Proposal to clarify the definitions and requirements associated with the installation of “single lamps”, “lamps marked D” and “Interdependent lamps”, to ensure that the introduction of the new class F marking materials does not conflict with the mandatory requirements for existing class C materials, and to extend the modifications that introduced provisions for interdependent direction indicator lamps in the 06 series of amendments to UN R48 to the 05 series in order to avoid an unjustified design restriction for approvals under the earlier version of the regulation.

Proposal to clarify the definitions and requirements associated with the installation of “single lamps”, “lamps marked D” and “Interdependent lamps”, to ensure that the introduction of the new class F marking materials does not conflict with the mandatory requirements for existing class C materials, and to enable the type-approval of direction indicators with variable apparent surfaces.

Proposal to introduce new class F marking materials designed with chevron type pattern to be applied to special utility vehicles or trailers not ordinarily covered by standard contour marking materials. The proposal also attempts to harmonize a number of national requirements.

Proposal to correct typographical errors introduced during previous amendment to the regulation (see document WP.29/2012/83). The initial changes were already in Revision 2 of UN Regulation No. 113.

Proposal to insert the IEC cap sheet number for the new light category LW2 into the regulation.

Proposal to allow for the use of different brake lamp activation methods for Powered Two Wheelers (PTWs). This amendment also introduces the concept of a high-mounted stop lamp to PTWs to improve the conspicuity of the vehicles during stopping.

Proposal to introduce new class 5 devices made solely of retro-reflective plates with chevron type pattern to be applied to special utility vehicles or trailers not regularly covered by standard rear marking plates. The amendment also seeks to harmonize the text to cover various national requirements.

Revised text originally submitted to WP.29 for its November 2013 session, but returned by the Forum due to concerns over the Conformity of Production (CoP) provisions. This revised version deletes the CoP provisions and is submitted pending also a review by GRE at its October 2014 session. This supplement completes the deletion of distributed lighting systems (DLS), or rather light generators, from the regulation.

Proposal to amend the provisions concerning the heat test requirements for Conformity of Production.

Proposal to correct provisions on bend lighting for motorcycles recently adopted by WP.29 as Supplement 2 (document WP.29/2012/83).

Proposal to amend the provisions concerning the heat test requirements for Conformity of Production (CoP) and to complete the deletion of distributed lighting systems (DLS) (light generators) from the regulations.

Responses to the IWVTA group questionnaire sent to Contracting Parties to the 1958 Agreement in order to determine readiness to apply the international whole vehicle type approval system (UN Regulation No. 0) and to raise any issues that might impede its development and use.

Proposal for an expert working group to develop recommendations for the restructuring of UN lighting regulations in order to reduce their number and simplify the system for their future development.

Comments on the proposed mandate for the SLR informal group.

GTB analysis of “collective amendments” to lighting regulations received by the Working Party on Lighting and Light-signalling Equipment (GRE) where a single change impacts multiple lighting regulations resulting in the proliferation of amendment proposals.

Starter text for a regulation that would concern general for test procedures applicable to Regulations 3, (4), 6, 7,.19, 23, (27), (37), 38, (45), 48, 50, 53, (65), 69, 70, 74, 77, 87, (88), 91, 99, 104, 112, 113, 119, 123, 128, with regard to definitions, general administrative requirements, general requirements, general test procedures band test procedures for plastic lenses and for materials with fluorescent colours.

ToR as agreed to within the informal group during its first session.