Correction to the proposal for Supplement 17 to Regulation No. 50 (to introduce the possibility of interdependent lamps for dedicated motorcycle lamps). Annex 1, Paragraph 4., should read: “However, in the case where a device is intended to be installed with its H plane at a mounting height less than 750 mm above the ground, the angle of 15 10° below the horizontal may be reduced to 5°”

Document to correct the original proposal to introduce the possibility of interdependent lamps for dedicated motorcycle lamps by including an omitted diagram and highlighting the marking clause.

Updated document to correct the original proposal to introduce the possibility of interdependent lamps for dedicated motorcycle lamps by including an omitted diagram and highlighting the marking clause.

In document GRE/2014/7, IMMA proposed to introduce the possibility of interdependent lamps for dedicated motorcycle lamps as Supplement 17 to Regulation No. 50. The concern was that the rear trunk lid commonly used for four-wheeled vehicles may be adapted for future scooter type motorcycles to secure the storage space for helmet, etc. Current lamp requirements impose design constraints that may hamper the proper development of such storage features. In this document, India proposes to clarify that the installation height of the device must be less than or equal to 750 mm.

Proposal to reference the compliance requirements for installation contained in Regulations Nos. 48, 53, 72 and 86 into the Regulations 3, 4, 6, 7, 19, 23, 38, 50, 77, 87, 91, 98, 104, 112, 113, 119 and 123. This proposal is a revised version of document GRE/2013/55 discussed during the October 2013 GRE session.

Text prepared by the International Automotive Lighting and Light Signalling Expert Group (GTB) to clarify the definition of “type”, with regard to manufacturer, trade names and marks and to introduce editorial improvements to the requirements for markings.

Although documents GRE/2013/45 and GRE-70-02 were adopted by GRE at its last (70th) session, this proposal consolidates the amendments and offers editorial improvements to the provisions concerning markings in Regulations Nos. 19, 23, 38, 65 and 119. These editorial improvements aim to clarify that the devices, and not only the samples, shall bear the trade name or mark and align the requirements with the other correctly worded regulations to avoid misunderstanding.

Text prepared by the International Motorcycle Manufacturers Association (IMMA) to introduce the possibility of interdependent lamps for dedicated motorcycle lamps. The proposal reflects recent amendments of Regulations Nos. 6 and 7 and meets the visibility angle requirements of Regulations Nos. 50 and 53. The concern is that the rear trunk lid commonly used for four-wheeled vehicles may be adapted for future scooter type motorcycles to secure the storage space for helmet, etc. Current lamp requirements impose design constraints that may hamper the proper development of such storage features.