Proposal to improve the accuracy of test procedures measuring the stability of the photometric performance, including replacement of the test point HV with points 0.50U/1.5L and 0.50U/1.5R and of percentage values for the heat test at these points with an absolute value of 225 cd.

Proposal to revise the Italian proposal in order to clarify that the requirements pertain only to characteristics verifiable directly on each lamp in order to avoid confusion with characteristics that can only be verified on the vehicle after installation.

Editorial correction to the presentation of the collective amendments to selected lighting regulations proposed in document GRE/2013/55.

Recommended corrections to the proposal to clarify the definition of “type” with regard to manufacturer, trade names and marks as used in Regulations Nos. 4, 6, 7, 19, 23, 38, 45, 50, 77, 87, 91,98 ,104, 112, 113, 119 and 123.

Proposal to specify that headlamps producing only a driving beam are subject to testing of the resistance to mechanical deterioration of the plastic lens surface. The current text only specifies procedures for the passing beam.

Proposal to update the Conformity of Production (CoP) requirements and to correct provisions on bend lighting for motorcycles recently adopted by WP.29 as Supplement 2 (document WP.29/2012/83).

Proposal to improve the accuracy of test procedures measuring the stability of the photometric performance, including replacement of the test point HV with points 0.50U/1.5L and 0.50U/1.5R and of percentage values for the heat test at these points with an absolute value of 225cd.

Proposal to reference the requirements for installation contained in Regulations Nos. 48, 53, 72 and 86 into the Regulations 3, 4, 6, 7, 19, 23, 38, 50, 77, 87, 91, 98, 104, 112, 113, 119 and 123.

Proposal to clarify the definition of “type” with regard to manufacturer, trade names and marks.

Italy proposes to introduce into each Regulation dealing with the type approval of lighting or light signalling devices a direct reference to the requirements contained in Regulations 48, 53 and 74, and 86, mandating the lamp manufacturers to apply them to obtain type approvals.

IMMA correction to previously adopted GTB proposal for amendments to Regulation No. 113 on bend lighting for motorcycles subsequently adopted by WP.29 as Supplement 2 (document WP.29/2012/83).

Summary of Canada’s acceptance of certain UN Regulations in whole or in part as alternatives to the requirements of Canada Motor Vehicle Safety Standards.

Submitted by Germany in order to update the Conformity of Production (CoP) requirements.