This document provides information on the expected operation of the IWVTA system and includes a new question on the impact of changes to a UN Regulation included within the IWVTA on whole vehicle approvals issued prior to the modification of the individual regulation.

Current draft text including changes made during the 18th subgroup session and prepared as the basis for discussions during the 19th subgroup session.

A complete and comprehensive review of the UN R0 base document for the 19th SGR0 meeting performed by experts from OICA.

Review of work towards adapting and/or approving certain UN Regulations for use within the International Whole Vehicle Type Approval regulation.

WP.29 adoption of the new IWVTA regulation (UN Regulation No. 0) is anticipated for March 2017 with an entry-into-force the following October. This initial regulation (00 series of amendments) will include UN Regulations as they stand prior to September 2, 2017. However, a number of these regulations contain transitional provisions such that new versions will enter into force during the 12 months following this cut-off date. Therefore, this document proposes a list of such regulations that would be included in the 01 series of amendments to UN R0 to be submitted for adoption by WP.29 in November 2017. In concept, UN R0 would be updated with these “upgraded” versions of the UN Regulations.

OICA proposal, updated by the SGR0 Pre-test task force coordinator, for the organization and rules of procedure for validating the proposed whole vehicle type approval regulation.

WP.29 adoption of the new IWVTA regulation (UN Regulation No. 0) is anticipated for March 2017 with an entry-into-force the following October. This initial regulation (00 series of amendments) will include UN Regulations as they stand prior to September 2, 2017. However, a number of these regulations contain transitional provisions such that new versions will enter into force during the 12 months following this cut-off date. Therefore, this document (updated from the earlier version) proposes a list of such regulations that would be included in the 01 series of amendments to UN R0 to be submitted for adoption by WP.29 in November 2017. In concept, UN R0 would be updated with these “upgraded” versions of the UN Regulations.

Report from Japan’s MLIT consideration of the IWVTA procedures, identifying concern over the definition and verification of information contained in type approvals. Attachment 1 to this report lists the various items from type-approval certificates that MLIT found difficult to verify independently.

MLIT report raising concerns over the way approval numbers reflect the supplements covered. The draft Revision 3 of the 1958 Agreement requires that each approval number include the applicable supplement number; however, the application for a change of the supplement number does not constitute application for an extension of the approval. As a result, the approval number will not be changed even if a different supplement comes into force, resulting in a product having a supplement number that is different from the actual number of the supplement in force.

Under the draft IN R0, Annex 5, Part III requires applicants to furnish the list of type approvals, including approval number, upon which the whole vehicle approval will be based. UN R0 would allow for limited whole vehicle (L-IWVTA) approvals based upon compliance with some, but not all of the UN Regulations incorporated within UN R0. MLIT believes that the information requested under Annex 5, Part III is insufficient to understand whether an application for an L-IWVTA or a universal approval (U-IWVTA) is complete with regard to the equipment installed on the vehicle to be approved or whether applicant has simply failed to provide complete information. MLIT proposes adding a column for the applicant to briefly note a reason for omitting a regulation.

Illustration of the UN Regulation approvals information sheet as proposed in the related document SGR0-19-13.

Proposal to exclude exhaust emission level and fuel consumption from the definition of a version until the exhaust emission requirements and the fuel consumption requirements are added to Annex 4. The concern is that limits vary across Contracting Parties and changes to a CP limit would require issuance of an new version based upon a new application for IWVTA approval.

Report raising concerns over the verification of compliance with lighting installation requirements under whole vehicle approval.

Proposal to remove the requirements to provide approval certificates for bulbs used in lamp units because approval procedures for lamp units involve the testing of the units with bulbs that comply with the requirements. Therefore, the UN R0 requirement to provide approval certificates for both lamp units and the bulbs used in those units appears redundant.

Presentation concerning how an IWVTA could relate to the structure of individual national or regional whole vehicle approval systems. In some cases, there may be a one-to-one relationship between the international and local whole vehicle approvals. In others, a single IWVTA may correspond to more than one local approval while in others, multiple IWVTA may be required to correspond to a broader local definition of a whole vehicle approval.

Tyre rolling resistance falls outside the scope of UN R0 because this attribute is used in the calculation of C02 emissions and IWVTA does not include UN R83 or UN R101.

The Communication requirement of UN R0 follows that of the EC-WVTA and refers to the attachment of an information package. Germany proposes that this reference be replaced with an index of attachments referring to the relevant information document and test report(s).

Description of two approaches for the development of the international whole vehicle approval system either by beginning with a limited regulatory scope (with Contracting Parties specifying additional national requirements) or by beginning with an absolute universal IWVTA covering all applicable regulations with Contracting Parties using limited IWVTA for approvals that are narrower in coverage of underlying component regulations.

Proposal from the Netherlands on behalf of the Database for the Exchange of Type Approval information (DETA) informal group. Similar to the decision to delete Commercial Name from the Document of Conformance (DoC), the DETA group proposes to remove the “Make” (i.e., trade name) and “Location of VIN”.

Proposal to add item 2, Masses and Dimensions, to the information document in Annex 5 because “the technically permissible maximum laden mass” is a criterion for determining the version.

Proposal to delete references to emission and fuel consumption because these attributes are not currently within the scope of IWVTA.

Proposal to add information provided concerning the vehicle type.

Proposal to delete the Supplement number from the approval since supplements are not extensions and do not require renumbering under 1958 Agreement procedures.

Proposal to delete exhaust and fuel consumption provisions since these attributes are regulated by contracting parties and national authorities.

Revised question no. 13 pursuant to the subgroup discussions.

Updated report from Japan’s MLIT consideration of the IWVTA procedures, identifying concern over the definition and verification of information contained in type approvals. Attachment 1 to this report lists the various items from type-approval certificates that MLIT found difficult to verify independently.

Updated MLIT report raising concerns over the way approval numbers reflect the supplements covered. The draft Revision 3 of the 1958 Agreement requires that each approval number include the applicable supplement number; however, the application for a change of the supplement number does not constitute application for an extension of the approval. As a result, the approval number will not be changed even if a different supplement comes into force, resulting in a product having a supplement number that is different from the actual number of the supplement in force.

Illustration of the UN Regulation approvals information sheet as proposed in the related document SGR0-19-13, superseding the previous attachment SGR0-19-13/att.1.

Updated text prepared for review during the 22nd SGR0 IWVTA subgroup meeting.