Proposal to correct cross-references in UN R73. The document amends paragraphs 12.1, 15.1, and Annex 3 paragraph 2.4 to correct invalid or non-existent paragraph references. Changes include updating references from paragraphs 12.4.4 and 15.2.4 to 12.4.2/3 and 15.2.2/3 respectively, and replacing the non-existent paragraph 2.8 reference with paragraph 12.10. The corrections do not increase requirement stringency.

Proposal to correct cross-references in UN R73. The amendments modify paragraphs 12.1, 15.1, and Annex 3, paragraph 2.4 to replace incorrect paragraph citations with accurate ones. The corrections address invalid references that do not exist or lack contextual relevance. The changes do not increase requirement stringency.

Proposal to extend the mandate of the DDADWS informal group until October 2028 to enable development of new (01) series of amendments to the original texts of the driver drowsiness and driver distraction warning systems regulations.

The initial regulations for Driver Drowsiness and Attention Warning and Advanced Driver Distraction Warning systems were adopted at GRSG-130 and WP.29-198. DDADWS is developing 01 series regulations, with workshops and online meetings planned. The group seeks a mandate extension to October 2028 to complete 01 series development, with proposed submission for approval to GRSG-136.

Proposal to align requirements across different series of amendments to UN R46, and to harmonize requirements for components inside and outside the vehicle with those of UN R26 and UN R61. For detailed explanations, see the TF UN-R46 report (GRSG-130-32) distributed at the 130th GRSG session.

Proposal to align requirements across different series of amendments to UN R46, and to harmonize requirements for components inside and outside the vehicle with those of UN R26 and UN R61. For detailed explanations, see the TF UN-R46 report (GRSG-130-32) distributed at the 130th GRSG session.

Proposal to align requirements across different series of amendments to UN R46, and to harmonize requirements for components inside and outside the vehicle with those of UN R26 and UN R61. For detailed explanations, see the TF UN-R46 report (GRSG-130-32) distributed at the 130th GRSG session.

Proposal to align requirements across different series of amendments to UN R46, and to harmonize requirements for components inside and outside the vehicle with those of UN R26 and UN R61. For detailed explanations, see the TF UN-R46 report (GRSG-130-32) distributed at the 130th GRSG session.

Proposal to clarify:

1. The allowed obstruction for devices of Class II, III and VIII,
2. The definition of the external original surface and the position of the cylinder,
3. The usage of indicators and overlays in the required field of vision
4. Protruding supports and their possible interference with the pendulum, and
5. Make corrections to figures.

Proposal to amend UN R167 to address Automated Driving Systems (ADS), exempting category Y vehicles and category X vehicles without a manual on-board mode from the regulation’s scope, while requiring ADS-equipped vehicles to comply when operated manually. Additional amendments update references to the three-dimensional H-point machine per Mutual Resolution No. 1, and revise approval marking provisions to remove the Unique Identifier option.

Proposal to resolve a longstanding inconsistency in UN R125 between the lower datum point (§5.1.1.3, set at 5°) and the obstruction requirement (§5.1.3, set at 4°), by aligning the lower datum point to 4° while retaining upper and lateral aspects of §5.1.1. unchanged. The 5° datum point has never been used for any technical requirements beyond serving as a reference point, while the 4° obstruction requirement has prior precedent. As this is a vehicle rather than component requirement, the datum point is also proposed for deletion from UN R43, retaining it solely in UN R125.

Proposal to align UN R43 with a proposed amendment to UN R125 (ECE/TRANS/WP.29/GRSG/2026/23), which resolves a longstanding inconsistency between the lower datum point definition (§5.1.1.3) and the obstruction requirement (§5.1.3) by harmonizing the lower datum point angle from 5° to 4°.

Proposal from the GRSG task force on Automated Vehicles Regulatory Screening to exempt ADS vehicles of subcategories X and Y from the requirements of UN R176.

Proposal to clarify that ocular reference point adjustment applies only to back angle, and to reference the original version of UN R166 to prevent future ambiguity should Annex and paragraph numbering change in subsequent amendments.

Proposal to clarify that transparency requirements under UN R43 apply in both directions (exterior to interior and interior to exterior), addressing the growing use of privacy foils on windscreens and front side windows post-registration, which raises safety concerns regarding driver eye-contact, law enforcement visibility, and driving behaviour enforcement, consistent with the position expressed by GRSG at its 130th session.

Proposal to remove subjectivity and clarify manufacturer requirements for demonstrating equally effective triggering performance in vehicles with a maximum mass between 8,000 and 12,000 kg.

Proposal to align requirements across different series of amendments to UN R46, and to harmonize requirements for components inside and outside the vehicle with those of UN R26 and UN R61. For detailed explanations, see the TF UN-R46 report (GRSG-130-32) distributed at the 130th GRSG session.

Proposal to exempt vehicles of subcategories X and Y (ADS vehicles) from the requirements on UN R167 and to delete the provisions for Unique Identifier markings.

Proposal from the GRSG task force on Automated Vehicles Regulation Screening to enable application of UN R166 to ADS vehicles, including the exemption of ADS vehicles of subcategories X and Y from the requirements of the Regulation.