Revision 2 of the proposal from the CRS informal group to introduce phase 2 amendments regarding the approval of booster-seat CRS category (booster seat with backrest) into UN R129.

Amendment to the proposals (GRSP/2016/3, GRSP/2016/5, and GRSP/2016/6) to amend the toxicity and flammability declarations via references to EN 71 (European safety standards), taking into account procedures of FMVSS 302. The amendments propose the burning rate values of FMVSS 302 (302.4 inches/102 mm per minute), to harmonize the three proposals with regard to EN standards references, and to incorporate the amendment 1 to EN 71-3 (A1:2014).

Proposal to change the burn-rate in documents GRSP/2016/3, GRSP/2016/5, and GRSP/2016/6 from [250 mm] to the equivalent of the FMVSS 302 specification, i.e., 100 mm.

Presentation of issues raised during discussions of the GRE Task Force on EMC requirements with regard to the application of several UN Regulations to trolley buses depending upon their configuration (e.g., dual-mode operation either connected to overhead cables or in standard bus mode).

Revised version of the proposal from the CRS informal group to introduce phase 2 amendments regarding the approval of booster-seat CRS category (booster seat with backrest) into UN R129. This version supersedes document GRSP/2016/4 and will be introduced at the next GRSP session in May. Pursuant to the GRSP discussions, the draft may be subject to further changes during the June CRS-59 session.

Hungary agrees with the proposed change to the airbag label, but recommends the addition of transitional provisions.

Presentation concerning technical discussions, conclusions, and proposals for CRS bench seat cushion drop tests under UN R44 and UN R129.

Draft of a request for authorization to amend GTR 9 to include provisions for deployable safety systems of the outer surface of the vehicle. This proposal originates with the development of technologies such as active hood/bonnet mechanisms that improve pedestrian impact protection. The proposal anticipates submission of a formal amendment for the June 2018 WP.29 session.

Updated proposal from Spain on behalf of the CRS Technical Services Group to align requirements for deceleration test devices with acceleration ones (making explicit that it is mandatory to match the corridor for each test) and to add dummy criteria and compliance with ISO 17025 to the information required in test reports.

Proposal from Spain on behalf of the CRS Technical Services Group to

• to align paragraph 6.6.3.1. with the 01 series of amendments,
• to align requirements in 7.1.3.1 to test methods in 8.1.2.4.,
• to add tolerances to better define the test method in paragraph 8.1.2.3.,
• to improve the specifications for the measurement of dimensions C and D in Annex 23,
• to align deceleration test requirements with acceleration test provisions (making explicit that it is mandatory to match the corridor for each test, and
• to define the initial acceleration value under paragraph 7.3. against which the maximum deviation restriction is to be applied.

Proposal to clarify the “Minimum requirements for safety-belts and Retractors” table in Annex 16.

Proposal to strip ISOFIX CRS provisions from UN R44 and to cease all new type approvals for ISOFIX integral CRS under UN R44 from [November 2016] in deference to UN R129 on Enhanced CRS.

Updated proposal from the CRS informal group to introduce phase 2 amendments related to the booster-seat CRS category (booster seat with backrest) into UN R129. This document updates the proposal in document GRSP/2016/4.

Proposal drafted by OICA pursuant to cooperation among the EU, Consumers International, Governmental experts, Euro NCAP, OICA and CLEPA to restructure and simplify the consumer information requirements on the installation of ISOFIX child restraint systems under UN R16.

Proposal to introduce provisions for seat-belt reminders for all vehicle seating positions pursuant to the outcome of the Task Force on Seat-belt Reminders discussions.