Editorial improvements to the text and introduction of provisions allowing for the separation of connectors (including the vehicle inlet) without the use of tools under prescribed conditions.

Editorial improvements to the text and introduction of provisions allowing for the separation of connectors (including the vehicle inlet) without the use of tools under prescribed conditions.

Request for clarifications on the application of relaxation areas under UN Regulation No. 127.

Japan is developing national legislation to prescribe requirements for the body, hydrogen storage containers and their specific components, batteries etc. of hydrogen fuel-cell powered motorcycles.

Request for clarification of test procedures for active pedestrian protection devices (such as active hood, pedestrian airbag).

Updated presentation showing relative risks of injuries within and outside the proposed bumper test area and comparing late-model (post-2006) cars against earlier models based upon GIDAS data.

Proposal to amend the toxicity and flammability declarations via references to EN71 (European safety standards).

Proposal to include “MFP” in the labeling requirement for hydrogen containers. MFP refers to the maximum allowable container pressure under normal use.

Presentation on occupant protection tests of selected L7 category vehicles (e.g., very light, limited maximum speed road vehicles that do not require a driver’s license to operate).

Question and answer brochure on the i-size child restraint systems regulation.

Report on the phase 2 development (regarding universal booster seats and cushions) of UN Regulation No. 129.

Proposal to exclude “bucket seats” from the ISOFIX requirements as well as vehicles with only one seating position (by applying the regulation only to vehicles with more than one seating position). The proposal also exempts certain vehicle/seating configurations from ISOFIX requirements, addressing cases where the vehicle design and purpose mitigate against the use of such child restraints and ISOFIX systems.

Proposal from the Bumper Test Area Task Force, pursuant to discussions within GRSP, to revise the procedure for determining the bumper test area under the pedestrian safety regulation. This proposal corrects shortcomings in the current definitions which could lead to a narrower test area than intended (leading to less effective pedestrian protection). This proposal does not take into account potentially harmful hard structures such as bumper beams that may lie behind the outer contour or front fascia extending beyond the defined bumper corners as consensus within the task force could not be reached. Presented as a Supplement, the proposal includes a September 2017 transition date in case GRSP determines that the changes should be put into a new series of amendments rather than as a supplement.

Proposal from the Bumper Test Area Task Force, pursuant to discussions within GRSP, submitted as an alternative to the proposal in document GRSP/2014/31 as amended by document GRSP-56-40, to revise the procedure for determining the bumper test area under the pedestrian safety regulation. This proposal corrects shortcomings in the current definitions which could lead to a narrower test area than intended (leading to less effective pedestrian protection). This proposal includes a “bumper beam” determination method. The proposal also includes a September 2017 transition date in the event that the GRSP determines that the proposal should be treated as a new series of amendments rather than as a Supplement.

Fact sheet on UN R129 including comparison with UN R44.

Proposal to prohibit the use of Y-shaped belt on forward-facing child restraint system. This proposal aligns UN R129 with provisions already in UN R44.

The scope of the new Global Technical Regulation on Pole Side Impact includes vehicles of category N1 (limited to GVM < 3.5 t) and vehicles of category M1 (without mass limit). However, the vehicle fleet includes a small number of M1 vehicles with a GVW > 3.5t which are based on vehicles of category N2, N3, M2 or M3. Based on the OICA proposal (document GRSP-56-12) and ensuing discussions, Australia proposes to limit the scope of the GTR to both M1 vehicles under 3.5 t maximum vehicle mass and to certain N1 vehicles based on geometric measurements.

Thorax compression criterion (ThCC) under the draft new regulation on frontal impact protection and occupant restraint systems.

Proposal from the Bumper Test Area Task Force to revise the procedure for determining the bumper test area under the pedestrian safety regulation. This proposal corrects shortcomings in the current definitions which could lead to a narrower test area than intended (leading to less effective pedestrian protection). This proposal does not take into account potentially harmful hard structures such as bumper beams that may lie behind the outer contour or front fascia extending beyond the defined bumper corners as consensus within the task force could not be reached.

Proposal from the Bumper Test Area Task Force, submitted as an alternative to the proposal in document GRSP/2014/17 as amended by document GRSP-56-38, to revise the procedure for determining the bumper test area under the pedestrian safety regulation. This proposal corrects shortcomings in the current definitions which could lead to a narrower test area than intended (leading to less effective pedestrian protection). This proposal includes a “bumper beam” determination method.