Proposal to correct a reference to the 01 series of amendments to UN R148 and to align UN R48 with the 01 series of amendments to UN R148 and R149.

Proposal to correct a reference to the 01 series of amendments to UN Regulation No. 148 and align UN R48 from the 03 to the 08 series of amendments with 01 series of amendments to UN Regulations Nos.148 and 149.

Proposal to:

• Clarify that only light-signalling devices may incorporate an illuminated logo
• Align UN R48 with 01 series of amendments to R148 and R149.

Proposal to:

• Align UN R48 with UN R149 with regard to light sources and objective luminous flux
• Replace the term “LED module” with “Light source module”
• Align he requirements for off-road vehicles passing-beam vertical inclination across the 06, 07, 08 series and the 09 series
• Allow the projection of a pattern for predicted trajectory
• Amend failure detection and signalisation requirements to reflect technological progress in multiple light sources
• Remove the double requirement for a sum of reference marks and a sum of maximum luminous intensities.

Proposal to:

• Align UN R48 with updated requirements in UN R149 with regard to light sources and total objective luminous flux
• Replace the term “LED module” with “Light source module”
• Modify wording to adapt to the introduction of “matched pair” requirements for headlamps and AFS
• Align the requirements for off-road vehicles passing-beam vertical inclination across UN R48 series
• Allow the projection of a pattern for predicted trajectory
• Amend failure detection and signalisation requirements to reflect technological progress in multiple light sources.

Proposal to:

• Align the requirements in UN R48 with updated requirements in UN R149 (e.g., require the communication form to indicate whether the total objective luminous flux of one or more light source(s) or light source module(s) for a dipped beam exceeds 2,000 lumens)
• Replace the term “LED module” with “Light source module” and modify wording to adapt to the introduction of “matched pair” requirements for headlamps and AFS
• Align the requirements for off-road vehicles passing-beam vertical inclination between the 06, 07, 08 series and the 09 series of amendments to UN R48
Allow the projection of a pattern for predicted trajectory
• Amend failure detection and signalisation requirements to reflect technological progress in multiple light sources.

Proposal to:

• Align the requirements in UN R48 with updated requirements in UN R149 (e.g., require the communication form to indicate whether the total objective luminous flux of one or more light source(s) or light source module(s) for a dipped beam exceeds 2,000 lumens)
• Replace the term “LED module” with “Light source module” and modify wording to adapt to the introduction of “matched pair” requirements for headlamps and AFS
• Align the requirements for off-road vehicles passing-beam vertical inclination between the 06, 07, 08 series and the 09 series of amendments to UN R48
Allow the projection of a pattern for predicted trajectory
• Amend failure detection and signalisation requirements to reflect technological progress in multiple light sources.

Proposal to introduce provisions to enable the approval of reversing light projections.

Proposal is to define common rules while leaving the choice to
countries to adopt them or not. These rules must in particular make it possible to
automatically cut off the work lamps in circulation to avoid glare and make traffic
safer

In order to harmonise requirements among different installation Regulations, the SLR Officers offered to draft a proposal for Reg. 48 to clarify that devices not allowed in the Regulation are prohibited (in line with Par. 5.17. of Reg. 53).

TF AVSR Comments on document ECE/TRANS/WP.29/GRE/2023/9/Rev.3

Proposal to clarify that only light-signalling devices may incorporate an illuminated logo.

Proposal to require a minimum of 50% of the apparent surface of the rear direction-indicator lamps (category 2a or 2b) to be more than 25mm from the stop lamp.

Proposal prepared by the experts from the Task Force on Automated Vehicle Signalling Requirements (TF AVSR). Proposal aim to introduce vehicles with a driving system, which controls its operation or may be operated by driver support features or automated driving features or by an Automated Driving System (ADS).

Proposal aims to amend failure detection and signalisation requirements to reflect technological progress in multiple light sources. This amendment proposes to include in UN Regulation No. 149 different provisions allowing that a failure signal is only triggered when a significant change in the beam is detected and ensuring that the most suitable failure provision can be applied. Proposal for a Supplement to the 06, 07, 08 and 09 series of amendments to UN Regulation No. 48

Proposal with the aim to allow the projection of a pattern for predicted trajectory.

Proposal is to define common rules while leaving the choice to countries to adopt them or not. These rules must in particular make it possible to automatically cut off the work lamps in circulation to avoid glare and make traffic safer.