Editorial improvements to the consolidated version (97 pages) of the amendments to UN R10 proposed in documents WP.29/2013/73 (formal proposal of amendments pending before the November 2013 Forum session) and GRE-70-14.

Proposal to improve the clarifications proposed regarding the requirements to avoid intentional non-approved (voltage) variation of the principal passing beam, using halogen light sources and to harmonize them with the operating voltage requirements in UN Regulation No. 48

Following discussions with OICA, GTB proposes improvements to the definitions and requirements associated with the installation of “single lamps”, “lamps marked D” and “interdependent lamps”.

OICA comments on the Dutch proposal to revise definitions and specifications concerning “operating” and “failure” tell-tales under UN R48.

As part of the work on establishing an International Whole Vehicle Type Approval (IWVTA) system, Japan has noted differences between European and Japanese vehicle registration (license) plates. Since UN R4 would be part of the IWVTA process, Japan seeks to add its plate requirements to the European requirements embodied in UN R4 in order to enable Japan to adopt this regulation and thereby adhere to the IWVTA.

UK proposal to address concerns raised in the series of proposals to insert provisions for the use of incandescent light sources in the case of light source modules and lamps with non-replaceable light sources.

OICA proposal to amend Poland’s proposal to introduce an alternative set of performance-based requirements for the initial aiming of dipped-beam headlamps and allowing removing the artificial 2,000 lm borderline and Light Emitting Diode (LED) automatic leveling.

Presentation in support of document GRE/2013/57 proposing to introduce an alternative set of performance-based requirements for the initial aiming of dipped-beam headlamps and allowing removing the artificial 2,000 lm borderline and Light Emitting Diode (LED) automatic leveling.

Proposal to expand the tolerances proposed for the initial aiming of dipped-beam headlamps in order to encompass all vehicle configurations and conform to the practical constraints of vehicle mass production.

Proposal to improve the draft text prepared in order to introduce provisions for direction indicator lamps with variable apparent surfaces.

Status report on the GTB working group establish with SAE to assist NHTSA in the development of test protocols for adaptive driving beam (ADB) headlamps under FMVSS 108.

Revised consolidated version (98 pages) of the amendments to UN R10 presented in documents WP.29/2013/73 (formal proposal of amendments pending before the November 2013 Forum session) and GRE-70-14 (revised proposal of further amendments superseding GRE/2013/41).

This document is intended to supersede the formal proposal WP.29/2013/73.

Status of the lighting regulations listed for inclusion within the International Whole Vehicle Type Approval systems.

Presentation highlighting concern over permissible indicator patterns under the proposed provisions for direction indicator lamps with variable apparent surfaces.

Revised presentation in support of document GRE/2013/57 proposing to introduce an alternative set of performance-based requirements for the initial aiming of dipped-beam headlamps and allowing removing the artificial 2,000 lm borderline and Light Emitting Diode (LED) automatic leveling.