Text prepared by the International Automotive Lighting and Light Signalling Expert Group (GTB) to clarify the definitions and requirements associated with the installation of “single lamps”, “lamps marked D” and “Interdependent lamps”.

Text prepared by Poland to introduce an alternative set of performance-based requirements for the initial aiming of dipped-beam headlamps and allowing removing the artificial 2,000 lm borderline and Light Emitting Diode (LED) automatic levelling.

Proposal to ensure that the introduction of the new class F marking materials does not conflict with the mandatory requirements for existing class C materials. Class F markings are designed with alternate stripe pattern to be applied to special utility vehicles or trailers not regularly covered by standard contour marking materials requires amending the definitions.

Correction to paragraph 6.2.7.6.1. where the reference should read Annex 13 instead of Annex 12.

Discussion document on tell-tale requirements in Regulation No. 48 versus Regulation No. 121 and consideration of establishing a task force to further discuss the issues involved. Pursuant to discussions at the previous two GRE sessions concerning the use of the term “failure tell-tale” in relation to daytime running lamps and adaptive front lighting systems (AFS) in UN R48 and the potential impact on UN R121 concerning the “location and identification of hand controls, tell-tales and indicators”, the Netherlands proposes the formation of a special task force to study the issues and propose draft amendments for lighting regulations as warranted.

Status report on efforts to resolve concerns related to automatic headlamp leveling provisions and their impact on visibility and on-coming driver glare.

Proposal to extend the modifications that introduced provisions for interdependent direction indicator lamps in the 06 series of amendments to UN R48 to the 04 and 05 series in order to avoid an unjustified design restriction for approvals under the earlier versions of the regulation.

Proposal to introduce flashing side marker lamps for vehicles of categories N₂, N₃, O₃ and O₄. The objective of this provision is to improve the safety of vulnerable road users by better informing them about the intention of a heavy goods vehicle to make a turn. Germany believes this to be a simple measure that will improve the safety level especially for cyclists and pedestrians located in the blind spot area of a heavy goods vehicle.

Document GRE/2014/13 proposes to ensure that the introduction of the new class F marking materials does not conflict with the mandatory requirements for existing class C materials. The addition of Class F brings markings required under certain countries’ national legislation within the UN regulatory system. However, Japan actually prohibits the use of white retro-reflective markings on the rear of vehicles. Therefore, Japan proposes the addition of a footnote confirming the right of Contracting Parties to prohibit the use of Class F markings under national legislation.

Presently, UN R48 requires that reverse lights be switched off when cornering lights are switched off. OICA argues that the simultaneous lightning of both cornering lamps for slow maneuvers in forward motion (e.g., while parking a vehicle) can increase safety by improved illumination of surroundings. Therefore, OICA proposes that cornering lights be allowed to remain on as long as the vehicle speed does not exceed 10 km/h.

Brief presentation raising question over the necessity to have triangular reflectors on the rear of large trailers and seeking greater flexibility in such rear reflectors.