Proposal to address cross-referencing issues in UN Regulation No. 79 with respect to UN Regulation No. 130 (Lane Departure Warning System), especially with regard to Australian lane marking specifications.

Proposal to address cross-referencing issues in UN Regulation No. 79 with respect to UN Regulation No. 130 (Lane Departure Warning System), especially with regard to Australian lane marking specifications.

Proposal to clarify the wording concerning automatic re-instatement of the AEBS default status at the “initiation of each engine start/run cycle”.

Proposal to differentiate between the scope of UN R79 and the proposed UN Regulation on Driver Control Assistance Systems (DCAS).

Proposal to adapt the regulation to allow for the approval of vehicles equipped with both an Automated Driving System and a manual driving mode.

Copy of document GRVA-17-49.

Document GRVA-17-49 from the September 2023 GRVA session.

Proposal to delineate the scope of UN R79 vis-à-vis the draft new UN Regulation on Driver Control Assistance Systems (DCAS).

Proposal to ensure that vehicles with ‘basic’ B1+ACC are not required to approve to the DCAS regulation just because that functionality meets the definition of DCAS. However, if the vehicle is equipped with DCAS that includes such functionality, that functionality must be approved according to this regulation so that the DCAS has been assessed holistically.

Proposal to clarify the provisions for ACSF Cat. A “Remote Controlled Parking (RCP)” for vehicle combinations. The current definition for RCP S_RCPmax sets a maximum limit of 6m distance to the motor vehicle, which is insufficient in situations where the operation is supervised by the driver located behind the vehicle combination.

Proposal to address cross-referencing issues in UN Regulation No. 79 with respect to UN Regulation No. 130 (Lane Departure Warning System), especially with regard to Australian lane marking specifications.

Proposal to address cross-referencing issues in UN Regulation No. 79 with respect to UN Regulation No. 130 (Lane Departure Warning System), especially with regard to Australian lane marking specifications.

Proposal to clarify the provisions for ACSF Cat. A “Remote Controlled Parking (RCP)” for vehicle combinations. The current definition for RCP S_RCPmax sets a maximum limit of 6m distance to the motor vehicle, which is insufficient in situations where the operation is supervised by the driver located behind the vehicle combination.

Proposal to permit crossing of lane markings by ACSF of category B1 to assist the driver in forming an access corridor for emergency and enforcement vehicles in slow-moving traffic (based on provisions adopted for UN R157).

Proposal to clarify the cascade of actions regarding activation of ACSF B1 and C and the indication on when the vehicle has entered an eligible road based on the following justification:

1. When the same means is used by the driver to simultaneously activate the Automatically Commanded Steering Function of Category B1 (ACSF B1) and of Category C (ACSF C), both functions switch to standby mode when the vehicle enters an ACSF C eligible road. But if the road is non-eligible to ACSF C, then only the ACSF B1 is activated.
2. With the current text of the regulation, once the vehicle moves to an ACSF C eligible road, the driver must operate again the means to activate the ACSF C. This second deliberate action is confusing for the driver since it makes the manipulation more complex. The current wording discourages most drivers from using this assistance function.
3. The proposed wording permits the following, logical, cascade of actions:
   1. The driver has done a deliberate action to activate ACSF B1 and ACSF C (on a non-eligible road); then
   2. He drives into an eligible road, and is clearly informed thereof; then
   3. He initiates a lane change procedure by activating e.g. the direction indicator.
4. This amendment further clarifies the requirement on the indication of when the vehicle enters an eligible road. It gives some examples of the type of indication to be given to the driver, e.g. additional popup or blinking indication, without being design restrictive.
5. A dedicated status indication of an ACSF C off-mode is by nature already different from the standby or active indication. Therefore, the driver is already sufficiently informed on a potential status change.
6. Regarding paragraph 5.6.4.2.3.: While entering the eligible road, the driver may be distracted or annoyed by this “prominent” indication. His attention resources shall be totally available during this phase. So the system would switch automatically to standby mode when fulfilling these two conditions: reaching an eligible and regular lane of travel. This second condition may be fulfilled for example by implementing a suitable time delay or by a direct verification of the lane of travel. These criteria should be explained, agreed between the technical service and the vehicle manufacturer.

Proposal to clarify the cascade of actions regarding activation of ACSF B1 and C and the indication on when the vehicle has entered an eligible road based on the following justification:

1. When the same means is used by the driver to simultaneously activate the Automatically Commanded Steering Function of Category B1 (ACSF B1) and of Category C (ACSF C), both functions switch to standby mode when the vehicle enters an ACSF C eligible road. But if the road is non-eligible to ACSF C, then only the ACSF B1 is activated.
2. With the current text of the regulation, once the vehicle moves to an ACSF C eligible road, the driver must operate again the means to activate the ACSF C. This second deliberate action is confusing for the driver since it makes the manipulation more complex. The current wording discourages most drivers from using this assistance function.
3. The proposed wording permits the following, logical, cascade of actions:
   1. The driver has done a deliberate action to activate ACSF B1 and ACSF C (on a non-eligible road); then
   2. He drives into an eligible road, and is clearly informed thereof; then
   3. He initiates a lane change procedure by activating e.g. the direction indicator.
4. This amendment further clarifies the requirement on the indication of when the vehicle enters an eligible road. It gives some examples of the type of indication to be given to the driver, e.g. additional popup or blinking indication, without being design restrictive.
5. A dedicated status indication of an ACSF C off-mode is by nature already different from the standby or active indication. Therefore, the driver is already sufficiently informed on a potential status change.
6. Regarding paragraph 5.6.4.2.3.: While entering the eligible road, the driver may be distracted or annoyed by this “prominent” indication. His attention resources shall be totally available during this phase. So the system would switch automatically to standby mode when fulfilling these two conditions: reaching an eligible and regular lane of travel. This second condition may be fulfilled for example by implementing a suitable time delay or by a direct verification of the lane of travel. These criteria should be explained, agreed between the technical service and the vehicle manufacturer.

Revised proposal prepared by the GRVA secretary pursuant to discussions during the 15th session to clarify a logical cascade of actions regarding activation of ACSF B1 and C and the indication on when the vehicle has entered an eligible road based on the following justification:

1. When the same means is used by the driver to simultaneously activate the Automatically Commanded Steering Function of Category B1 (ACSF B1) and of Category C (ACSF C), both functions switch to standby mode when the vehicle enters an ACSF C eligible road. But if the road is non-eligible to ACSF C, then only the ACSF B1 is activated.
2. With the current text of the regulation, once the vehicle moves to an ACSF C eligible road, the driver must operate again the means to activate the ACSF C. This second deliberate action is confusing for the driver since it makes the manipulation more complex. The current wording discourages most drivers from using this assistance function.
3. The proposed wording permits the following, logical, cascade of actions:
   1. The driver has done a deliberate action to activate ACSF B1 and ACSF C (on a non-eligible road); then
   2. He drives into an eligible road, and is clearly informed thereof; then
   3. He initiates a lane change procedure by activating e.g. the direction indicator.
4. This amendment further clarifies the requirement on the indication of when the vehicle enters an eligible road. It gives some examples of the type of indication to be given to the driver, e.g. additional popup or blinking indication, without being design restrictive.
5. A dedicated status indication of an ACSF C off-mode is by nature already different from the standby or active indication. Therefore, the driver is already sufficiently informed on a potential status change.
6. Regarding paragraph 5.6.4.2.3.: While entering the eligible road, the driver may be distracted or annoyed by this “prominent” indication. His attention resources shall be totally available during this phase. So the system would switch automatically to standby mode when fulfilling these two conditions: reaching an eligible and regular lane of travel. This second condition may be fulfilled for example by implementing a suitable time delay or by a direct verification of the lane of travel. These criteria should be explained, agreed between the technical service and the vehicle manufacturer.

Proposal to clarify a logical cascade of actions regarding activation of ACSF B1 and C and the indication on when the vehicle has entered an eligible road.

Proposal to clarify a logical cascade of actions regarding activation of ACSF B1 and C and the indication on when the vehicle has entered an eligible road.

Proposal to clarify a logical cascade of actions regarding activation of ACSF B1 and C and the indication on when the vehicle has entered an eligible road based on the following:

1. When the same means is used by the driver to simultaneously activate the Automatically Commanded Steering Function of Category B1 (ACSF B1) and of Category C (ACSF C), both functions switch to standby mode when the vehicle enters an ACSF C eligible road. But if the road is non-eligible to ACSF C, then only the ACSF B1 is activated.
2. With the current text of the regulation, once the vehicle moves to an ACSF C eligible road, the driver must operate again the means to activate the ACSF C. This second deliberate action is confusing for the driver since it makes the manipulation more complex. The current wording discourages most drivers from using this assistance function.
3. The proposed wording permits the following, logical, cascade of actions:
   1. The driver has done a deliberate action to activate ACSF B1 and ACSF C (on a non-eligible road); then
   2. He drives into an eligible road, and is clearly informed thereof; then
   3. He initiates a lane change procedure by activating e.g. the direction indicator.
4. This amendment further clarifies the requirement on the indication of when the vehicle enters an eligible road. It gives some examples of the type of indication to be given to the driver, e.g. additional popup or blinking indication, without being design restrictive.
5. A dedicated status indication of an ACSF C off-mode is by nature already different from the standby or active indication. Therefore, the driver is already sufficiently informed on a potential status change.

Proposal to prevent activation of an Automatically Commanded Steering Function of Category C for a minimum of [10] seconds after the system has verified that the road is of a valid type when merging into a roadway. The activation delay of [10] seconds prevents the system from being used during merging from the motorway’s acceleration lane. According to the proposal, the merging process during the acceleration phase is not fully suitable for an automated lane change due to, among other things, the vehicle dynamics and the limited space available. In addition, the delay shifts the driver’s notification of the automatic activation of the ACSF-C system to a time when the vehicle is already in a stable driving condition on the motorway and the driver’s attentional resources are more available to receive the notification. A manual activation of the system remains possible.