Proposal of corrections to document GRSG/2016/7. The wording of the original proposal opens the possible interpretation that the regulation allows materials other than copper, stainless steel, or steel with corrosion-resistant coatings for gas tubes. The intention of the proposal was only to allow for “non-seamless” gas tubing. The original proposal is therefore modified to allow Class 0/I hoses with couplings using gas tubes of other than seamless material.

Editorial amendment to document GRSG/2016/8 for clarity. The original proposal would allow the use of Class 0 hoses with couplings using sealing technologies other than those with a 45° cone provided that the hose assembly can withstand the impulse test of paragraph 1.7. and the tests of Annexes 5A (overpressure test) and 5B (external leakage test). This proposal clarifies that the original sealing-cone specification or other compliant couplings, including designs with soft seals (e.g., O-ring) provided they pass testing described in Annexes 5D, 5F, and 5G.

Proposal from the informal working group on the International Whole Vehicle Type Approval to restructure UN R116 into two separate regulations. The regulation addresses anti-theft, alarm, and immobilizer aspects of theft prevention. Since these aspects may be mandatory or optional depending upon the country or market, the application of UN R116 to whole vehicle type approval becomes problematic. This proposal would extract the immobilizer provisions into a separate new regulation.

Proposal to change the latency for scanning a field of vision (total process of scanning, rendering and reset to its initial position) from a maximum of 2 seconds to a maximum of 200 ms. This proposal corresponds to the current state of technology and removes a contradiction within the regulation between paragraphs 6.2.1.2. and 6.2.2.3.4.3. (the latter introduced via supplement 2 to the 04 series of amendments).

Copy of the proposal by Poland to amend UN R55 to ensure that coupling devices are only approved for use on vehicles approved for towing trailers.

Draft proposal to introduce amendments on a procedure to dimension coupling equipment for heavy transports through speed reduction.

Draft proposal to introduce amendments on a procedure to dimension coupling equipment for heavy transports through speed reduction.

Proposal to introduce a procedure to identify allowable combinations of performance values DC and V for drawbar coupling equipment.

Presentation of issues raised during discussions of the GRE Task Force on EMC requirements with regard to the application of several UN Regulations to trolley buses depending upon their configuration (e.g., dual-mode operation either connected to overhead cables or in standard bus mode).

Proposal to amend GRSG/2015/36 introducing requirements for the operation of a CNG heater when the vehicle is stationary and before starting the engine. The limitation on the number of valves used to operate the CNG combustion heater will require technical changes without any significant benefit. The proposal therefore deletes the limitation and introduces additional clarifications.

Presentation on blind-spot accident data and work on the development of a test cycle to assess the effectiveness of blind-spot countermeasures to reduce the risk of VRU collisions.

Working draft amendment to UN R55 to introduce:

• An amendment that concerns a separation of requirement calculation procedures from the procedure of setting and certifying performance values.
• An amendment that adds procedures for requirement calculation for vehicle combinations that have hitherto not been accounted for in the regulation.

UN R55 informal group working draft to introduce:

• Correction error in annex 5 figure 12 and 17
• An amendment that concerns identification of worst cases for design assessment
• Clarifications on minimum articulation angles.