Draft proposal for minimum sound requirements (via an audible alerting signal) for low noise vehicles (e.g., electric vehicles).

The purpose of this proposal is to update the reference to the latest version of the ISO 10844 and to introduce transitional provisions for the shift of the test track requirements from ISO 10844: 1994 to ISO 10844: 2014. This proposal supersedes document GRB/2015/5.

Proposal to update and clarify the text of UN R28.

In response to concerns that approval agencies may not grant manufacturers the additional 1dB for L(wot) on conformity of production tests as changes had been made to Annex 6 of R41-04, GRB issued an interpretation recorded in the report of its 56th session. However, IMMA believes that industry and agency personnel may still not be aware of the interpretation. Therefore, IMMA proposes to codify the interpretation within UN R41.

Pursuant to the introduction of the deceleration method for measuring tire rolling resistance using the dω/dt approach (“Deceleration Calculator”) proposed by NAMI and accepted by GRB, UTAC (France) provides information on the results of tests conducted to confirm repeatability and reproducibility of the new method using different machines.

Proposal to correct the Annex 7, paragraph 3.1. “Determination of the anchor point for each gear ratio” and a calculation symbol in paragraph 3.2.1 “Calculation of the slope of the regression line for each gear”.

Proposal from Japan, pursuant to the discussion of document GRB/2014/8 during the previous GRB session, to correct perceived inconsistencies in time measurement accuracy in annex 6.

Presentation of the benefits envisioned by the Netherlands from the use of AAA tyres.

Proposal to update the test-track references to the recently published ISO 10844:2014.

Update on Russian developments and perspectives regarding the regulation of vehicle interior noise levels.

This document contains the consolidated text of proposals for the 03 series of
amendments to Regulation No. 51, as adopted by GRB at its sixtieth and sixty-first
sessions:
- ECE/TRANS/WP.29/GRB/58, para. 5, based on ECE/TRANS/WP.29/GRB/2014/5,
as amended by Annex III to ECE/TRANS/WP.29/GRB/58;1 and
- ECE/TRANS/WP.29/GRB/59, paras. 8-10, based on ECE/TRANS/WP.29/GRB/2015/3 and Corr.1, as amended by Annex III to ECE/TRANS/WP.29/GRB/59.

Following a decision of GRB, this consolidated text will be submitted to the June
2015 session of WP.29 for consideration and possible adoption.

Proposal to update and clarify the regulation. The proposal refines definitions, removes the “AWD” abbeviation for “audible warning device” to avoid confusion with its more common use for “all wheel drive”, adds T category agricultural vehicles to the scope, modifies some administrative communications, and proposes three-direction acoustic measurements.

In response to concerns that approval agencies may not grant manufacturers the additional 1dB for L(wot) on conformity of production tests as changes had been made to Annex 6 of R41-04, GRB issued an interpretation recorded in the report of its 56th session. The proposal formalizes the interpretation as an explicit provision of the regulation.

WBU and European Blind Union statement critical of the current draft UN Regulation for failing to adequately address the needs of the visually impaired.

Presentation on low-noise pavements and the PERSUADE (PoroElastic Road
SUrface for Avoiding Damage to the Environment) project.

Presentation of Japan’s plans for phasing in UN R41, UN R51 (Phase 2, but not Phase 3 limits), and UN R117 requirements.

Presentation on Japanese vehicle noise activities, including alignment with UN Regulations and subsequent abolition of certain current Japanese regulatory requirements (e.g. cruising noise, etc.).

Presentation on China’s international noise standards working group activities and program for future development of vehicle noise and silencing system durability requirements.

ETRTO comments raising concerns over the validity of the Dutch dataset used to support the proposal for higher tyre-noise stringency.

Presentation in support of the proposal to increase the stringency of tyre noise limits from 1 November 2020.

Proposal to increase the stringency of tyre noise limits from 1 November 2020.

Proposal to clarify the wording of the 03 series of amendments to UN R51 as adopted by the World Forum in June 2015 (document WP.29/2015/62). The adopted wording could lead to the interpretation that sound levels measured on the left side of the vehicle are mixed by calculation with sound levels measured on the right side of the vehicle. The proposed new wording clarifies that the overall sound emission is assessed individually per vehicle side.

The current text of UN R41 provides an allowance that increases the noise limit value by 1 dB(A) for motorcycles tested only in second gear under Annex 3. This allowance expires on 1 January 2017. IMMA proposes to extend this allowance until 1 January 2018 in response to the delayed implementation of UN R41-04 in the EU (2016 instead of planned 2014).

Comments on the draft Supplement 5 to the UN R28. The draft supplement aims to refine definitions, removes the “AWD” abbeviation for “audible warning device” to avoid confusion with its more common use for “all wheel drive”, adds T category agricultural vehicles to the scope, modifies some administrative communications, and proposes three-direction acoustic measurements.

Proposal for corrections to the draft Supplement 5 to the regulation. The draft supplement aims to refine definitions, removes the “AWD” abbeviation for “audible warning device” to avoid confusion with its more common use for “all wheel drive”, adds T category agricultural vehicles to the scope, modifies some administrative communications, and proposes three-direction acoustic measurements.

At the GRB meeting in January 2015 the Netherlands introduced a justification and proposal for future tyre noise limits (document GRB-61-03). During the discussion, it was suggested to investigate whether difference in performance existed between Original Equipment Manufacturer (OEM) tyres and replacement tyres, noting that the transitional provisions in EC/661/2009 take into account the earlier introduction of noise limits of OEM tyres mounted on new vehicle types. Therefore, the Dutch Ministry of Infrastructure and the Environment asked M+P to investigate the statistics of tyre noise label values in OEM tyres in more detail.

Table of potential areas for future GRB work prepared during an informal meeting held in Paris during 2-3 July 2015.

Proposal to specify that conditioning of exhaust or silencing systems is required only in cases where the fibrous materials are in contact with exhaust gases because there is no possibility for the dispersion of fibrous materials under any other condition.

Correction of two minor reference errors contained in the proposal for Supplement 2 to the 04 series of amendments to Regulation No. 41 which was adopted during the March 2015 session of WP.29.

Proposal to amend the draft Supplement 5 to the UN R28. The draft supplement aims to refine definitions, removes the “AWD” abbeviation for “audible warning device” to avoid confusion with its more common use for “all wheel drive”, adds T category agricultural vehicles to the scope, modifies some administrative communications, and proposes three-direction acoustic measurements.

Presentation by Dr. Edward C. Bell, Professional Development and Research Institute on Blindness, Louisiana Tech University.

Paper describing the development and application of a method for determining benefits of tyre noise reduction efforts in terms of the number of people impacted.

Presentation on the Dutch-developed methodology for assessing the impact of changes to tyre and vehicle noise standards.

GRB-62 post-session review of future noise regulation development based upon the results of the GRB Informal meeting held in Paris during 2-3 July 2015.

Proposal to update and clarify the regulation. The proposal refines definitions, removes the “AWD” abbeviation for “audible warning device” to avoid confusion with its more common use for “all wheel drive”, adds T category agricultural vehicles to the scope, modifies some administrative communications, and proposes three-direction acoustic measurements. The proposal also aims to structure the regulation to enable its application to additional sound warning devices not presently regulated at the international level, excluding acoustic vehicle alerting systems (AVAS) which will be subject to a separate regulation on minimum vehicle sound levels.