Proposed revisions to the CLEPA to introduce into Regulations Nos. 67 and 110 type approval provisions for “valve control at stop-start”. The CLEPA proposal would allow the tank valves to stay open in an active stop-start phase for CNG/LPG with stop-start engines.

Comments on the proposed guidelines for advanced driver-assistance systems (lane-change, hazard, collision, etc.).

Proposal to delete the unintended duplication of generic automatic functions in the table concerning specific automatic functions.

This document aims at improving the transitional provisions of the 03 series of amendments to Regulation No. 46, including: Provisions for extensions to approvals to the 03 series of amendments for devices, provision for approval of devices to the 02 series, and provisions for aftermarket.

This document aims at improving the transitional provisions of the 04 series of amendments to Regulation No. 46, including: Provisions for extensions to approvals to the 04 series of amendments for devices, provision for approval of devices to the 02 series, and provisions for aftermarket. It assumes approval of document GRSG-104-25 on 03 series transition provisions.

OICA report on behalf of the ISO group working on camera-monitor systems. ISO 16505 specifies minimum safety, ergonomic and performance requirements for camera-monitor systems as an alternative to the currently mandatory inside and outside mirrors for road vehicles.

Proposal to clarify the wording of the original proposal to prevent accidents when the flap covering the engine compartment is open by specifying that the provisions concern only the main engine access panel.

Proposal to improve the wording without changing the intent of the original proposal to amend the requirements for the minimum number of priority seats: four in Class I, two in Class II and Class III and one in Class A and Class B and disallowing the priority designation for folding seats.

Proposal to add transitional provisions to ensure the validity of the preceding series of amendments to UN R107 for vehicles not impacted by the 05 series (mandating temperature alarm systems in certain bus compartments not directly visible to bus occupants).

OICA raises a series of questions concerning the Japanese proposal (document GRSG/2013/5) to add field-of-vision provisions to enhance the safety of pedestrians and other vulnerable road users in narrow alleys and by-streets and other improvements to Regulation No. 46.

Proposal to clarify that the 04 series of amendments (adopted document WP.29/2012/87) addresses only vehicles with a high cab.

Proposal to align the definition of the “driver’s ocular points” with that of Regulation No. 125 (forward vision) as also used in EC Directive 2003/97/EC as amended by Directive 2005/27/EC. The proposal concerns the ocular points used to check compliance with the required field of vision provided by the rear-view mirrors.

OICA counter-proposal to the German proposal (document GRSG/2013/27) to introduce more stringent requirements for rear underrun protection devices.

Proposal to adapt the provisions for multi-function displays to technological progress. In principle, current displays can convey more information to the driver, including levels of severity or importance, while the current text was written when technologies were less flexible. As a result, the current provisions risk impeding the use of beneficial multi-function tell-tales.

Proposal developed by the GRSG chair, OICA, and the UK to align the transitional provisions of the 01 series of amendments to UN Regulation No. 121 (document WP.29/2012/30, presently pending before WP.29 and awaiting parallel amendments from the GRRF for UN R13 and 13-H) with those of UN R13 and 13-H.

Proposal to replace in paragraph 6.2.6. of UN Regulation No. 118, the obsolete reference to the cable test according to paragraph 12. of ISO 6722 with the correct reference to paragraph 5.22. of ISO 6722-1:2011.

Proposal to clarify that an “overnight locking system” referred to in the proposed amendment to paragraph 2.41 is not one intended to be operated by passengers from inside the vehicle.

Proposal to modify document GRSG/2014/5 which would amend the current transitional provisions of UN Regulation No. 107in order to ensure the validity of the preceding series of amendments to UN R107 for vehicles not impacted by the 05 series (mandating temperature alarm systems in certain bus compartments not directly visible to bus occupants). This proposal would change the proposed language in order to clarify that vehicles not affected by the 05 Series of amendments can continue to be approved with no modification to their markings, and that extensions to the approvals for these vehicles can continue to be granted.

Presentation concerning the asynchronous use of an indicator space for communicating information to the driver. The presentation explains the concept of this “common space” that two or more symbols may share but only use one at a time. The presentation proposes that two or more symbols might be displayed sequentially in the same common space (i.e., alternately flashing symbols).

OICA comments on the proposal to introduce fire suppression systems for buses and coaches upon detection of fire in the engine and/or heater compartment (document GRSG/2014/6).

UN R116 specifies operating voltages and voltage limits. Current technology and intelligent battery management systems allow for precise control and definition of these parameters. This includes “intelligent” operating ranges in order to optimize energy management (CO2 emission reduction). Fixed operating voltage ranges are therefore unnecessary or even may hinder efforts for CO2 emission reduction in the future. OICA proposes language to modify the design-restrictive language.

Paragraph 5.3.1. refers to Appendix 8 of Annex 1. OICA believes that the reference should be to Appendix 10 of Annex 1 and so proposes this correction.

The draft 03 series of amendments follows current UN guidelines for regulatory texts (document WP29/1044/Rev.1); however, a new version of the guidelines which uses a different phrasing for transitional provisions will soon be adopted. Therefore, OICA proposes using the new wording in the draft 03 series.

More detailed explanation of the proposal (document GRSG/2014/24) to update the reference to ISO 6722 in the cable test (i.e. replace the reference to “IS0 6722 paragraph 12” with a reference to “ISO 6722-1:2011 paragraph 5.22”).

Proposal to correct the calculation of total mass under the draft 05 and 06 series amendments intended to align Annex 11 of UN R107 with Regulation (EU) 1230/2012 (i.e., the amendments proposed in document GRSG/2014/22).

Proposal to modify the draft amendment to UN R39 that would introduce odometer requirements (document GRSG/2014/32). OICA proposes to change the definition of “odometer” to refer to the distance recorded rather than traveled and to delete the definition of “technical constant of the odometer”.

OICA and CLEPA comments on the Korean proposal to amend GTR No. 6 and UN Regulation No. 43 in response to issues identified in its defect investigation concerning panoramic sunroofs.

This proposal aims to clarify that surveillance mirrors can be mounted below 2 meters from the ground when integrated in a housing including one or several mirrors of classes II or III.

Document GRSG/2015/8 proposes to amend the provisions on forward field of vision of drivers in UN R125 to promote and to support the installation of camera-monitor devices on vehicles of category M1. This proposal would clarify that the amendment only applies to regulated devices for indirect vision.

Document GRSG/2015/9 would amend the provisions of UN R10 on electromagnetic compatibility to include camera-monitor devices newly defined under UN R46. This proposal aims to clarify that the amendment applies only to regulated devices for indirect vision (UN R46) so as not to be confused with other devices for indirect vision already included within the scope of UN R10.

Proposal to amend document GRSG/2015/17 which would introduce higher stringency levels for rear underrun protection devices.

Proposal to correct certain omissions in the text and to simplify the transitional provisions proposed in document GRSG/2015/17 which would increase the stringency of the rear underrun protection device requirements.

Proposal to enable the use of autonomous CNG heaters for the heating of engines before the vehicle is in service.

OICA comments expressing opposition to the proposed measures to combat odometer fraud in the used vehicle market.

OICA concerns regarding the proposal to introduce fire suppression systems for buses and coaches upon detection of fire in the engine and/or heater compartment (document GRSG/2014/6/Rev.1).

Proposal developed by the IWVTA informal group to highlight concerns over the ambiguity of Regulation No. 116, especially with regard to whether the installation of vehicle immobilizer systems is mandatory. IWVTA is requesting WP.29 for clarification and resolution of the ambiguous provisions and interpretations.

Revised approach to resolving the issues raised in Romania’s proposal GRSG/2015/21 to redefine the measurement criteria for determining appropriate seat spacing. This proposal has been developed collaboratively by Romania, OICA, and CCLCR with respect to discussions held by the type approval authorities of the member states of the European Union (TAAM). The proposal includes the use of a new testing gauge for the H dimension measurement.

Presentation of issues raised during discussions of the GRE Task Force on EMC requirements with regard to the application of several UN Regulations to trolley buses depending upon their configuration (e.g., dual-mode operation either connected to overhead cables or in standard bus mode).

Proposal to clarify paragraph 7.7.5.1. with regard to ceiling-mounted displays or monitors and simplify the testing procedure:

• The gauge shall be used only for the identification of the monitors to be tested.
• The simplified way to apply the removal force corresponds to a passenger pushing the monitor/display with its hand, and in these conditions the acceptable force limit is adapted.
• The test must be conducted in both directions.
• The proposed wording for the last condition to fulfil is more technology neutral, the case of automatic redeployment is also considered and banned.

Proposal to correct a cross-referencing error introduced in paragraph 7.7.9.1. of Annex 3 to Regulation 107 concerning textual markings (safety signs).

Proposal to delete the inclusion of the 75kg mass of a crew member from the definition of the mass of buses and coaches equipped with a crew member seat in order to align UN R107 with the definitions used in European Commission Regulation (EU) No. 1230/2012.

The 01 series of amendments inserted a new paragraph 5.1 and renumbered the subsequent paragraphs. This proposal corrects an oversight by updating a reference to paragraph 5.3 to 5.4 in the footnote under paragraph 2.5.

The text of the German proposal (document GRSG/2016/21) in the tables in annexes 14 and 16 only refers to small windows as “windows into which a circle of diameter D < 150 mm is capable of being scribed”. OICA proposes to add the criterion of a maximum area limited to 200 cm² in order to align with the definition in paragraph 2.39 (“pane having an area of less than 200 cm² and within which it is not possible to inscribe a circle having a diameter of 150 mm”).

Proposal to align UN R121 with ISO 2575 per ISO Resolution 664 allowing for use of the diesel engine glow plug symbol with non-diesel technologies that (also) assist engine starting at low temperatures. he current text of the Regulation focuses on diesel engine glow plugs that assist in starting the engine at low temperatures.

Proposal to introduce requirements for Automatic Emergency Call Component (AECC) approvals that can be integrated into Automatic Emergency Call Device (AECS) approvals and/or Automatic Emergency Call Device installation approvals (Installation of AECD) under the new AECS Regulation.

At its fifty-ninth session, GRSP approved a proposal for the 07 series of amendments to UN R16 ( (GRSP/2016/2 and GRSP/59, page 24) to mandate safety belt reminders for all vehicle seats. This proposal aligns provisions in UN R121 with the changes to UN R16:
a) the term “seat belt” is replaced by “safety belt”,
b) the symbol for safety belt, defined in item 21 of Table 1 in the Regulation, may be displayed in different colours to convey different meanings. Therefore, the existing footnote ¹⁸ has been added to item 21, and
c) this symbol may be replaced by different symbols for seats other than those of the front row. Therefore, a new footnote ²² is added to item 21.

Paragraph 5.1.5. is modified and paragraph 5.1.7. introduced to take into consideration the strict content of GRSP/59, page 24, paragraphs 8.4.3.2.1. and 8.4.4. on safety-belt reminder for occupants of rear seat row(s). This proposal does not change any of the technical requirements of UN R121.

Overview of AECS, the draft regulation, and possible next steps.

Proposal to align UN R121 with the 07 series of amendments to UN Regulation No. 16:

1. the term “seat belt” is replaced by “safety belt”,
2. the symbol for safety belt, defined in item 21 of Table 1 in the Regulation, may be displayed in different colours to convey different meanings. Therefore, the existing footnote 18 has been added to item 21, and
3. this symbol may be replaced by different symbols for seats other than those of the front row. Therefore, a new footnote 22 is added to item 21.

Proposal to clarify that in the case where telltale No. 1 (Master lighting switch) and telltale No. 19 (Position, side marker, and/or end-outline marker lamps) are combined, the symbol may be shown in other colours than specified in the table of telltales in order to convey different meanings according to the general colour coding as proposed in paragraph 5. of ISO 2575-2004 (i.e., per footnote 18 to the table).

Proposal to clarify provisions concerning protection of the fuel tank in the event of vehicle collision in connection with the proposal by France in document GRSG-112-09 to align the French translation with the English original. The intent is to clarify the prohibition against the presence of elements likely to cause damage to the installed tank in the event of a collision rather than to the installation of the tank per se.