Proposal to clarify and amend the supplement concerning sequential direction indicators adopted by GRE during its 76th session based upon document GRE/2016/20 and finalized in Annex IV of the session report. The proposal would clarify and move the prohibition against the mixing of signals of two or more activation modes to UN R48 and introduces transitional provisions.

Revised proposal to clarify the requirements for light sources in the lighting and light-signalling Regulations listed in Annex 4 to Regulation No. 0 on the International Whole Vehicle Type Approval (IWVTA) pursuant to GRE-77 discussions.

The 05 and 06 series of amendments provide for automatic adjustment of lamps based on ambient light conditions. To avoid misuse of the daytime running lamps (DRL), automatic switching between DRL and dipped-beam headlamps is preferable; however, manual switching for specific cases is still necessary. Under the transitional provisions for series 05 of amendments, only automatic switching would be permissible after 30.7.2016 (for new type of categories M1 and N1 vehicles) and after 30.1.2018 (for new type of other categories vehicles). Nonetheless, in the transitional provisions for series 06 of amendments, the same transitional period appears to have been unintentionally omitted. This proposed supplement corrects this mistake in the 06 series by deleting the alternatives to the automatic switching from the 06 series of amendments:

1. deletion of paragraphs 6.2.7.6.2 and 6.2.7.6.3;
2. merging and rewording of paragraphs 6.2.7.5 and 6.2.7.6;
3. consequent editorial adjustment in paragraph 5.11.1.3. and 6.19.7.4. to maintain acceptable the rear position lamps switching possibility allowed by the present text;
4. small editorial changes to better clarify that an automatic switching based on different factors in respect to those prescribed in paragraph 6.2.7.5. (new numbering) are allowed only as supplemental condition;
5. other editorial changes and renumbering for text and numbering coherence.

Proposal to amend GRE/2016/33 and GRE-76-17 pursuant to discussions at the October 2016 GRE-76 session:

1. The direct reference to Regulations Nos. 97 and 116 that was included in GRE-76-17, para. 2.37. was removed based on the observation of the representative of Finland on a potential split, in the future, of some of the Regulations under the responsibility of GRSG.
2. In another remark from the representative of Finland, the word “indicator” that was missing in the last sentence of para. 2.37. in the text of the proposals GRE/2016/33 and GRE-76-17 has been added.
3. Based on the comments from the representatives of France, UK, Finland and Japan, the area of the apparent surface, mentioned in GRE/2016/33 and GRE-76-17, para. 5.30. (c) has been lowered from 50 cm² to 20 cm², in the case of one indicator is being installed on the vehicle. If two indicators are installed, the area of the apparent surface should not exceed 10 cm² per indicator.

Modifications to the proposal for a supplement to the 06 series of amendments to UN R48 with regard to switching between daytime running lamps and dipped-beam headlamps.

Proposal to update paragraph 6.9.8. with regard to current technologies (e.g. LED and IPS) where instrument panels remain illuminated whenever the engine is running. With the advent of new automated technologies and Advanced Driver Assistance Systems (ADAS), the number of warnings and symbols may dramatically increase in the near future. This proposal aims to reduce risks of driver confusion by reducing the number of symbols displayed on the instrument panel. The Chinese Standard GB 4094 already captures this possibility. The proposal is therefore also a move toward further international harmonization.

During October 2016, GRE-76 adopted collective amendments (GRE/2016/31) to align the requirements of lamp regulations (7, 23, 38, 48, 77, 91 and 119) to guarantee the conformity of the lamp in case of any failure or the mandatory indication that a failure had occurred. This means that when a failure indication signal is provided by the lamp, the vehicle shall be equipped with a tell-tale indicating the failure. Thus, amendments were proposed for Regulation No. 48 to specify the modes of displaying the corresponding failure (see GRE/2016/7). Subsequently, some GRE experts requested GTB to clarify the text of its proposal. This proposal amends UN R48 with respect to all lamps affected by GRE/2016/31 to include the failure indication requirement. The proposal does not apply to the failure indication requirements already in UN R 48 prior to the last (76th) GRE session.

Proposal to:

1. delete paragraphs 6.2.7.6.2. to 6.2.7.6.3.2. concerning transitional provisions for the 05 series of amendments,
2. to clarify that drivers may not switch OFF the dipped-beam headlamps manually when they are switched ON automatically according to paragraph 6.2.7.6.1., and
3. to clarify that daytime running lamps shall not be switched OFF except as specified in paragraphs 6.19.7.1. to 6.19.7.6. (For example, DRLs shall not be switched OFF when only the position lamps are ON.).

Proposal to clarify the requirements for light sources in the lighting and light-signalling Regulations listed in Annex 4 to Regulation No. 0 on the International Whole Vehicle Type Approval (IWVTA).

Presentation on vehicle loading and inclination and impact on headlamp leveling and glare.

Proposals for amendments to Regulations Nos. 4, 6, 7, 19, 23, 38, 48, 50, 77, 87, 91, 98, 112, 113, 119, 123 to clarify requirements for light sources in lighting and light-signalling Regulations listed in Annex 4 to UN Regulation No. 0. The proposed UN R0 on whole vehicle type approval requires submission of approval certificates for components and systems. Vehicle manufacturers work directly with UN R48 approvals, but lamp and device approvals are generally handled by lighting suppliers. UN R48 includes provisions for listing approvals of lighting units, but not for approvals of light sources (presently UN R37, R99, and R128). This set of proposed amendments introduces provisions for light-source approvals under the device regulations.

Extract from the International Commission on Illumination publication “Performance Assessment Method for Vehicle Headlighting Systems”.

Proposal to introduce requirements for light emitting diode (LED) substitute light sources into Regulations Nos. 48, 53, 74 and 86.