Proposal to:

1. harmonize airbag warning labels regarding the correct use of a child restraint system in a seating position equipped with an activated frontal airbag in order to prohibit the display of additional information unrelated to child safety, and
2. clarify that only a 3-point-belt shall be permitted for the driver seating position in order to address differing interpretations among Technical Services regarding which requirements apply for driver position seat-belt approval.

Proposal to require seat belt components such as retractors to remain functional if damaged during the load-retention test according to Annex 9 of UN R17. Such components have occasionally been damaged during testing such that their functionality has been impaired. In order to ensure adequate occupant safety, this proposal would require all safety-belt components to be included in the test installation and require post-test inspection to confirm the continued functionality. The transitional provisions phase in the new requirements during September 2020-September 2022.

Proposal to align UN R24 (Compression Ignition Engines – Emission of Visible Pollutants – Power Measurement) with UN R85 with regard to correction factors.

Proposal to modify the Constant Volume Sampling system temperature sensor time response requirement.

Proposal to modify the Constant Volume Sampling system temperature sensor time response requirement.

Proposal to modify the Constant Volume Sampling system temperature sensor time response requirement.

Proposal to

1. clarify the fuel tank capacity restriction for mono-fuel gas vehicles (insertion of word “nominal” in definition of “mono-fuel gas vehicle”;
2. modify the Constant Volume Sampling system temperature sensor time response requirement;
3. allow the use of WLTP-based Ki and Deterioration Factors (DF) as well as On-Board Diagnostics (OBD) demos under UN R83 to permit use of WLTP methods and test results under UN R83;
4. align the definitions for bi-fuel vehicles align with the new definitions in UN GTR 15,
5. amend paragraph 5.3.1.2.4. to recognize that particulate pollutant emissions measurements are no longer limited to compression ignition vehicles;
6. introduce provisions for reagent tank specifications and limits for triggering warning and driver inducement systems.

Proposal to

1. clarify the fuel tank capacity restriction for mono-fuel gas vehicles (insertion of word “nominal” in definition of “mono-fuel gas vehicle”;
2. modify the Constant Volume Sampling system temperature sensor time response requirement;
3. allow the use of WLTP-based Ki and Deterioration Factors (DF) as well as On-Board Diagnostics (OBD) demos under UN R83 to permit use of WLTP methods and test results under UN R83;
4. align the definitions for bi-fuel vehicles align with the new definitions in UN GTR 15,
5. amend paragraph 5.3.1.2.4. to recognize that particulate pollutant emissions measurements are no longer limited to compression ignition vehicles;
6. introduce provisions for reagent tank specifications and limits for triggering warning and driver inducement systems.

Proposal to allow the usage of WLTP-based Ki and Deterioration Factors (DF) as well as On-Board Diagnostics (OBD) demos under UN R101. The proposal allows the use of the more robust WLTP and eases testing burdens by allowing manufacturers to use WLTP test results for UN R101.

Proposal to explicitly specify requirements related to the selection of driving modes for testing of Off-Vehicle Charging Hybrid Electric Vehicles (OVC-HEV) with a mode selection switch.

Proposal to align UN R132 with the 05 series of amendments to Regulation No. 96.

Proposal to align the Russian text with the English version.

In the absence of complete harmonization with ISO 11439, this proposal recommends that Table 6.4 of UN R110 should be amended by the following for CNG-1 designs:

1. Delete A.17, A.25, and A.7 since they do not match the tests specified in paragraph 7.5 on Cylinder design qualification tests
2. Add A.15 and A.6 since they do match the tests specified in paragraph 7.5 on Cylinder design qualification tests
3. Add A.24 because paragraph 6.9 on Fire protection requires all PRDs on all cylinder types to comply with A.24.

Proposal to align the Russian text with the English version.

Proposal to align the French text with the English version.

Proposal prepared by the secretariat to correct and improve the quality of the image of Figure 1a of Annex 5.

Proposal to combine the provisions of individual UN Regulations Nos. 4, 6, 7, 23, 38, 50, 77, 87 and 91 into a single UN Regulation on uniform provisions concerning approval of light-signalling devices for power-driven vehicles and their trailers. This consolidation simplifies and streamlines requirements without changing detailed technical specifications already in force. The Regulation applies to eleven categories of lamps including rear-registration plate illuminating, direction indicator, position, stop, end-outline marker, reversing, manoeuvring, rear fog, parking, daytime running, and side marker lamps. Requirements address administrative provisions, type approval, approval marks using unique identifiers or conventional E-marks, general and specific technical requirements for each lamp function, photometric and colorimetric characteristics, etc.

Proposal for a new UN Regulation on Road Illumination Devices (RID) to supersede UN Regulations Nos. 19, 98, 112 (thus 1, 8, and 20), 113 (thus 56, 57, 72, 76, and 82), 119, and 123.

Proposal for a new UN Regulation on retro-reflecting devices (RRD) to supersede UN Regulations Nos. 3, 27, 69, 70, and 104.

Proposal to introduce the flexible pedestrian legform impactor (FlexPLI) test tool, a new bumper test area definition, and related Injury Assessment Reference Values (IARVs).

Appendix to the proposal for Amendment 2 to GTR 9 providing the rationale, justifications, and other supplemental information concerning the development of the amendment to introduce the Flex PLI lower legform impactor and related test procedures, including new bumper test area specifications.

OICA proposal to clarify that the numbering of type approvals for UN Regulations does not apply to UN Regulation No. 0 on international whole vehicle type approval. Numbering under UN R0 is explained in that Regulation.

The objective of this proposal is to develop, in the framework of the 1998 Agreement, an amendment to UN Global Technical Regulation (UN GTR) No. 6 on Safety Glazing to adapt the Regulation to technical progress by providing optional use of thinner laminated-glass panes meeting mechanical strength requirements in front, exterior, forward-facing glazing of upper deck of double decked buses instead of laminated windscreen.

Update to the original agenda in order to add references to additional documentation and to delete references to documentation where none has been received.

Proposal to expand the scope of the regulation on unauthorized L-category vehicle use to include electronic devices such as keyless entry systems, similarly to what already exists in UN R116 on passenger car use.

Proposal to insert type (item 1.1.) and pressure classification (item 1.2.) in the communication form (Annex 2B).

Proposal to insert type (item 1.1.) and pressure classification (item 1.2.) in the communication form (Annex 2B).

Proposal to clarify the positioning of lateral protection devices on central axle trailers.

Proposal to clarify that Contracting Parties applying this Regulation shall continue to accept type approvals granted to the 06 or 07 series of amendments to vehicles which are not affected by the 08 series of amendments.

Proposal to require, in instances where ogive protective covers are fitted to a cylinder, that the covers be removed before conducting the impact damage (drop) test. The proposal further would amend and clarify the need for a gas flow adjuster under UN R110 with regard to the use of carburetors and fuel injectors. A gas flow adjuster is not necessary when an electronic fuel injection system manages the air/fuel mixture and therefore should be removed from paragraph 18.3.1. An adjuster is needed when air/fuel mixture runs via a carburetor and therefore should be added to paragraph 18.3.2.

Proposal to remove references to European radio frequency standards (paragraphs 6.2.3., 7.2.3. and 8.2.2.). Telecommunications devices must meet requirements specific to local markets. Therefore, the references to standards specific to European markets (but not other markets) fall outside the purview of UN Regulations.

Proposal to introduce requirements for CNG compressor and CNG accumulator components designed to maintain stable pressure in fuel systems and to allow the use of a generator fueled by the vehicle gaseous fuel system that provides electricity to run accessories (e.g., overnight power in sleeper cabs, to maintain battery charge during high electrical power use with loading or lifting equipment).

Proposal to correct Revision 2 of UN R55 to align with the text of Supplement 04 to 01 series of amendments. This proposal removes a subparagraph under paragraph 13.1 that should not have been included in the Revision.

Proposal to strike “sur un montage rigide” from paragraph 6 (Essai effectué sur un montage rigide/sur un véhicule/sur des parties représentatives du châssis d’un véhicule2) in order to align the French version with the English and Russian versions of the text and to introduce a clarification of the correspondence between UN 58 and the 03 series of amendments to UN R31.

Proposal to delete paragraphs 7.2.3.1.1. to 7.2.3.1.3. in Annex 3. In 2008 WP.29 adopted document WP.29/2008/98 under Supplement 3 to the 02 series of amendments, deleting all marking requirements and transferring them to Annex 11. Nonetheless, Revision 4 of UN R107 as published on the UNECE website includes the deleted paragraphs. This proposal aims to correct that error.

Proposal to delete paragraphs 7.2.3.1.1. to 7.2.3.1.3. in Annex 3. In 2008 WP.29 adopted document WP.29/2008/98 under Supplement 3 to the 02 series of amendments, deleting all marking requirements and transferring them to Annex 11. Nonetheless, Revision 4 of UN R107 as published on the UNECE website includes the deleted paragraphs. This proposal aims to correct that error.

Proposal to delete paragraphs 7.2.3.1.1. to 7.2.3.1.3. in Annex 3. In 2008 WP.29 adopted document WP.29/2008/98 under Supplement 3 to the 02 series of amendments, deleting all marking requirements and transferring them to Annex 11. Nonetheless, Revision 4 of UN R107 as published on the UNECE website includes the deleted paragraphs. This proposal aims to correct that error.

Proposal to delete paragraphs 7.2.3.1.1. to 7.2.3.1.3. in Annex 3. In 2008 WP.29 adopted document WP.29/2008/98 under Supplement 3 to the 02 series of amendments, deleting all marking requirements and transferring them to Annex 11. Nonetheless, Revision 4 of UN R107 as published on the UNECE website includes the deleted paragraphs. This proposal aims to correct that error.

Proposal to delete paragraphs 7.2.3.1.1. to 7.2.3.1.3. in Annex 3. In 2008 WP.29 adopted document WP.29/2008/98 under Supplement 3 to the 02 series of amendments, deleting all marking requirements and transferring them to Annex 11. Nonetheless, Revision 4 of UN R107 as published on the UNECE website includes the deleted paragraphs. This proposal aims to correct that error.