Proposal for testing electric vehicles against thermal propagation risks, including nail penetration method.

Update on the work concerning head restraint height measurement, dynamic test for rear impacts, BioRID II dummy certification and R&R, GTR “whiplash” injury criteria, and introduction of the BioRID test tool into the Mutual Resolution 1 compendium.

Proposal to expand the application area of the energy absorption criteria for seating in order to facilitate the optimization of seat-belt load limiters by allowing limited occupant contact with these seat areas.

Revised amendment to introduce all the modifications needed in UN Regulation No. 129 (Enhanced Child Restraint System (ECRS)) that were suggested by the experts of the informal working group on Child Restraint Systems (IWG CRS) to extend the scope of this Regulation to Non-Integral child restraint systems (“Universal Booster” or “Specific to vehicle Booster”) (Phase 2 of the UN Regulation).

Revised amendment, including track changes, to introduce all the modifications needed in UN Regulation No. 129 (Enhanced Child Restraint System (ECRS)) that were suggested by the experts of the informal working group on Child Restraint Systems (IWG CRS) to extend the scope of this Regulation to Non-Integral child restraint systems (“Universal Booster” or “Specific to vehicle Booster”) (Phase 2 of the UN Regulation).

Editorial improvements to the text and introduction of provisions allowing for the separation of connectors (including the vehicle inlet) without the use of tools under prescribed conditions.

Editorial improvements to the text and introduction of provisions allowing for the separation of connectors (including the vehicle inlet) without the use of tools under prescribed conditions.

Proposal to clarify the text related to the recently expanded height requirements for the effective upper belt anchorage (Supplement 4 to the 07 series of amendments to Regulation No. 14).

Revised CLEPA proposal to clarify dynamic testing, rear seat system, advanced restraint system approval, and transitional provisions. This proposal supersedes document GRSP/2014/27.

Proposal to introduce provisions concerning universal child booster seating positions.

Proposal to introduce provisions concerning universal child booster seating positions with the amendments shown within the text of the regulation, incorporating the amendments proposed in document GRSP/2014/14.

The scope of the new Global Technical Regulation on Pole Side Impact includes vehicles of category N1 (limited to GVM < 3.5 t) and vehicles of category M1 (without mass limit). However, the vehicle fleet includes a small number of M1 vehicles with a GVW > 3.5t which are based on vehicles of category N2, N3, M2 or M3. Therefore, OICA proposes to limit the scope of the GTR to both M1 and N1 vehicles under 3.5 t maximum vehicle mass in order to alleviate burdens on manufacturers producing M1 variants based on N2, N3, M2, or M3 vehicles.

Text prepared by the UN R44 Technical Services Group to clarify the regulation, including test failure parameters, CRS displacement or locking systems, seat installation color coding systems, and use of load limiting devices. The test procedure would be modified, including an increase in the applied load to exceed the maximum allowed resistance to permit sliding of the strap through the quick adjuster and through rigid parts, increased tolerances related thereto, deletion of the option for shorter shift (deemed unnecessary since it is a test on the strap, not on the complete component), and modification of drawings to improve consistency with the text.

Request for clarifications on the application of relaxation areas under UN Regulation No. 127.

Request for clarification of test procedures for active pedestrian protection devices (such as active hood, pedestrian airbag).

Updated presentation showing relative risks of injuries within and outside the proposed bumper test area and comparing late-model (post-2006) cars against earlier models based upon GIDAS data.

Japan is developing national legislation to prescribe requirements for the body, hydrogen storage containers and their specific components, batteries etc. of hydrogen fuel-cell powered motorcycles.

Proposal to include “MFP” in the labeling requirement for hydrogen containers. MFP refers to the maximum allowable container pressure under normal use.

Proposal to amend the toxicity and flammability declarations via references to EN71 (European safety standards).

Question and answer brochure on the i-size child restraint systems regulation.