Proposal to add a new symbol (as defined by IEC standard 60417-5009) for power on/off controls in electrified vehicles (e.g., electric or fuel cell vehicles).

Proposal to clarify the treatment of extensions of existing approvals under the new transitional provision guidelines (“Until 31 December 2019, Supplement 2 to the 01 series of amendments to this Regulation may not apply to extensions of approvals that were originally granted prior to the entry into force of Supplement 2.”)

Proposal to align the Russian text with the English version.

Proposal to correct the Russian text of the regulation.

Proposal pursuant to discussions on the application of footnote ¹⁸ under Table 1 concerning tell-tale symbols and the use of colours to convey different meanings. ISO standard 2575-2004, para. 5.1. allows for the use of different colours to convey a change in the operating condition. This proposal would remove the current footnote ¹⁸ text and application of the footnote to telltales 2, 9-12, and 19 pending a decision on the proposal to apply a revised footnote to the master lighting switch (tell-tale 1). Paragraph 5.4.1.1. of UN R121 references ISO 2575-2004 which was developed to simplify the application of UN R121 when colour changes are adopted in other UN Regulations; however, OICA submits that the footnote which references ISO 2575-2004 in relation to specific lighting devices or systems creates a degree of confusion. (If approved, this proposal would likely impact Supplement 3 to the 01 series rather than Supplement 2 given that WP.29 at its November 2017 session adopted the proposal to add a telltale and symbols for “Accident Emergency Call System (AECS)” and to align UN R121 with the 07 series of amendments to UN Regulation No. 16 as Supplement 2 to the 01 series.)

Proposal to apply footnote ¹⁸ to the symbol for tell-tale No. 1 (master lighting switch) in order to simplify the treatment of colour changes of tell-tales. Footnote ¹⁸ specifies "“Symbol may be shown in other colours than specified in column 5 in order to convey different meanings according to the general colour coding as proposed in paragraph 5. of ISO 2575-2004.” This proposal clarifies the existing understanding of the intent of the regulation and in particular addresses concerns over interpretation where tell-tales Nos. 1 and 19 have been combined.

Proposal to apply footnote ¹⁸ to the symbol for tell-tale No. 1 (master lighting switch) in order to simplify the treatment of colour changes of tell-tales. Footnote ¹⁸ specifies "“Symbol may be shown in other colours than specified in column 5 in order to convey different meanings according to the general colour coding as proposed in paragraph 5. of ISO 2575-2004.” This proposal clarifies the existing understanding of the intent of the regulation and in particular addresses concerns over interpretation where tell-tales Nos. 1 and 19 have been combined.