Proposal to modify the draft Amendment 2 to GTR 6 regarding obscuration area definitions.

Changes to the proposal to exempt rear edges of fenders and rear edges of A pillars under certain conditions.

Full UN R144 integrating the proposal to:

1. clarify that the application of an AECD approval to other vehicle categories than M₁ and N₁ is not mandatory,
2. align the power supply requirement of Part III, para. 34.1 with the corresponding requirement in Part II, para. 25.1.
3. clarify with regard to para. 34.1 that if the vehicle is equipped with both
   • -a “back-power supply” as listed in para. 35.10.1 and
   • -a “Power supply other than back-up power supply mentioned in paragraph 35.10.1” as listed in para. 35.10.2
   both should be tested according to Annex 9. The “Power supply other than back-up power supply mentioned in paragraph 35.10.1” should indeed only be tested if it is the only power supply for the AECS.
4. include two-year transitional provisions
5. remove the exclusion of M₁ and N₁ not equipped with a side airbag and to specify that the AECS shall be able to output the navigation solution in an NMEA-0183 protocol format (RMC, GGA, VTG, GSA and GSV message), among other clarifications.

Proposal for a mutual resolution [No. 4] concerning recommendations on ceramic printed area widths for panoramic sunroof designs.

Revisions to the proposal to update Part III of UN R93 to enable approval of truck cabs where the front underrun protection is integrated in the motor vehicle (in order to improve aerodynamic performance). The proposal includes transitional provisions from 1 November 2025.

Revised proposal to allow an alternative positioning and spacing of escape hatches on buses of Classes A and B to address limitations for shorter vehicles.

Proposal to clarify the regulation with regard to cone placement in the test procedure.

Updated proposal to exempt Zone I from opaque obscuration requirements of GTR 6 under certain conditions.