The European Association of Automotive Suppliers (CLEPA) proposes changes to the Dutch proposal (GRSG/2011/23) that would enable the replacement of mirrors by camera monitor systems. This document is based on informal document GRSG-101-03.

CLEPA presentation of the results of its noise-emission tests on seven vehicles comparing original equipment and replacement (aftermarket) silencing systems (mufflers) under the “Additional Sound Emissions Provisions” test procedure.

CLEPA presentation on two alternatives for the application of “additional sound emission provisions” (ASEP) to replacement silencing systems.

UN R90 unintentionally omits the bedding procedure for the brake drum high load test for M2, M3, N2 and N3 vehicles. CLEPA proposes using the same bedding procedure as already adopted for the thermal fatigue test for such vehicles and for the high load tests for trailers.

The use of test reports in Regulation No.13 was first introduced in Annex 11 of UN R13 in 1984. CLEPA proposes this amendment to support the proposal to permit the use of an Annex 19 test report as an alternative method in meeting the vehicle stability function requirements as detailed in Annex 21.

Denmark submitted document GRRF-71-19 (subsequently integrated into GRRF/2012/12) proposing to narrow the compatibility bands for control line pressure versus brake rate. This document challenges the proposed changes as effectively mandating electronic braking and imposing unwarranted costs.

Denmark submitted Document GRRF-71-18 (subsequently integrated into GRRF/2012/12) proposing to narrow the limits for coupling force control systems which are allowed to override the compatibility bands. This document argues against the proposed changes.

Denmark submitted GRRF-71-19 (subsequently in GRRF/2012/12) proposing a new paragraph to require a test point between the coupling head and the trailer relay emergency valve. This document argues that the requirement is already implicit within UN R13 and therefore, that the change is unnecessary.

This document addresses the ramifications of introducing the proposals outlined in GRRF-72-07 (superceded by GRRF-72-07/Rev.1) specifically associated with semi-trailers.

Modified version of document GRRF/2011/35/Rev.1, pursuant to GRRF session 72 discussions, which aims to clarify reasonable levels of braking performance to be expected in different positions of the ignition key (i.e., off, on, lock, etc.).

Proposal to update UN R27 in accordance with technological progress by establishing provisions for the use of fluorescent retro-reflective strip, enabling the consolidation of currently separate fluorescent (daytime) and retro-reflective (nighttime) striping.

Proposal from CLEPA submitted as an alternative to the German proposal (document GRE-67-04) concerning conspicuity markings for the cab of commercial vehicles.

Illustrations to accompany the CLEPA proposal concerning conspicuity markings for commercial vehicles (document GRE-67-28).

CLEPA changes to its earlier proposal (GRSG/2012/4) proposing revisions to a Dutch proposal (GRSG/2011/23) that would enable the replacement of mirrors by camera monitor systems.

Presentation of alternative approach to the current version of i-Size child seat X-definition.

Proposal to clarify the use of test reports in Regulation No.13 as proposed under the Alternative Method for the Evaluation of Electronic Vehicle Stability Control Systems.

The current Euro 6 light duty vehicle emission limits for total hydrocarbons (THC)
include the methane fraction as well as non-methane hydrocarbon emissions. When the
Euro 5/6 co-decision proposal was negotiated, an NMHC limit value was added but the
THC limit was unchanged and is too restrictive.

The proposed amendments are aimed at redefining the class of bi-fuel vehicles to permit the simultaneous use of gas and petrol in gas mode. This submission follows the review by CLEPA members of the draft proposal (GRPE/2012/6).

Proposal to increase the strap sensitivity to a range of up to 3.0g to allow the
installation of belt systems less likely to lock up when pulling out the strap while buckling up.

OICA/CLEPA presentation supporting the use a of head-restraint measuring device (HRMD) to enhance GTR 7 test procedures.

CLEPA and OICA proposal to harmonize Regulations Nos. 13 and 13-H with the Federal Motor Vehicle Safety Standard FMVSS 135 on electric vehicle requirements with regard to the regenerative braking system (RBS).

Proposal from CLEPA to introduce type-approval requirements for Liquefied Petroleum Gas (LPG) fuel selection systems, including with regard to engine control units (ECU), CNG start-stop functionality, and a prohibition against the flow of gaseous fuel into the petrol/diesel fuel tank and vice versa.

Proposal from CLEPA to introduce type-approval provisions for compressed natural gas (CNG) control functionality included in the engine control unit, and for control
functionality which is used in vehicles with start-stop system.

Proposal to update UN R27 in accordance with technological progress by establishing provisions for the use of fluorescent retro-reflective strip, enabling the consolidation of currently separate fluorescent (daytime) and retro-reflective (nighttime) striping.

CLEPA presentation on additional sound emission provisions for replacement silencing systems.

Presentation outlining parameters for the further development of the advanced emergency braking systems regulation in line with technological progress.

Text from the European Association of Automotive Suppliers (CLEPA) and from the International Organization of Motor Vehicle Manufacturers (OICA) to align the braking performance requirements for M1 vehicles in Annex 3 of UN R79 with those of UN R13-H (light vehicle braking).

Update of the presentation outlining parameters for the further development of the advanced emergency braking systems regulation in line with technological progress.

Proposal from the European Association of Automobile Suppliers (CLEPA) to amend requirements on emergency locking retractors to increase the strap sensitivity to a range of up to 3.0g to allow the installation of belt systems less likely to lock up when pulling out the strap while buckling up.

Documents GRPE-63-05/Rev.1 and GRPE/2012/6/Rev.1 propose to redefine the class of bi-fuel vehicles to permit the simultaneous use of gas and petrol in gas mode in UN Regulation No. 83. CLEPA proposes an alternative method to the weighing procedure of the fuel consumption test procedure.

Proposal to align M1 vehicle braking performance requirements with UN R13-H provisions and clarify those for N1 vehicles in Annex 3 of UN R79.