Paper from the Electronic Displays Conference held in Nuremberg during the 25-26 February 2015.

This proposal aims to clarify that surveillance mirrors can be mounted below 2 meters from the ground when integrated in a housing including one or several mirrors of classes II or III.

Document GRSG/2015/9 would amend the provisions of UN R10 on electromagnetic compatibility to include camera-monitor devices newly defined under UN R46. This proposal aims to clarify that the amendment applies only to regulated devices for indirect vision (UN R46) so as not to be confused with other devices for indirect vision already included within the scope of UN R10.

Document GRSG/2015/8 proposes to amend the provisions on forward field of vision of drivers in UN R125 to promote and to support the installation of camera-monitor devices on vehicles of category M1. This proposal would clarify that the amendment only applies to regulated devices for indirect vision.

Proposal to redefine the measurement criteria for determining appropriate seat spacing in order to address observed cases where adequate spacing is not achieved even though the current criteria are fulfilled. The type approval authorities of the member states of the European Union (TAAM) discussed the proper interpretation of the text of the Regulation in the case of seats with a central recess (sunken area) and decided that the text of the Regulation needed to be modified in order to provide an adequate method to measure the H dimension.

Incident reports confirm that occupants of exposed seats have been thrown forward during heavy braking or vehicle impact conditions, often sustaining head injuries from contact with the vehicle floor or other hard structure. Seats particularly affected are those located immediately to the rear of an open wheelchair or buggy space. This proposal aims to reduce this risk by extending existing requirements for exposed seats adjacent to step wells to apply to other exposed seats where there is a risk of the occupant being thrown forward.

Proposal to enable the use of autonomous CNG heaters for the heating of engines before the vehicle is in service.

An accident occurred where an N1 security vehicle fatally injured a child who was crossing the entrance to a supermarket car park. The vehicle had been modified from the original specification of the manufacturer by the removal of the side windows and the fitting of plastic glazing on both sides of the driver’s cab area, and a frame of strengthening material fitted to the replacement glazing. This reduced the side vision for the driver of the vehicle. Since UN R125 applies to M1 vehicles, the UK seeks guidance from GRSG on the application of UN R125 provisions to N1 vehicles.

Proposal from the GRSG secretariat to correct the definition of “Odometer” in documents GRSG/2015/15 and GRSG/2015/16.

Proposal to amend document GRSG/2015/17 which would introduce higher stringency levels for rear underrun protection devices.

Proposal to correct certain omissions in the text and to simplify the transitional provisions proposed in document GRSG/2015/17 which would increase the stringency of the rear underrun protection device requirements.

UN Regulations Nos. 58 and 73 contain exemptions which can be applied by an approval authority and we are concerned that a vehicle which is correctly approved using such an exemption cannot then be required to have an RUPD or sideguards. The UK seeks the views of GRSG on how the wording of the exemptions may be improved to ensure that as many vehicles as possible are fitted with RUPD and sideguards.

Proposal to limit reporting requirements to the tested (or parent) vehicles in the type approval communication form by deleting the requirement to communicate CO2 emissions and power figures for each specific vehicle0. For vehicle types where the retrofit system is qualified (i.e. other than parent vehicles), the current model requires the communication of a calculated CO2 factor as well as of the specific CO2 emissions in natural gas mode. Since the specific CO2 emissions in gas mode are calculated by applying the CO2 factor to the emissions in petrol mode, communication of only the CO2 factor is sufficient to establish the CO2 emissions in gas mode of any vehicle type, when required.

OICA comments expressing opposition to the proposed measures to combat odometer fraud in the used vehicle market.

India comments raising concerns over the feasibility of the proposal to combat odometer fraud in used car sales.

Proposal to update requirements for numeric/digital displays.

OICA concerns regarding the proposal to introduce fire suppression systems for buses and coaches upon detection of fire in the engine and/or heater compartment (document GRSG/2014/6/Rev.1).

Proposal to establish an informal working group to consolidate existing amendments to UN Regulation No. 110 in light of technical progress of other gaseous fuel regulations and standards and, where necessary, amend the Regulation to promote improved clarity and harmonization.

Proposal to require an exterior protection on cylindrical gas tanks. Under the current regulation, such exterior protection may be fitted at the discretion of the manufacturer. The intention is to increase protection against corrosion of cylinders in response to a corroded cylinder explosion in Germany.

Proposal to exclude M and N1 vehicles from the close-proximity field of vision requirements pursuant to the establishment of the international whole vehicle type approval system.