Proposal clarify the scope and to allow for the type approval of camera-monitor systems installed in place of Class I through IV mirrors.

Proposal as approved by the GRSG during its 108th session to introduce more stringent requirements for rear underrun protection devices..

Proposal to ensure that all devices for indirect vision, including exterior cameras, are covered by UN R61.

Proposal as approved by the GRSG to delete provisions regarding the optical display of the status of the vehicle alarm system outside the passenger compartment in order to avoid driver distraction by and/or confusion of such exterior lighting with primary lighting and signaling equipment required under UN R48.

Proposal to introduce mandatory requirements for fire suppression systems for Class III buses and coaches (and optional requirements for other classes) activated upon detection of fire in the engine and/or heater compartment. This proposal also extends the treatment of rear-view mirrors to any camera-monitor systems used in place of rear-view mirrors.

Proposal to correct the numbering of chapter 18 following the introduction of provisions for automatic valves.

Proposal to regulate the discharge direction of pressure relief devices on CNG containers.

Proposal as approved by the GRSG to delete provisions regarding the optical display of the status of the vehicle alarm system outside the passenger compartment in order to avoid driver distraction by and/or confusion of such exterior lighting with primary lighting and signaling equipment required under UN R48.

Pursuant to GRPE work on vehicle propulsion system definitions (VPSD informal group; see document WP.29-165-17), this GRSP proposal would update the definition of the acronym “REESS” to refer to “rechargeable electrical energy storage system” across the passive safety regulations and currently proposed texts that make use of this acronym. (REESS had previously referred generically to “rechargeable energy storage systems”.)

Proposal to specify buckle-release color, use of buckle warning lights, and to clarify the installation provisions for “general use” safety-belts (Annex 1B, item 12).

Text prepared by the UN R44 Technical Services Group to clarify the regulation, including test failure parameters, CRS displacement or locking systems, seat installation color coding systems, and use of load limiting devices. The test procedure would be modified, including an increase in the applied load to exceed the maximum allowed resistance to permit sliding of the strap through the quick adjuster and through rigid parts, increased tolerances related thereto, deletion of the option for shorter shift (deemed unnecessary since it is a test on the strap, not on the complete component), and modification of drawings to improve consistency with the text.

Proposal to align UN R94 with the draft amendment to add camera-monitor systems to UN R46 (i.e., document WP.29/2015/84). Under UN R94, the measurement for the 40% overlap between the vehicle and crash barrier excludes external rear-view mirrors. This proposal would extend the same treatment where the mirror has been replaced by an exterior camera.

Proposal to amend the regulation frontal impacts with a view towards the establishment of a new regulation on frontal impact testing for occupant restraint systems (full width rigid barrier test). The proposal increases the thorax compression criterion (ThCC) stringency to 42 mm (from 50 mm), clarifies vehicle width definition, and amends REESS acronym definition.

Pursuant to GRPE work on vehicle propulsion system definitions (VPSD informal group; see document WP.29-165-17), this proposal would update the definition of the acronym “REESS” to refer to “rechargeable electrical energy storage system” across the passive safety regulations and currently proposed texts that make use of this acronym. (REESS had previously referred generically to “rechargeable energy storage systems”.)

Pursuant to GRPE work on vehicle propulsion system definitions (VPSD informal group; see document WP.29-165-17), this proposal would update the definition of the acronym “REESS” to refer to “rechargeable electrical energy storage system” across the passive safety regulations and currently proposed texts that make use of this acronym. (REESS had previously referred generically to “rechargeable energy storage systems”.)

Proposal from the Bumper Test Area Task Force to revise the procedure for determining the bumper test area under the pedestrian safety regulation. The proposal introduces a “bumper beam” method for determining the test area and includes a 31 December 2017 transition date.

Proposal to correct the unit of the road load coefficient b used in the formula for the calculation of the resistance to progress force.

Proposal to correct the unit of the road load coefficient b used in the formula for the calculation of the resistance to progress force.

Proposal to avoid a redundant correction of the measured engine power of supercharged and turbocharged engines fitted with a self-correcting system for ambient conditions such as temperature and altitude. The current correction factor may yield inaccurate results for such configurations.

Proposal to align the tyre-selection criteria in the CO2 emissions/fuel consumption tests under UN R101 with those for pollutant emissions (UN R83).

UN R107 includes a provision to prevent a folding seat used by the crew from obstructing the view of the exterior rear-view mirror. In light of the proposed amendment to introduce camera-monitor systems into UN R46 (indirect vision), this proposal would extend the same treatment to CMS used in the place of rear view mirrors.

Proposal to establish a new UN Regulation on uniform provisions for the approval of passenger cars with regard to their occupant-restraint system performance in the event of a frontal collision (full width rigid barrier test).

Please note: para. 5.2.8.2. should read 5 liters, not 0.5 liters maximum allowable electrolyte spillage.

Proposal to increase the stringency of the Thorax Compression Criterion (ThCC) for the Hybrid III 5th female dummy in the passenger seat to 34 mm under the proposed new regulation to test the performance of occupant restraint systems in the event of a frontal collision. The transition date would be 1 September 2020.

The purpose of this paper is to provide a framework through which the delegates to the World Forum for the Harmonization of Vehicle Regulations (WP.29) and other interested stakeholders can examine the experience with the 1998 Global Agreement and agree on ideas and processes for improvement in its implementation.

Pursuant to the addition of a new speed symbol for forestry tyres, this proposal would add a bonus loads column for A6-rated tyres to Annex 7-Part D. The proposal also corrects the tables concerning “Agricultural implement tyres – Normal section sizes”.

Proposal for a set of uniform terms and definitions to promote consistency across powertrain-related regulations.

Proposal from GRPE to provide recommendations for the minimum quality of market fuels (i.e. gasoline and diesel) that should be introduced concurrently with the corresponding emissions standards. They complement the motor vehicle and NRMM pollutant emission standards that a country or a region may be considering to introduce.

Correction to the Russian text only of the 01 series amendments to UN R94.