The document establishes procedures for demonstrating equivalence between vehicle circuit and indoor drum test facilities. It defines requirements for selecting exercise tyres and participating facilities, establishing baseline values from multiple facilities, and comparing facility results against baselines. For indoor drum facilities, transfer functions mathematically relate drum results to vehicle results, either as generic (fixed coefficient) or specific (facility-determined coefficient). Facilities must meet statistical criteria including result deviation limits and root mean square deviation thresholds to demonstrate equivalence.

Proposal to establish a list of test facilities deemed equivalent pursuant to paragraph 12.8 of the draft UN Regulation on tyre abrasion. The list recognizes six foundational facilities that participated in the initial inter-facility campaign to develop abrasion limits for C₁ tyres. The facilities are: DEKRA Test Center SA (France, circuit); IFV (Germany, circuit); Link Engineering Company GmbH (Germany, circuit); Bridgestone Corporation (Japan, indoor drum); Sumitomo Rubber Industries, LTD. (Japan, indoor drum); and The Yokohama Rubber Co., Ltd. (Japan, indoor drum). These facilities generated foundational data used to define abrasion limits and are deemed equivalent for equivalence procedures under Annex 4.

ETRTO presents its position on remaining open points for C₁ tyre abrasion limit settings, reminding positions from GRBP-82-24. Key points include: inclusion of two assessment methods; limit settings proposing approximately 23% market removal by Euro7 application timeline and additional 13.5% removal five years later; exclusion of C₁ special use tyres representing 0.7% of EU market; retention of 0.1 allowance for Extra Load tyres and tyres with nominal aspect ratio 40 suitable for speeds 300 km/h representing 7.2% of market. ETRTO views this as a challenging compromise package respecting political expectations and industry effort.

ETRTO presents a temporary conservative transfer function for tyre abrasion testing with a gain value of 1.5, designed to minimize drum inversion risk and reduce rejection risk while enabling coexistence of Indoor Drum Method and Outdoor Vehicle method at GRBP 83rd session. The transfer function, based on TA-40-2 data analysis, will be revised following a 2026 workplan before a more relevant solution in Supplement 1 to UNRxxx at GRBP 84th session.

Proposal to amend GRBP/2025/27 based on GRBP-83-32. Modifications to Annex 3 revise the abrasion index calculation methods for both vehicle test and indoor drum test methods. The abrasion margin (Amargin) is redefined in two stages accounting for evolution of measurement methods and tyre technology, with different values for normal, snow, and special use tyre categories. Amargin allowances for specific tyre groups, including severe snow conditions tyres, reinforced tyres, and tyres with nominal aspect ratio ≤40, are defined as cumulative additions to the base Amargin value.

Proposal to supersede document GRBP/2025/27 for a new UN Regulation on uniform provisions concerning the approval of tyres with regard to abrasion performance. The regulation establishes scope, definitions, application requirements, marking standards, approval procedures, and technical requirements for class C₁ tyres. It excludes temporary-use spare tyres, competition tyres, ice grip tyres, studded tyres, and certain other tyre categories. Type approval is granted if candidate tyres meet abrasion performance limits measured by one of two methods: vehicle testing on public open roads or indoor drum testing. Abrasion index limits are defined for normal, snow, and special use tyres, with adjustments for specific tyre groups. Requirements include conformity of production verification, penalties for non-conformity, and transitional provisions establishing Stage 1 and Stage 2 implementation timelines with specified dates for mandatory approval.

Proposal to ensure robust tyre abrasion measurements regardless of the test method used.

Guidance document on the Procedure for Demonstrating Equivalence of Vehicle Test and Indoor Drum Test Facilities for Tyre Abrasion and Determining the Transfer Function for Indoor Drum Test Facilities