposal to clarify the conditions where a door is deemed to be open under UN R95. Technical Services have interpreted the definition of “open” under paragraph 5.3.1. differently, resulting in divergent outcomes. The proposed definitions are taken from UN Regulation No. 135 Revision 1.

Formal proposal for the “Phase 3” amendments (universal belted and specific-to-vehicle belted CRS) prepared by the CRS informal group.

CRS informal group proposal to correct wording and chapter references, clarify test procedures, and introduce new definitions.

CRS informal group proposal to correct wording and chapter references, clarify test procedures, and introduce new definitions.

CRS informal group proposal to correct wording and chapter references, clarify test procedures, and introduce new definitions.