Revised document following discussion during the 7th BMFE informal group session.

Comparison table following the 7th BMFE informal group session.

Proposal to exempt Zone I from opaque obscuration requirements of GTR 6 under certain conditions.

Proposal to introduce a definition for “Aerodynamic devices” and ensure that such devices shall not compromise the functionality of rear underrun protection devices.

Proposal to update Part III of UN R93 to enable approval of truck cabs where the front underrun protection is integrated in the motor vehicle (in order to improve aerodynamic performance). This proposal would define the forward reference point as being the same transverse location where the force is applied. This results in FUPs where (in the case of cab fronts that are curved) at least 400 mm must be maintained along the front contour of the cab, instead of the foremost point. The proposal includes transitional provisions from 1 September 2020.

Proposal for a new regulation on uniform provisions concerning the approval of vehicle alarm systems and approval of a vehicle with regard to its vehicle alarm system. The regulation would extract provisions from UN R116 in order to advance UN R0 on the international whole vehicle type approval system.

Proposal to extract provisions from UN R116 in order to establish a separate regulation for the approval of devices to protect against unauthorized vehicle use. The splitting of UN R116 into three separate regulations has been proposed to advance the implementation of the International Whole Vehicle Type Approval system.

Proposal from the VRU Proximity Awareness informal group to

1. clarify test procedures allowing non-random selection of parameter combinations and
2. provide for protrusion requirements for Blind Spot Information Systems (BSIS) external elements.

Proposal in line with ISO 2575 to allow for the use of different colors (e.g., red, yellow, green) to convey the status modes (e.g., failure, active) of seven functions via modification of footnote 18 under Table 1.

Proposal to introduce electromagnetic specifications for the approval of an electronic device, such as a transponder — even without the traditional functionality of a mechanical key — under UN R62 via reference to UN R10 on electromagnetic compatibility (as is the case under UN R116).

Proposal to correct erroneous references (to annexes in the regulation as well as to UN R94 and R95) in the text.

Proposal to extract provisions from UN R116 in order to establish a separate regulation for the approval of immobilizers and vehicles equipped with immobilizers. The splitting of UN R116 into three separate regulations has been proposed to advance the implementation of the International Whole Vehicle Type Approval system.