Proposal to update the references to the three-dimensional H-point (3-D “H”-point) measurement and calibration procedure per the update and transfer of the device specifications from the Consolidated Resolution on the Construction of Vehicles (R.E.3) to Mutual Resolution No. 1 (M.R.1).

Proposal to update the references to the three-dimensional H-point (3-D “H”-point) measurement and calibration procedure pursuant to updates and transfer of related provisions from the Consolidated Resolution on the Construction of Vehicles (R.E.3) to Mutual Resolution No. 1 (M.R.1).

Proposal by TF-AVRS to amend to enable the application of this Regulation to vehicles of categories X and Y

Proposal from the GRSG task force on Automated Vehicles Regulation Screening to exempt ADS vehicles of subcategories X and Y from requirements related to the presence of a human driver and manual driving controls. The proposal permits X and Y vehicles to use alternative materials for windscreens given their 6 kph speed restriction. The proposal further permits translucence levels below 70% for ADS vehicles while an ADS feature is active (i.e., performing the DDT).

Proposal by prepared by the Task Force on Automated Vehicles
Regulatory Screening (TF-AVRS), with the aim to amend and supersede document
ECE/TRANS/GRSG/2025/19

Proposal to exempt ADS vehicles of subcategories X and Y from requirements related to the presence of a human driver and manual driving controls. The proposal permits X and Y vehicles to use alternative materials for windscreens given their 6 kph speed restriction. The proposal further permits translucence levels below 70% for ADS vehicles while an ADS feature is active (i.e., performing the DDT).

Proposal to amend and supersede document ECE/TRANS/GRSG/2026/2 to UN R43. Supplement 13 to the 01 series of amendments introduces provisions for vehicles of category X and Y, and vehicles with manual mode operating above 6 km/h equipped with Automated Driving System Feature of Type 2. The amendment extends application to vehicles without driver and manual driving controls. Different manual modes are considered: remote-control operation, seated driver operation for category X, and onboard operation other than seated for category X. Requirements for windscreens, safety glazing, light transmittance, and installation provisions are modified accordingly for these vehicle categories.