Explanation of three options developed for handling the approval of electronic stability controls (ESC) and brake-assist systems (BAS) under regulaitons separate from UN R13-H (light vehicle braking) while fulfilling the requirements of complex electronic systems (CEL).

Proposed corrections and clarifications to the draft text of the new regulation to separate ESC provisions from Regulation No. 13-H (document GRRF/2014/12).

India noted an erroneous reference to “ESC” in the original document where “BAS” was clearly intended.

Actions and decisions taken during the 9th session of the expert group amending the 1958 Agreement in order to accommodate the proposed international whole vehicle type approval system.

Latest version (superceding WP.29/2014/26) of the revision of the 1958 Agreement to enable the deployment of the International Whole Vehicle Type Approval system and to facilitate the global application of the Agreement and its system for the mutual recognition of type approvals. This version proposes solutions to all the remaining open issues except the question of two-thirds voting raised as a measure to address concerns of non-EU governments over the current simple majority procedure.

Proposal to amend the draft text for the proposed new regulation on BAS which would extract the BAS provisions from the current UN R13-H on light vehicle braking systems. The intention is to clarify the meaning of the text in places where it is ambiguous when taken out of the context of UN R13-H.

Transmitted by the experts of the subgroup on UN R0 pursuant to their 9th session held during 21-22 January 2014 (Document SGR0-08-13-rev.1).

Proposed amendments to UN R13-H to confirm that the complex electronic control system (CEL) requirements may be satisfied through an approval conducted under another regulation (e.g., the pending new ESC and BAS regulations) and to delete the marking requirement concerning ESC systems which will no longer be within the scope of UN R13-H.

Proposal to specify that safety aspects of brake assist systems can be assessed under this new regulation or under UN R13-H. The objective of the proposed wording is to avoid redundant certification of the complex electronic control systems (CEL) aspects of ESC according to both the proposed BAS regulation and UN Regulation No. 13-H (keeping unchanged the level of safety). The proposal would permit the applicant to show evidence that CEL compliance has already been achieved according to Annex 8 of UN Regulation No. 13-H as an alternative to demonstrating compliance with the CEL annex of the BAS regulation.

Proposal to specify that safety aspects of ESC systems can be assessed under this new regulation or under UN R13-H. The objective of the proposed wording is to avoid redundant certification of the complex electronic control systems (CEL) aspects of ESC according to both the proposed ESC regulation and UN Regulation No. 13-H (keeping unchanged the level of safety). The proposal would permit the applicant to show evidence that CEL compliance has already been achieved according to Annex 8 of UN Regulation No. 13-H as an alternative to demonstrating compliance with the CEL annex of the ESC regulation.

Proposal from the Netherlands for editorial improvements and clarifications to the draft text of Schedule 7 concerning exemptions from UN Regulation provisions where warranted for new technologies.

Australia and the UK propose:

• New text for Article 4 (rights and obligations in cases of a non-conforming approval to a UN regulation), particularly to clarify the terminology used (threat to road safety or to the environment….) and to strengthen the provisions;
• New text in Schedule 7, Section 5 to allow the granting of individual “exemption approvals” without committing Contracting Parties to accept such approvals within their own market;
• Changes to Article 3 to clarify that the acceptance of a UN regulation that has been applied is also subject to it meeting any discretionary options allowed for within the regulation;
• Changes to Article 8 so that approvals issued by a CP automatically cease to be valid after a defined period should the CP withdraw from the Agreement; and
• UK acceptance of text proposed by Australia to address CP’s that do not have approval authorities.

Comments from Australia and the UK on the draft “Proposal for Revision 3 of the 1958 Agreement”.

Agenda for the ninth session of the expert group preparing revisions to the 1958 Agreement as part of the program to establish an international whole vehicle type approval system.

Updated revised draft proposal to amend Schedule 7 for the procedure to allow for the exemption of new technologies from relevant existing regulatory requirements in cases where those existing requirements present incompatible, inapplicable, and/or unwarranted burdens.

Revised draft proposal to amend Schedule 7 for the procedure to allow for the exemption of new technologies from relevant existing regulatory requirements in cases where those existing requirements present incompatible, inapplicable, and/or unwarranted burdens.

Proposal to clarify the marking provisions under the whole vehicle type approval system.

Comments and recommendations from Russia for clarifications and improvements to the latest draft versions of the proposed UN Regulation No. 0 on whole vehicle type approvals (documents SGR0-08-13 and SGR0-09-01.

Comments on the draft text of UN Regulation No. 0 to clarify the conditions under which whole vehicle type approvals (including the limited approvals under partial sets or earlier versions of UN Regulations) would be recognized and to refine the text of certain provisions.

Presentation on the proposed procedures for updating UN R0. This regulation would govern the International Whole Vehicle Type Approval process and as such, would need to be updated (annually under the proposal) in line with changes to the various component or system level UN Regulations that are included within the scope of the whole vehicle type approval.

OICA-proposed revisions to the draft Q&A document intended to help explain the international whole vehicle type approval system and the proposed “UN Regulation No. 0” (document SGR0-08-06).

Proposal for wording to ensure that countries notify the UN secretariat of decisions to accept approvals based upon earlier versions of UN Regulations under the proposed International Whole Vehicle Type Approval system.