Copy of document GRSP-56-09 (to extend the scope of UN R129 to include non-Integral child restraint systems (“Universal Booster” or “Specific to vehicle Booster”)) for development during the 49th CRS informal group session.

Revised version of the proposal to extend the scope of UN R129 to include non-Integral child restraint systems (“Universal Booster” or “Specific to vehicle Booster”) based upon document GRSP-56-09 as developed during the 49th CRS informal group session.

Pursuant to the introduction of the deceleration method for measuring tire rolling resistance using the dω/dt approach (“Deceleration Calculator”) proposed by NAMI and accepted by GRB, UTAC (France) provides information on the results of tests conducted to confirm repeatability and reproducibility of the new method using different machines.

Proposal to delete the requirement for automatic leveling devices for all headlamps with light emitting diode (LED) light sources based upon the results of the GTB glare study. The proposal argues that the restriction discriminates against LED light sources based upon an erroneous understanding of light-source relevance to driver glare.

Proposal to delete the requirement that the total objective luminous flux of all LED modules producing the principal passing (main low) beam of a headlamp be greater than or equal to 1000 lumens because the requirement is design-restrictive, unnecessary given the objective criteria for luminous output and photometric grid points of the regulation, and obsolete given improvements in LED technologies.

Proposal to correct an inconsistency between the regulation text and Figure B of Annex 3.

European countries are considering new requirements to require the fitment of snow tyres for use in severe snow conditions on specific axles of heavy duty vehicles. New tyres are approved under UN R117; however, a large percentage of heavy duty vehicles are fitted with retreaded tyres which are outside the scope of UN R117. This proposal would transpose the relevant requirements for new snow tyres into UN R109 in order of avoid the exclusion of retreaded tyres from such applications/markets.

Proposal to extend the scope of UN Regulation No. 129 to include non-Integral child restraint systems (“Universal Booster” or “Specific to vehicle Booster”) (Development Phase 2 of the UN Regulation).

Revised version of the proposal (formal document GRSP/2015/9 ) to extend the scope of UN Regulation No. 129 to include non-Integral child restraint systems (“Universal Booster” or “Specific to vehicle Booster”). This version includes all corrections to the text made by the Informal Working Group on Child Restraint Systems through it 6 May 2015 session.

Revised amendment, including track changes, to introduce all the modifications needed in UN Regulation No. 129 (Enhanced Child Restraint System (ECRS)) that were suggested by the experts of the informal working group on Child Restraint Systems (IWG CRS) to extend the scope of this Regulation to Non-Integral child restraint systems (“Universal Booster” or “Specific to vehicle Booster”) (Phase 2 of the UN Regulation).

Proposal to:
a) Align definitions and content with the other tyre regulations (UN Regulations Nos. 117, 54, 75 etc.);
b) Include a definition of “manufacturer” extracted from the resolution “R.E.3”;
c) Adopt a common definition and use of the terms “Manufacturer’s name”, “Brand name”, “Trademark”, “Trade description” and “Commercial name” and their links; and
d) Add information in the certificate to enable approval authorities to more easily understand the products the certificate addresses.

Proposal to:
a) Align definitions and content with the other tyre regulations (UN Regulations Nos. 30, 117, 75 etc.);
b) Include a definition of “manufacturer” extracted from the resolution “R.E.3”;
c) Adopt a common definition and use of the terms “Manufacturer’s name”, “Brand name”, “Trademark”, “Trade description” and “Commercial name” and their links; and
d) Add information in the certificate to enable approval authorities to more easily understand the products the certificate addresses.

Proposal to:
a) Align definitions and content with the other tyre regulations (UN Regulations Nos. 30, 54, 75 etc.);
b) Include a definition of “manufacturer” extracted from the resolution “R.E.3”;
c) Adopt a common definition and use of the terms “Manufacturer’s name”, “Brand name”, “Trademark”, “Trade description” and “Commercial name” and their links; and
d) Add information in the certificate to enable approval authorities to more easily understand the products the certificate addresses.

Proposal for corrections to the draft Supplement 5 to the regulation. The draft supplement aims to refine definitions, removes the “AWD” abbeviation for “audible warning device” to avoid confusion with its more common use for “all wheel drive”, adds T category agricultural vehicles to the scope, modifies some administrative communications, and proposes three-direction acoustic measurements.

Presentation supporting documents GRRF/2015/25, /29, and /32 proposing to:
a) Align definitions and content of UN tyre regulations;
b) Include a definition of “manufacturer” extracted from the resolution “R.E.3”;
c) Adopt a common definition and use of the terms “Manufacturer’s name”, “Brand name”, “Trademark”, “Trade description” and “Commercial name” and their links; and
d) Add information in the certificate to enable approval authorities to more easily understand the products the certificate addresses.

Proposal to improve the wording of the draft amendment on lane-keeping assistance systems, based on document GRRF-79-04.

The current text of UN R54 does not encompass the case where a tyre designed for a “special” application can also fulfil the definition of a “snow” tyre. This proposal would allow for such tyres to be marked with the inscription M+S, M.S, or M&S while remaining in the category of use “special”.

Revised version of the proposal (formal document GRSP/2015/9 ) to extend the scope of UN Regulation No. 129 to include non-Integral child restraint systems (“Universal Booster” or “Specific to vehicle Booster”). This version includes all corrections to the text made by the Informal Working Group on Child Restraint Systems through its September session. (The CRS informal group will discuss this version during its October session.)

Proposal to clarify the texts related to the recently expanded height requirements for the effective upper belt anchorage (Supplement 4 to the 07 series of amendments to Regulation No. 14).

Proposal to introduce phase 2 amendments related to the booster seat category (booster seat with backrest) into UN R129. The text includes all modifications proposed by GRSP up to and including its 57th session (Geneva, 18–22 May 2015) as well as those of the IWG CRS up to and including its 53rd session (London, 2 September 2015). The proposal builds on the original UN Regulation No. 129, Corrigendum 1, Supplements 1, 2, 3 and 4 as well as the draft 01 series of amendments to the UN Regulation (ECE/TRANS/WP.29/GRSP/2015/24) Phase 1.

Proposal to limit the use of a booster cushion (booster seat without backrest) with children of a stature greater than 125 cm and the application for type approval of such CRS only in mass Group III for children of mass from 22 kg to 36 kg. The proposal is submitted on behalf of the CRS informal working group.

Comments on the draft amendment to UN R79 addressing automated steering as it stood at the end of the third ACSF informal group session. This document also raises links to rear vision (UN R46), AEBS (UN R131), and park assist systems.

Proposal to:
a) Align definitions and content with the other tyre regulations (UN Regulations Nos. 117, 54, 75 etc.);
b) Include a definition of “manufacturer” extracted from the resolution “R.E.3”;
c) Adopt a common definition and use of the terms “Manufacturer’s name”, “Brand name”, “Trademark”, “Trade description” and “Commercial name” and their links; and
d) Add information in the certificate to enable approval authorities to more easily understand the products the certificate addresses.

Proposal to:
a) Align definitions and content with the other tyre regulations (UN Regulations Nos. 30, 117, 75 etc.);
b) Include a definition of “manufacturer” extracted from the resolution “R.E.3”;
c) Adopt a common definition and use of the terms “Manufacturer’s name”, “Brand name”, “Trademark”, “Trade description” and “Commercial name” and their links; and
d) Add information in the certificate to enable approval authorities to more easily understand the products the certificate addresses.

The current text of UN R54 does not encompass the case where a tyre designed for a “special” application can also fulfil the definition of a “snow” tyre. This proposal would allow for such tyres to be marked with the inscription M+S, M.S, or M&S while remaining in the category of use “special”.

Proposal to:
a) Align definitions and content with the other tyre regulations (UN Regulations Nos. 30, 54, 75 etc.);
b) Include a definition of “manufacturer” extracted from the resolution “R.E.3”;
c) Adopt a common definition and use of the terms “Manufacturer’s name”, “Brand name”, “Trademark”, “Trade description” and “Commercial name” and their links; and
d) Add information in the certificate to enable approval authorities to more easily understand the products the certificate addresses.

Further refinements to the formal proposal to amend UN R129 with regard to non-integral CRS. This informal document effectively updates the formal proposal in GRSP/2015/24.

Updated proposal from the CRS informal group to introduce phase 2 amendments related to the booster-seat CRS category (booster seat with backrest) into UN R129. This informal document effectively supersedes the formal proposal in GRSP/2015/31.