MR1: Proposal for Addendum 1 (BioRID II ATD specifications)
Reference Number: GRSP/2021/2
Specifications for the Construction, Preparation and Certification of the 50th percentile male Biofidelic Rear Impact Dummy, (BioRID-II UN) anthropomorphic test Device.
Clarifies the application of the dynamic test procedures and specifies the installation configurations to be tested. Aims to clarify the tests conducted in a consistent way by Technical Services.
UN R129: Proposal for Supplement 8 to the 01 series of amendments
Reference Number: GRSP/2021/4
Proposal clarifies the application of the dynamic test procedures and specifies the installation configurations to be tested. Aims to clarify the tests conducted in a consistent way by Technical Service.
UN R129: Proposal for Supplement 7 to the 02 series of amendments
Reference Number: GRSP/2021/5
Proposal clarifies the application of the dynamic test procedures and specifies the installation configurations to be tested. Aims to clarify the tests conducted in a consistent way by Technical Services.
UN R129: Proposal for Supplement 6 to the 03 series of amendments
Reference Number: GRSP/2021/6
Proposal clarifies the application of the dynamic test procedures and specifies the installation configurations to be tested. Aims to clarify the tests conducted in a consistent way by Technical Services.
UN R129: Proposal for Supplement 6 to the 03 series of amendments
Reference Number: GRSP/2021/7
Clarifies how to assess the head containment. Increases the time frame for the assessment of the head containment criteria from the current period of 0 to 80 ms into the full duration of the entire test
UN R95: Proposal for Supplement 1 to the 04 series of amendments and Supplement 2 to the 05 series of amendments
Reference Number: GRSP/2021/8
Expands the scope and covers: M1 with a maximum permissible mass not exceeding 3,500 kg; M1 with a maximum permissible mass exceeding 3,500 kg and a low “R” point and N1.
UN R16: Proposal for Supplement 7 to the 07 series of amendments, Supplement 3 to the 08 series of amendments
Reference Number: GRSP/2021/10
Proposal corrects an omission in paragraph 3 with regard to information on safety-belt reminders and aligns the regulation with Annex I of EU regulation 2018/858.
UN R134: Proposal for Supplement 4 and Supplement 1 to the 01 series of amendments
Reference Number: GRSP/2021/12
Proposes alternative test methods for heavy duty vehicles in order to improve applicability of the requirements to vehicles of categories M2, M3, N2 and N3.
UN R22: Proposal for Supplement 1 to the 06 series of amendments
Reference Number: GRSP/2021/13
Introduces wording to clarify that the performance of protective helmets may be affected by using accessories not tested during the type approval procedure. Changes introduced by customers on helmets are not covered once the helmet has been type-approved.
UN R135: Proposal for Supplement 3 to 01 series of amendments
Reference Number: GRSP/2021/14
Defines parameters to enable a reproducible measurement of the acute angle alpha (α) to decide if the vehicle is or is not in the scope of the regulation.
UN R16: Proposal for Corrigendum 1 to Supplement 12 to the 06 series of amendments
Reference Number: GRSP/2021/16
Proposal brings the text from the information sheet referring to the safety-belt reminder where it is really required, namely the seating position of the driver.
UN R22: Proposal for Supplement 1 to the 06 series of amendments
Reference Number: GRSP/2021/15
Proposal to address the safety of helmet accessories until such time as specific requirements for the approval of accessories independently of helmets can be established.