Draft text presented by the EVS informal group for GRSP discussion and consideration.

Revised version of document EVS-13-07-501.

Draft text pursuant to discussions of EVS-13-16-502. This text remains be cleaned up.

Draft text for inclusion in the electric vehicle safety GTR concerning future work on cell/module/system test requirements as part of the further development of the regulation.

Draft version of GTR not yet finalized, including partial insertions from Task Force 5.

Draft version of GTR not yet finalized, including partial insertions from Task Force 5.

Joint proposal supported by Canada, the EU, OICA, and the USA.

Updated document EVS-11-27 in clean version prepared by the EU.

Final clean draft proposal for GTR provisions regarding “Protection against Water Effects” (superseding EVSTF-07-03e, EVS-08-17, EVS-10-05e, EVS 11-27e) prepared by the EU.

Proposal from Japan for the use of an isolation resistance monitor as an alternative to water flooding and washing tests in evaluating electric vehicle protection against water.

Overview of thermal runaway test procedure discussion outcomes.

Final task force draft for consideration by the EVS informal group during its 12th (September 2016) session.

Amendment proposal on draft GTR (document EVS-07-04).

Draft text with comments as of 3 September 2016.

Draft proposal for electric vehicle requirements with regard to providing the driver with safety-related warnings (e.g. low battery indication, system malfunction, thermal event).

Revised working draft text for the thermal runaway propagation test procedure with comments responding to items raised from the previous version.

Identical to document EVS-11-27.

“Thermal Runaway and Propagation in Li Ion Batteries”

Water tests for the power inlet are not required in GTR draft. During the 4th EVS meeting, it was agreed that the power inlet is one part of the vehicle and that the vehicle level waterproof requirement is sufficient.

Revision 6 of the electric vehicle safety GTR project plan of the informal working group on Electric Vehicle Safety.

Marked up version of document EVSTF-08-40 showing JRC comments and questions on the draft text.

OICA comments on the status of the discussions and proposed test procedure as of 13 June 2016.

OICA presentation on the proposed thermal propagation initiation methods (nail, heat, and overcharge) and concerns over the objectivity of the testing in terms of producing quantitative, comparable outcomes. OICA argues that the three proposed initiation methods are not equivalent and that overcharge should be removed. In addition, OICA could like to see a thermal runaway definition applicable to cathode or anode configurations and proposes changing the definition (detection criteria) of thermal runaway to temperature-increase rates of greater than 1.25°C/sec (75°C/min) or lower.

Presentation of research on various REESS configurations and proposal for test and performance criteria. Korea proposes configurations for the heat, penetration (nail), and overcharge initiation methods. In addition, Korea proposes a thermal runaway definition as the condition where the cell temperature rise rate ≥ 20°C/min and would limit the maximum cell temperature to ≥ 200°C Initiation method.

Update version of document EVTS-08-60 on battery management system functionality.

Comments from Toyota on the draft procedure.

Draft OICA “framing document” intended to clarify the consensus concerning the scope, purpose, and objectives of the BMS functionality work, as of 10 June 2016 (version 2).

Korea comments in response to Japan’s document EVSTF-08-07 on the draft text for evaluating fire resistance of electric vehicle power systems (document EVS-08-01).

Korea comments on the documents EVSTF-08-13 and 14 concerning the draft text on fire resistance (EVSTF-08-01).

Korea comments on the OICA proposal in document EVSTF-08-14 for an LPG fire test method.

US proposal taking into account and responding to comments received from JRC (22 April 2016) and OICA (17 May 2016)

Comments on the draft proposal (version EVSTF-08-29) for battery pack thermal propagation testing.

Comparison of provisions in the draft proposals prepared by China and by OICA and in UN R100 on battery electric vehicle safety.

List of ISO, IEC, SAE, and UL standards related to electric vehicle safety performance.

Overview of provisions for the electric vehicle safety GTR towards defining those ready for incorporation into the first proposal to establish the GTR and those open items to be resolved and include in the GTR in a later amendment.

Draft electric vehicle safety GTR including water protection test and 48V system provisions.

Presentation on discussions to define a test procedure and requirements for battery management system (BMS) warning indicators (e.g., low energy). Concerns have arisen over the range of battery designs, differences between centralized and distributed BMS, and that ability to devise a coherent test procedure to cover all the possible variations.

Proposed schedule for the Electric Vehicle Safety informal group Tokyo meeting and for meetings of its subsidiary task forces.